Kusatsu-Shirane volcano, Japan, is known for its active phreatic eruptions. We have investigated its hydrothermal system by conducting audio-magnetotelluric soundings at 22 stations along a profile that extends across the volcano. The final two-dimensional model is characterized by two conductors. One is a 300-to 1000-m-thick conductor of 1-10 m, which is located on the eastern slope and covered with 200-m-thick resistive layers of Kusatsu-Shirane lava and pyroclastics. This conductor indicates the presence of a Montmorillonite-rich layer of Pliocene volcanic rocks that may function both as an impermeable floor for the shallow fluid path from the peak to the hot springs to the east and as an impermeable cap for the deeper fluid path from the summit region to the foot of the volcano. The second conductor is found at a depth of 1-2 km from the surface, at the peak of the volcano, and its resistivity is as low as 1 m or less. This low resistivity can be explained by fluids containing high concentrations of chloride and sulfate which were supplied from the magmatic gases. Micro-earthquakes cluster above this conductor, and the cut-off of the earthquakes corresponds to the top of the conductor. This conductor infers the presence of the fluid reservoir, and the upward release of these fluids from the reservoir through the conduit presumably triggers the micro-earthquakes at the peak area of the volcano. Crustal deformation modeling using GPS and leveling data of the past 10 years revealed that the center of the deflation coincides with the top of the second conductor, indicating that the fluid reservoir itself can be hosting the deformation.

We estimate the mass and energy budgets for the 2018 phreatic eruption of Mt. Motoshirane on Kusatsu–Shirane volcano, Japan, based on data obtained from a network of eight tiltmeters and weather radar echoes. The tilt records can be explained by a subvertical crack model. Small craters that were formed by previous eruptions are aligned WNW–ESE, which is consistent with the strike of the crack modeled in this study. The direction of maximum compressive stress in this region is horizontal and oriented WNW–ESE, allowing fluid to intrude from depth through a crack with this orientation. Based on the crack model, hypocenter distribution, and MT resistivity structure, we infer that fluid from a hydrothermal reservoir at a depth of 2 km below Kusatsu–Shirane volcano has repeatedly ascended through a pre-existing subvertical crack. The inflation and deflation volumes during the 2018 eruption are estimated to have been 5.1 × 105 and 3.6 × 105 m3, respectively, meaning that 1.5 × 105 m3 of expanded volume formed underground. The total heat associated with the expanded volume is estimated to have been ≥ 1014 J, similar to or exceeding the annual heat released from Yugama Crater Lake of Mt. Shirane and that from the largest eruption during the past 130 year. Although the ejecta mass of the 2018 phreatic eruption was small, the eruption at Mt. Motoshirane was not negligible in terms of the energy budget of Kusatsu–Shirane volcano. A water mass of 0.1–2.0 × 107 kg was discharged as a volcanic cloud, based on weather radar echoes, which is smaller than the mass associated with the deflation. We suggest that underground water acted as a buffer against the sudden intrusion of hydrothermal fluids, absorbing some of the fluid that ascended through the crack.

No abstract

We modeled pressure sources under Mount Ontake volcano, Japan, on the basis of global navigation satellite system (GNSS) observations of ground deformation during the time period including the 2007 and 2014 phreatic eruptions. The total change in volume in two sources below sea level in the period including the 2007 eruption was estimated from GNSS network observations to be 6 × 10 6 m 3