Living building materials (LBMs) were engineered using photosynthetic cyanobacteria and an inert sand-gelatin scaffold. Microorganisms biomineralized LBMs with calcium carbonate, which imparted higher fracture toughness compared with no-cell controls. The microorganisms maintained relatively high viability in LBMs as long as sufficient humidity conditions were provided. The microorganisms were capable of on-demand exponential regeneration in response to temperature and humidity switches. Looking forward, LBMs represent a new class of structural materials that can be engineered to exhibit multiple biological functionalities.
Micropollutants in wastewater present environmental and human health challenges. Powdered activated carbon (PAC) can effectively remove organic micropollutants, but PAC production is energy intensive and expensive. Biochar adsorbents can cost less and sequester carbon; however, net benefits depend on biochar production conditions and treatment capabilities. Here, life cycle assessment was used to compare 10 environmental impacts from the production and use of wood biochar, biosolids biochar, and coal-derived PAC to remove sulfamethoxazole from wastewater. Moderate capacity wood biochar had environmental benefits in four categories (smog, global warming, respiratory effects, noncarcinogenics) linked to energy recovery and carbon sequestration, and environmental impacts worse than PAC in two categories (eutrophication, carcinogenics). Low capacity wood biochar had even larger benefits for global warming, respiratory effects, and noncarcinogenics, but exhibited worse impacts than PAC in five categories due to larger biochar dose requirements to reach the treatment objective. Biosolids biochar had the worst relative environmental performance due to energy use for biosolids drying and the need for supplemental adsorbent. Overall, moderate capacity wood biochar is an environmentally superior alternative to coal-based PAC for micropollutant removal from wastewater, and its use can offset a wastewater facility's carbon footprint.
Modeling efforts to understand the financial implications of microalgal biofuels often assume a static basis for microalgae biomass composition and cost, which has constrained cultivation and downstream conversion process design and limited in-depth understanding of their interdependencies. For this work, a dynamic biological cultivation model was integrated with thermo-chemical/biological unit process models for downstream biorefineries to increase modeling fidelity, to provide mechanistic links among unit operations, and to quantify minimum product selling prices of biofuels via techno-economic analysis. Variability in design, cultivation, and conversion parameters were characterized through Monte Carlo simulation, and sensitivity analyses were conducted to identify key cost and fuel yield drivers. Cultivating biomass to achieve the minimum biomass selling price or to achieve maximum lipid content were shown to lead to suboptimal fuel production costs. Depending on biomass composition, both hydrothermal liquefaction and a biochemical fractionation process (combined algal processing) were shown to have advantageous minimum product selling prices, which supports continued investment in multiple conversion pathways. Ultimately, this work demonstrates a clear need to leverage integrated modeling platforms to advance microalgae biofuel systems as a whole, and specific recommendations are made for the prioritization of research and development pathways to achieve economical biofuel production from microalgae.
We demonstrate for the first time that the morphology and nanomechanical properties of calcium carbonate (CaCO3) can be tailored by modulating the precipitation kinetics of ureolytic microorganisms through genetic engineering. Many engineering applications employ microorganisms to produce CaCO3. However, control over bacterial calcite morphology and material properties has not been demonstrated. We hypothesized that microorganisms genetically engineered for low urease activity would achieve larger calcite crystals with higher moduli. We compared precipitation kinetics, morphology, and nanomechanical properties for biogenic CaCO3 produced by two Escherichia coli (E. coli) strains that were engineered to display either high or low urease activity and the native producer Sporosarcina pasteurii. While all three microorganisms produced calcite, lower urease activity was associated with both slower initial calcium depletion rate and increased average calcite crystal size. Both calcite crystal size and nanoindentation moduli were also significantly higher for the low-urease activity E. coli compared with the high-urease activity E. coli. The relative resistance to inelastic deformation, measured via the ratio of nanoindentation hardness to modulus, was similar across microorganisms. These findings may enable design of novel advanced engineering materials where modulus is tailored to the application while resistance to irreversible deformation is not compromised.
Sanitation remains a global challenge, both in terms of access to toilet facilities and resource intensity (e.g., energy consumption) of waste treatment. Overcoming barriers to universal sanitation coverage and sustainable resource management requires approaches that manage bodily excreta within coupled human and natural systems. In recent years, numerous analytical methods have been developed to understand cross-disciplinary constraints, opportunities, and trade-offs around sanitation and resource recovery. However, without a shared language or conceptual framework, efforts from individual disciplines or geographic contexts may remain isolated, preventing the accumulation of generalized knowledge. Here, we develop a version of the social-ecological systems framework modified for the specific characteristics of bodily excreta. This framework offers a shared vision for sanitation as a human-derived resource system, where people are part of the resource cycle. Through sanitation technologies and management strategies, resources including water, organics, and nutrients accumulate, transform, and impact human experiences and natural environments. Within the framework, we establish a multitiered lexicon of variables, characterized by breadth and depth, to support harmonized understanding and development of models and analytical approaches. This framework’s refinement and use will guide interdisciplinary study around sanitation to identify guiding principles for sanitation that advance sustainable development at the nature-society interface.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.