ÖzGelişen malzeme ve üretim teknolojileri ile birlikte silahlar küçülmeye başlamış ve bu problem büyük oranda çözülmüştür. Ancak silahlardan temel olarak elde edilmek istenen yüksek yıkım etkisidir. Bu durum günümüzde halen en önemli problemlerden birisi olan geri tepme kuvvetini de beraberinde getirmekte ve incelenmesi gereken bir konu olarak güncelliğini sürdürmektedir. Bir ateşli silahta geri tepme kuvveti barutun yanmasına bağlı olarak ortaya çıkan gazın basıncından kaynaklanır. Bu anlamda ateşli silah namlusunda hareket eden bir merminin etrafındaki akış alanının tahmin edilmesi gerekir ki bu oldukça karmaşık bir iştir. Karmaşıklıklar, türbülans, karmaşık yüzey geometrisi, hesaplama alanındaki zaman değişikliği, sıkıştırılabilirlik ve gaz denklemleri gibi çok sayıda faktörün varlığından kaynaklanmaktadır. Bu çalışma kapsamında yanma sonucu olan gazların davranışının modellenmesinde kullanılan Noble-Abel ve ideal gaz denklemlerinin, merminin akış alanı üzerindeki etkisi nümerik olarak incelenmiştir. Nümerik modellemede Fluent paket programı kullanılmıştır. Hesaplamalar iki boyutlu, kararsız, sıkıştırılabilir, eksenel simetrik şartlarda gerçekleştirilmiştir. Hesaplamalar sonucunda mermi etrafında oluşan basınç dağılımı, namlu ekseninden farklı konum boyunca çizilmiş ve bu konumlarda farklı zaman değerleri için basınç değerleri gösterilmiştir.
In this study, effect of heat sink geometries on the performance of a thermoelectric generator was researched. In this context, fins with different geometries (flat fin, square pin fin, hexagonal pin fin, circle pin fin) placed to aluminium heat sink and their effects on heat transfer and electricity generation were investigated numerically. Calculations were carried out according to three different hot surface temperatures and five different air velocities. As a result of this study, it was determined that the electrical output increased with the increase of air velocity and hot surface temperature in all geometries. The highest electrical outputs were obtained at 150 °C hot surface temperatures and 15000 Reynolds numbers, while the lowest electrical outputs were obtained at 50 °C hot surface temperatures and 5000 Reynolds numbers in all geometries. The best thermal and electrical performance was obtained with flat fin heat sink and the worst in the TEG system without heat sink. The highest power outputs of the flat fin heat sink and without heat sink TEG systems were 6.42 W and 1.12 W, respectively. In addition, the highest conversion efficiencies of the flat fin heat sink and without heat sink TEG systems were 14.94% and 5.54%, respectively.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.