The evolution of elastic properties and structure upon the change of CaO/P(2)O(5) ratio in SiO(2)-CaO-Na(2)O-P(2)O(5) glasses (45S5-derived and 55S4-derived) at ambient conditions has been studied by using both Brillouin and Raman spectroscopy coupled with X-ray diffraction. Under the same SiO(2)/Na(2)O ratio, it is found that a decrease in CaO/P(2)O(5) molar ratio has caused a more-polymerized silicate network via a net consumption of Q(0), Q(1), and Q(2) species yet enriching in Q(3) and Q(4) species. Brillouin experiments revealed that all the bulk, shear and Young's moduli of the glasses studied increases with the increase of CaO/P(2)O(5) molar ratio. The unexpected variation trend in shear modulus can be correlated to the contribution from cohesion, the less-polymerized phosphate Q species, and density. Compared to the 45S5-derived, the more-polymerized 55S4-deived glass has a lower bulk but slightly higher shear modulus at the given CaO/P(2)O(5) ratio.

No abstract

The elastic properties and structure of four potential bioactive compounds in the CaSiO3-Na2SiO3 system were characterized by Raman and Brillouin spectroscopy at ambient conditions. The increase of Na2O content in the Na2O-CaO-SiO2 glass with the same silica content and hence polymerization was found to lower the elastic moduli with accompanied decrease of Q(0) and Q(2) species, increase of Q(1) species and negligible change of Q(3) species, corresponding to a lower and higher equilibrium constant for the disproportional reactions [Formula: see text] and [Formula: see text] (without balance), respectively. The composition-dependent variation in the shear modulus (G) of the Na2O-CaO-SiO2 glass can be attributed to the concentration change of Q(2) and probably Q(4) species; while bulk modulus (K) ascribed to the cohesion factor. The elastic moduli of the corresponding crystalline phases in this system also lower with the increase of Na2O content following two general criteria as a function of Na2O/CaO molar ratio: (1) K decreases faster than G for both the amorphous and crystalline phases and (2) both K and G decreases faster for the crystals than the glasses.

In this work, three layers of transparent conductive films of WO3/Ag/WO3 (WAW) were deposited on a glass substrate by radio frequency (RF) magnetron sputtering. The thicknesses of WO3 (around 50~60 nm) and Ag (10~20 nm) films were mainly the changeable factors to achieve the optimal transparent conductivity attempting to replace the indium tin oxide (ITO) in cost consideration. The prepared films were cardinally subjected to physical and electrical characteristic analyses by means of X-ray diffraction analysis (XRD), field-emission scanning electron microscope (FE-SEM), and Keithley 4200 semiconductor parameter analyzer. The experimental results show as the thickness of the Ag layer increases from 10 nm to 20 nm, the resistance becomes smaller. While the thickness of the WO3 layer increases from 50 nm to 60 nm, its electrical resistance becomes larger.

No abstract

No abstract

No abstract

No abstract