Based on principal component analysis, it is concluded that higher pollen germination percentages and longer pollen tubes under optimum conditions and with optimum temperatures above 32 degrees C for pollen germination would indicate tolerance to high temperature.

Plant reproduction is highly vulnerable to global climate change components such as carbon dioxide concentration ([CO(2)]), temperature (T), and ultraviolet-B (UV-B) radiation. The objectives of this study were to determine the effects of season-long exposure to treatments of [CO(2)] at 360 (control) and 720 micromol mol(-1) (+CO(2)), temperature at 30/22 degrees C (control) and 38/30 degrees C (+T) and UV-B radiation 0 (control) and 10 kJ m(-2) d(-1) (+UV-B) on flower and pollen morphology, pollen production, germination, and tube lengths of six soybean genotypes (D 88-5320, D 90-9216, Stalwart III, PI 471938, DG 5630RR, and DP 4933RR) in sunlit, controlled environment chambers. The control treatment had 360 micromol mol(-1) [CO(2)] at 30/22 degrees C and 0 kJ UV-B. Plants grown either at +UV-B or +T, alone or in combination, produced smaller flowers with shorter standard petal and staminal column lengths. Flowers so produced had less pollen with poor pollen germination and shorter tube lengths. Pollen produced by the flowers of these plants appeared shrivelled without apertures and with disturbed exine ornamentation even at +CO(2) conditions. The damaging effects of +T and +UV-B were not ameliorated by +CO(2) conditions. Based on the total stress response index (TSRI), pooled individual component responses over all the treatments, the genotypes were classified as tolerant (DG 5630RR, D 88-5320: TSRI >-790), intermediate (D 90-9216, PI 471938: TSRI <-790 to >-1026), and sensitive (Stalwart III, DP 4933RR: TSRI <-1026). The differences in sensitivity identified among genotypes imply the options for selecting genotypes with tolerance to environmental stresses projected to occur in the future climates.

Soybean [Glycine max (L.) Merr.] reproduction is sensitive to temperatures > 35°C. Two studies were conducted to determine temperature effects on soybean pollen germination (PG) and to detect genotypic differences. Pollen collected from 44 genotypes (Maturity Groups III to VI) grown outdoors was subjected to in vitro temperatures from 15 to 50°C at 5°C intervals. Genotypes differed significantly for in vitro PG percentage (mean of 81%) and tube length (mean of 437 μm). Mean cardinal temperatures (Tmin, Topt, and Tmax) were 13.2, 30.2, and 47.2°C for PG and 12.1, 36.1, and 47.0°C for pollen tube growth. Genotypes differed for leaf cell membrane thermostability (CMTS), but CMTS did not correlate with pollen parameters. Cumulative temperature response index, CTRI (unitless), of each genotype calculated as the sum of eight individual stress responses (ISRs) derived from maximum PG, maximum pollen tube length (PTL), and the maximum (Tmax), minimum (Tmin), and optimum (Topt) temperatures for PG and for PTLs was used to group genotypes for temperature tolerance. Heat‐tolerant genotype (DG 5630RR) was less sensitive to high temperature (38/30°C) compared with heat‐intermediate (PI 471938) and heat‐sensitive (Stalwart III) genotypes that had deformed pollen, with reduced apertures and collumellae heads. Hence, pollen can be used as a screening tool for heat tolerance. Most sensitive to temperature was D88‐5320 with a CTRI of 6.8, while AG 4403RR was most tolerant with a CTRI of 7.5. Elevated [CO2] did not modify reproductive parameters or CTRI. The study also revealed that heat tolerance of vegetative tissue had little or no relationship with the heat tolerance of reproductive tissue. Maturity groups lacked a specific trend for tolerance to high temperature. The identified high temperature‐tolerant genotypes and temperature‐dependent pollen response functions might be useful in soybean breeding and modeling programs, respectively.

No abstract

No abstract