International audienceBiobased diepoxy synthons derived from isoeugenol, eugenol or resorcinol (DGE-isoEu, DGE-Eu and DGER, respectively) have been used as epoxy monomers in replacement of the diglycidyl ether of bisphenol A (DGEBA). Their curing with six different biobased anhydride hardeners leads to fully biobased epoxy thermosets. These materials exhibit interesting thermal and mechanical properties comparable to those obtained with conventional petrosourced DGEBA-based epoxy resins cured in similar conditions. In particular, a high Tg in the range of 90–130 °C and instantaneous moduli higher than 4.3 GPa have been recorded. These good performances are very encouraging, making these new fully biobased epoxy thermosets compatible with the usual structural application of epoxy materials

Herein, a catalytic reductive fractionation of lignocellulose is presented using a heterogeneous cobalt catalyst and formic acid or formate as a hydrogen donor. The catalytic reductive fractionation of untreated birch wood yields monophenolic compounds in up to 34 wt % yield of total lignin, which corresponds to 76 % of the theoretical maximum yield. Model compound studies revealed that the main role of the cobalt catalyst is to stabilize the reactive intermediates formed during the organosolv pulping by transfer hydrogenation and hydrogenolysis reactions. Additionally, the cobalt catalyst is responsible for depolymerization reactions of lignin fragments through transfer hydrogenolysis reactions, which target the β‐O‐4′ bond. The catalyst could be recycled three times with only negligible decrease in efficiency, showing the robustness of the system.

2,5-Furandicarboxylic acid (FDCA) has received attention as an emerging bio-based building block with many applications, especially in renewable polyesters. The common route to FDCA uses the unstable 5-hydroxymethylfurfural (HMF) as...

No abstract

No abstract