We study spin-wave transport in a microstructured Ni81Fe19 waveguide exhibiting broken translational symmetry. We observe the conversion of a beam profile composed of symmetric spin-wave width modes with odd numbers of antinodes n=1,3,... into a mixed set of symmetric and asymmetric modes. Due to the spatial homogeneity of the exciting field along the used microstrip antenna, quantized spin-wave modes with an even number n of antinodes across the stripe's width cannot be directly excited. We show that a break in translational symmetry may result in a partial conversion of even spin-wave waveguide mode

Experiments and simulations are reported, which demonstrate the influence of partial decoherence of spin-wave modes on the dynamics in small magnetic structures. Microfocus Brillouin light scattering spectroscopy was performed on 15 nm thick Ni81Fe19 rings with diameters from 1 to 3 microm. For the so-called "onion" magnetization state several effects were identified. First, in the pole regions of the rings spin-wave wells are created due to the inhomogeneous internal field leading to spin-wave confinement. Second, in the regions in between, modes are observed which show a well pronounced quantization in radial direction but a transition from partial to full coherency in azimuthal direction as a function of decreasing ring size. In particular for larger rings a continuous frequency variation with position is observed which is well reproduced by spin-wave calculations and micromagnetic simulations.

Chemical solution deposition (CSD) of YBa2Cu3O7−δ (YBCO) nanocomposites from colloidal precursor solutions containing double metal oxide preformed nanocrystals is a promising, costeffective and reproducible approach to produce superconducting films with high critical current density (Jc) and enhanced pinning. Here, the influence of the preformed nanocrystal composition on the microstructure and superconducting properties of the YBCO nanocomposite films is studied, with a focus on establishing a simple and scalable process to grow nanocomposites that can be transferred to grow nano-added coated conductors. Colloidal stable BaZrO3, BaHfO3, BaTiO3 and SrZrO3 nanocrystals (3-6 nm in diameter) were synthesized and added to an environment-friendly low-fluorine YBCO precursor solution. High-quality superconducting layers were grown on LaAlO3 single-crystal substrates from these four nanocomposite precursor solutions in a single deposition process, without the need of a seed layer, yielding Jc of 4-5 MA/cm² at 77 K in self-field. The different YBCO microstructures produced by the four types of nanocrystals and the resulting microstrain of the films are compared and related with the magnetic-field and angular dependence of Jc. We demonstrate the BaHfO3-containing nanocomposite as the best-performing with a homogeneous distribution of nanoparticles with 7 nm in average diameter and a high density of stacking faults, which leads to some of the best superconducting properties ever achieved via low-fluorine CSD. The Jc exhibits a much smoother decay in applied magnetic fields and a much more isotropic behaviour for non-parallel magnetic fields, and the pinning force is increased by a factor of 3.5 at 77 K and 1 T with respect to the pristine film.

B2-ordered Co2FeAl films were synthesized using an ion beam deposition tool. A high degree of chemical ordering ∼81.2% with a low damping parameter (α) less than 0.004 was obtained in a 50 nm thick film via rapid thermal annealing at 600 °C. The perpendicular magnetic anisotropy (PMA) was optimized in ultra thin Co2FeAl films annealed at 350 °C without an external magnetic field. The reduced thickness and annealing temperature to achieve PMA introduced extrinsic factors thus increasing α significantly. However, the observed damping of Co2FeAl films was still lower than that of Co60Fe20B20 films prepared at the same thickness and annealing temperature.