The purpose of this study was to evaluate the short-term µTBS (Micro-tensile bond strength) and microscopic (SEM and TEM) observation of four recent adhesives. One adhesive was an experimental step-less 1-step system (LLB-2, Tokuyama Dental), which is an all-in-one system without the light-curing step in the application process. The other two were self-adhering light-cured flowable composite resin systems FLD (Fusio Liquid Dentin, Pentron Clinical Technologies) and VF (Vertise Flow Dental Restorative Materials, Kerr Corporation), which combine all the bonding steps together. A 2-step self-etching system MG (Clearfil MegaBond, Kuarary Medical) was employed as the control group in this study. The µTBS of MG was the highest (79.0 MPa) followed by that of LLB-2 (63.1 MPa), FLD (23.6 MPa), and VF (13.1 MPa). The microscopic observations showed that MG and LLB-2 had an approximately 20 µm and 5 µm adhesive layer respectively, without bubble or gap-formation at the resin-dentin interface, which were found in FLD and VF.

The purpose of this study was to evaluate the effect of remaining dentin thickness (RDT) on the bond strength of current adhesive systems. Third molars were randomly allocated among four groups depending on the adhesive system used: Clearfil SE Bond ONE (SE1), G-Bond PLUS (GB), BeautiBond (BB), and Clearfil Mega Bond (MB). Bonded specimens were stored in water at 37°C for 24 h. Teeth were then sectioned perpendicular to the adhesive interface to produce beams. After measuring RDT of each beam, microtensile bond strength test was carried out using a universal testing machine at a crosshead speed of 1 mm/min. All data were analyzed by linear regression analysis. Bond strengths of one-step self-etch materials used in this study increased with an increase in RDT. In contrast, that of two-step self-etch adhesive system was not affected by RDT.

The purpose of this study was to investigate the effect of remaining dentin thickness (RDT) and long term water storage on dentin bond strength in-vitro. Twenty-seven third molars were randomly divided into 3 groups: Clearfil Bond SE ONE (SE1, Kuraray Noritake Dental, Okayama, Japan), G-Bond plus (GB, GC, Tokyo, Japan) and Clearfil Mega Bond (MB, Kuraray Noritake Dental). Bonded specimens were stored in water at 37ºC for 24 h. The teeth were then sectioned perpendicular to the adhesive interface to produce beams. RDT of each beam was measured digital calliper. Microtensile bond strength testing was carried out at a crosshead speed of 1 mm/min after 24 h and 1 year water storage. Thicker RDT produced higher bond strengths with one/two-step self-etch materials tested except for the group of 24 h MB. Nevertheless water storage time and RDT affected µTBS in all materials used.

No abstract

No abstract

No abstract