A low band gap quinolizino acridine based molecule was designed and synthesized as new hole transporting material for organic-inorganic hybrid lead halide perovskite solar cells. The functionalized quinolizino acridine compound showed an effective hole mobility in the same range of the state-of-the-art spiro-MeOTAD and an appropriate oxidation potential of 5.23 eV vs the vacuum level. The device based on this new hole transporting material achieved high power conversion efficiency of 12.8% under the illumination of 98.8 mW cm(-2), which was better than the well-known spiro-MeOTAD under the same conditions. Moreover, this molecule could work alone without any additives, thus making it to be a promising candidate for solid-state photovoltaic application.

Dopant-free HTM KR321 showed highly ordered characteristic face-on organization leading to increased vertical charge transport and PCE over 19% in PSC with improved stability.

The photoresponse of quantum dot solar cells (QDSCs) has been successfully extended to the near-IR (NIR) region by sensitizing nanostructured TiO(2)-CdS films with a squaraine dye (JK-216). CdS nanoparticles anchored on mesoscopic TiO(2) films obtained by successive ionic layer adsorption and reaction (SILAR) exhibit limited absorption below 500 nm with a net power conversion efficiency of ~1% when employed as a photoanode in QDSC. By depositing a thin barrier layer of Al(2)O(3), the TiO(2)-CdS films were further modified with a NIR absorbing squaraine dye. Quantum dot sensitized solar cells supersensitized with a squariand dye (JK-216) showed good stability during illumination with standard global AM 1.5 solar conditions, delivering a maximum overall power conversion efficiency (η) of 3.14%. Transient absorption and pulse radiolysis measurements provide further insight into the excited state interactions of squaraine dye with SiO(2), TiO(2), and TiO(2)/CdS/Al(2)O(3) films and interfacial electron transfer processes. The synergy of combining semiconductor quantum dots and NIR absorbing dye provides new opportunities to harvest photons from different regions of the solar spectrum.

A new series of stable, unsymmetrical squaraine near-IR sensitizers (JK-216 and JK-217), which are assembled using both thiophenyl pyrrolyl and indolium groups, exhibit a panchromatic light harvesting up to 780 nm. The JK-216 based cell exhibited a record efficiency of 6.29% for near-IR DSSCs. In addition, the JK-217 device showed an excellent stability under a light soaking test at 60 °C for 1000 h.

It could successfully control the band-bending of the perovskite semiconductor, which led to improvement of the photovoltaic performance.

A new type of hole transporting material (HTMs) with an incorporated planar amine or triphenylamine as a core unit have been prepared. The two amine derivatives were demonstrated to be efficient hole transporting materials in fabricating solid-state organic-inorganic hybrid solar cells. Perovskite-based solar cells with a planar amine derivative gave a short circuit photocurrent density (Jsc) of 20.98 m Acm(-2), an open circuit voltage (Voc) of 0.972 V, and a fill factor of 0.67, corresponding to an overall conversion efficiency of 13.63 %. The photovoltaic performance is comparable to that of the standard spiro-OMeTAD. Moreover, the device showed good stability under light soaking for 500 h. These HTMs hold promise to replace the expensive spiro-OMeTAD because of their high efficiency, excellent stability, synthesis from simple and inexpensive materials.

No abstract

A series of new branched hole transporting materials (HTMs) containing two diphenylamine‐substituted carbazole fragments linked by a nonconjugated methylenebenzene unit is synthesized and tested in perovskite solar cells. Synthesis of the investigated materials is performed by a simple two‐step synthetic procedure providing a target product in high yield. The isolated materials demonstrate good thermal stability and majority of the investigated compounds exist in an amorphous state, which is advantageous as there is no risk of crystallization directly in the film. The highest charge drift mobility of µ0 = 4 × 10−4 cm2 V−1 s−1, measured at weak electric fields, is by ca. one order of magnitude higher than that of Spiro‐OMeTAD under identical conditions. From the perovskite solar cell testing results, it can be seen that performance of two new HTMs (V885 and V911) is on a par with Spiro‐OMeTAD. Due to the ease of synthesis, good thermal, optical and photophysical properties, this type of molecules hold great promise for practical application in commercial perovskite solar cells.