Electrochemical gating at the single molecule level of viologen molecular bridges in ionic liquids is examined. Contrary to previous data recorded in aqueous electrolytes, a clear and sharp peak in the single molecule conductance versus electrochemical potential data is obtained in ionic liquids. These data are rationalized in terms of a two-step electrochemical model for charge transport across the redox bridge. In this model the gate coupling in the ionic liquid is found to be fully effective with a modeled gate coupling parameter, ξ, of unity. This compares to a much lower gate coupling parameter of 0.2 for the equivalent aqueous gating system. This study shows that ionic liquids are far more effective media for gating the conductance of single molecules than either solid-state three-terminal platforms created using nanolithography, or aqueous media.
A new in situ electrochemical method of functionalizing an oxide-free Ni surface is demonstrated using octanethiol. Initial adsorption results in a multilayer molecular film, which blocks both the hydrogen evolution reaction (HER) and re-oxidation of the Ni by ambient oxygen. However, excess octanethiol can be removed by rinsing with ethanol, leaving behind a monolayer that continues to protect against re-oxidation but gives rise to an unexpected enhancement in the HER, with a greater enhancement for longer film formation times. The presence of an octanethiol monolayer on the surface was confirmed by spectroscopic observation of the CH(2), CH(3) and thiolate groups using infra red spectroscopy, while X-ray photo-electron spectroscopy demonstrated the effectiveness of the thiol layer as a barrier to surface oxidation. The electrochemically prepared octanethiol film impedes oxidation of the Ni in air more effectively than a film formed by immersion in a solution of octanethiol in ethanol.
Intermittent contact alternating current scanning electrochemical microscopy (ic-ac-SECM) has been used to determine the electrochemical response to an ac signal of several types of materials. A conductive gold foil and insulating Teflon sheet were first used to demonstrate that the intermittent contact function allows the topography and conductivity to be mapped simultaneously and independently in a single experiment. Then, a dense pellet of an electronically insulating but Li ion conducting garnet phase, Al-substituted Li7La3Zr2O12 (LLZO), was characterized using the same technique. The polycrystalline pellet was prepared by classical ceramic sintering techniques and was comprised of large (~150 μm) grains. Critical information regarding the contributions of grain and grain boundary resistances to the total conductivity of the garnet phase was lacking due to ambiguities in the impedance data. In contrast, the use of the ic-ac-SECM technique allowed spatially resolved information regarding local conductivities to be measured directly. Impedance mapping of the pellet showed that the grain boundary resistance, while generally higher than that of grains, varied considerably, revealing the complex nature of the LLZO sample.
An electrochemical method is presented for fabricating cobalt thin films for single-molecule electrical transport measurements. These films are electroplated in an aqueous electrolyte, but the crucial stages of electrochemical reduction to remove surface oxide and adsorption of alkane(di)thiol target molecules under electrochemical control to form self-assembled monolayers which protect the oxide-free cobalt surface are carried out in an ionic liquid. This approach yields monolayers on Co that are of comparable quality to those formed on Au by standard self-assembly protocols, as assessed by electrochemical methods and surface infrared spectroscopy. Using an adapted scanning tunneling microscopy (STM) method, we have determined the single-molecule conductance of cobalt/1,8-octanedithiol/cobalt junctions by employing a monolayer on cobalt and a cobalt STM tip in an ionic liquid environment and have compared the results with those of experiments using gold electrodes as a control. These cobalt substrates could therefore have future application in organic spintronic devices such as magnetic tunnel junctions.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.