The present work focuses on the development of a fast and cost effective method based on Laser Induced Breakdown Spectroscopy (LIBS) to the quality control, traceability and detection of adulteration in milk. Two adulteration cases have been studied; a qualitative analysis for the discrimination between different milk blends and quantification of melamine in adulterated toddler milk powder. Principal Component Analysis (PCA) and neural networks (NN) have been used to analyze LIBS spectra obtaining a correct classification rate of 98% with a 100% of robustness. For the quantification of melamine, two methodologies have been developed; univariate analysis using CN emission band and multivariate calibration NN model obtaining correlation coefficient (R) values of 0.982 and 0.999 respectively. The results of the use of LIBS technique coupled with chemometric analysis are discussed in terms of its potential use in the food industry to perform the quality control of this dairy product.

No abstract

No abstract

The present work reports the distribution of pollutants in the Madrid city and province from 22 monitoring stations during 2010 to 2017. Statistical tools were used to interpret and model air pollution data. The data include the annual average concentrations of nitrogen oxides, ozone, and particulate matter (PM10), collected in Madrid and its suburbs, which is one of the largest metropolitan places in Europe, and its air quality has not been studied sufficiently. A mapping of the distribution of these pollutants was done, in order to reveal the relationship between them and also with the demography of the region. The multivariate analysis employing correlation analysis, principal component analysis (PCA), and cluster analysis (CA) resulted in establishing a correlation between different pollutants. The results obtained allowed classification of different monitoring stations on the basis of each of the four pollutants, revealing information about their sources and mechanisms, visualizing their spatial distribution, and monitoring their levels according to the average annual limits established in the legislation. The elaboration of contour maps by the geostatistical method, ordinary kriging, also supported the interpretation derived from the multivariate analysis demonstrating the levels of NO2 exceeding the annual limit in the centre, south, and east of the Madrid province.

This 3 × 3 factorial study assessed pyrethroids, carbamates and neonicotenoids groups of pesticides in replicated samples of three fish species from low (S1, reference), medium (S2) and heavy (S3) polluted sites receiving agricultural run-offs around the Indus River. Water and sediment samples from the same sites were also analysed for these pesticides by using high-performance liquid chromatography. Out of nine investigated pesticides, only three pesticides (deltamethrin, carbofuran and cypermethrin) were detected in fish and sediment samples. Deltamethrin in Cyprinus carpio ranged from 0.490 to 0.839 μg/g, mostly exceeding 0.5 μg/g as the maximum residual limit suggested by FAO-WHO, whereas it ranged from 0.214 to 0.318 μg/g in the sampled sediments. The carbofuran concentrations were 0.0425-0.066 and 0.613-0.946 μg/g in Labeo rohita and Channa marulius muscles respectively and 0.069-0.081 μg/g in the corresponding sediment samples. These values were either higher or lower than the maximum limit (0.1 μg/g) as suggested by FAO-WHO. Conversely, the cypermethrin concentration ranged from 0.141 to 0.174 in Ch. marulius and 0.183-0.197 μg/g in sediments which were both below the FAO-WHO maximum limit of 2 μg/g. No pesticide residues were detected in water from these sampling sites. Most selected physicochemical variables were within the acceptable range of World Health Organization for the water quality for aquatic life. The detected pesticide contents were mostly higher in fish muscles from heavily polluted sites. This is worrying because these pesticides may pose health risks for the fish and people of the study area. However, a preliminary risk assessment indicated that the calculated daily intake of detected pesticides by people consuming fish from the Indus River was low and did not present an immediate risk to the fish-consuming people. This study may be used as a benchmark to determine the safety of fish meat in order to develop intervention strategies to maintain the water quality and to protect the health of fish and fish-consuming people.

The creation of new rapid prototyping techniques, low cost 3D printers as well as the creation of new software for these techniques have allowed the creation of 3D models of bones making their application possible in the field of teaching anatomy in the faculties of Health Sciences. The 3D model of cranium created in the present work, at full scale, present accurate reliefs and anatomical details that are easily identifiable by undergraduate students in their use for the study of human anatomy. In this article, the process of scanning the skull and the subsequent treatment of these images with specific software until the generation of 3D model using 3D printer has been reported.

No abstract

No abstract