Oxidation of the Ni-based superalloy RR1000 has been undertaken in air over the temperature range 600-900 degrees C for times up to 5000 h. The surface oxide consisted of a protective Ti-doped chromia layer but with rutile forming on its outer surface. Sub-surface oxidation of Al and Ti also occurred. The thickening kinetics of the chromia layer were sub-parabolic with initial rates around two orders of magnitude higher than expected for Ti-free chromia. This enhancement and the sub-parabolic kinetics are accounted for by Ti-doping of the chromia layer. Over time the enhancement reduced because of Ti-depletion in the alloy.

Funding Agencies|Engineering and Physical Sciences Research Council||Rolls-Royce plc||

Where a licence is displayed above, please note the terms and conditions of the licence govern your use of this document. When citing, please reference the published version. Take down policy While the University of Birmingham exercises care and attention in making items available there are rare occasions when an item has been uploaded in error or has been deemed to be commercially or otherwise sensitive.

Highlights • Two alloy surface treatments are compared. • The kinetics of a Ni-based superalloy are compared to pure chromia formation. • The enhancement is described in terms of Ti-doping of the surface chromia scale. • For the first time, a (Ta,Ti)O 2 phase, formed at the oxide metal interface, is identified.

No abstract

Where a licence is displayed above, please note the terms and conditions of the licence govern your use of this document. When citing, please reference the published version. Take down policy While the University of Birmingham exercises care and attention in making items available there are rare occasions when an item has been uploaded in error or has been deemed to be commercially or otherwise sensitive.

High temperature oxidation resistance is becoming increasingly important to component life as operating temperatures increase. Additionally, shot-peening is used to help extend the service life of high-duty components through inducing compressive stresses in the surface. The effect of shot-peening on oxidation resistance has not been examined in detail, at least on recent high-strength turbine disc alloys such as RR1000. In this study, oxidation of a coarse-grained variant of RR1000, with and without shot peening, has been characterised over a range of temperatures (700-800 o C) for periods of time extending to 2000 hours. Microstructural characterisation of the oxide and underlying material was performed using a number of techniques. A duplex surface oxide, comprised largely of Cr 2 O 3 covered by a thin top layer of TiO 2 was recorded in both surface conditions. Beneath this surface oxide was an alumina internal oxide, with the shot-peened condition exhibiting more numerous penetrations. The oxide growth kinetics in both alloy conditions were similar.

Where a licence is displayed above, please note the terms and conditions of the licence govern your use of this document. When citing, please reference the published version. Take down policy While the University of Birmingham exercises care and attention in making items available there are rare occasions when an item has been uploaded in error or has been deemed to be commercially or otherwise sensitive.

No abstract