Photoconductivity measurements of CH3NH3PbI3 deposited between two dielectric-protected Au electrodes show extremely slow response. The CH3NH3PbI3, bridging a gap of ∼2000 nm, was subjected to a DC bias and cycles of 5 min illumination and varying dark duration. The approach to steady -state photocurrent lasted tens of seconds with a strong dependence on the dark duration preceding the illumination. On the basis of DFT calculations, we propose that under light + bias the methylammonium ions are freed to rotate and align along the electric field, thus modifying the structure of the inorganic scaffold. While ions alignment is expected to be fast, the adjustment of the inorganic scaffold seems to last seconds as reflected in the extremely slow photoconductivity response. We propose that under working conditions a modified, photostable, perovskite structure is formed, depending on the bias and illumination parameters. Our findings seem to clarify the origin of the well-known hysteresis in perovskite solar cells.

In the pursuit to better understand the mechanisms of perovskite solar cells we performed Raman and photoluminescence measurements of free-standing CH3NH3PbI3 films, comparing dark with working conditions. The films, grown on a glass substrate and sealed by a thin glass coverslip, were measured subsequent to dark and white-light pretreatments. The extremely slow changes we observe in both the Raman and photoluminescence cannot be regarded as electronic processes, which are much faster. Thus, the most probable explanation is of slow photoinduced structural changes. The CH3NH3PbI3 transformation between the dark and the light structures is reversible, with faster rates for the changes under illumination. The results seem to clarify several common observations associated with solar cell mechanisms, like performance improvement under light soaking. More important is the call for solar-cell-related investigation of CH3NH3PbI3 to take the photoinduced structural changes into consideration when measuring and interpreting the results.

Bisquert and colleagues demonstrate the impact of positive charge accumulation at the electron contact of perovskite solar cells.

ARTICLE systems for comparison. A CdSe QD-sensitized photoelectrode was used in conjunction with an aqueous polysulfide electrolyte and the PbS-CE to record IÀV measurements under illumination and to compare the solar cell performance to a cell with a Pt-CE. Our results show that the PbS-CE reported here provides better performance while bypassing contamination problems known from alternative materials.

Hydrothermal synthesis of TiO 2 colloids is based on hydrolysis and pressure treatment of titanium isopropoxide precursor in acidic solutions. The influence of the use of nitric and acetic acids during the synthesis was studied, showing a significant effect on the colloid crystal structure. Both dark-field TEM and phase transformation temperature measurements indicate that the colloids prepared in acetic acid contain more of the {101} face compared with the colloids prepared in nitric acid. The surface structure difference affects the performance of dye-sensitized solar cells that consist of electrodes made from these colloids. Better performance is achieved using the colloids prepared in nitric acid, indicating the importance of controlled colloid fabrication for higher conversion efficiencies.