Recently, first analyses of single sub-micrometre particles, embedded in liquid droplets, by inductively coupled plasma optical emission spectrometry (ICP-OES) with a size-equivalent detection limit of several hundred nanometres were reported. 1,2 To achieve lower detection limits which might allow for the analysis of particles in the nanometre size range a more sensitive technique such as mass spectrometry (MS) is required. Various modifications of particle delivery and data acquisition systems commonly used were carried out to install a setup adequate for ICP-MS detection. These modifications enabled us to supply droplets generated by a commercial microdroplet generator (droplet size: 30-40 mm) with nearly 100% efficiency and high uniformity to the ICP. Analyses were performed using both standard solutions of dissolved metals at concentrations of 1 (Ag), 2 (Au), 5 (Au), or 10 (Cu) mg L À1 and highly diluted suspensions of gold and silver nanoparticles with sizes below 110 nm. In doing so, detection efficiencies of 10 À6 counts per atom could be achieved while size-related limits of quantification were found to be 21 nm and 33 nm for gold and silver, respectively. Furthermore, the advantages of utilizing microdroplet generators vs. conventional nebulizers for nanoparticle analyses by ICP-MS are discussed.

A prototype inductively coupled plasma time-of-flight mass spectrometer (ICPTOFMS) for time resolved measurements of transient signals in the microsecond regime is described in this work. Analytical figures of merit for the prototype are given for both liquid nebulization and single droplet introduction and are compared to a conventional quadrupole-based ICPMS using the same ICP source and vacuum interface.Quasi-simultaneous detection at a time resolution of 33 ms of the prototype ICPTOFMS allows multiisotope monitoring of short signals (200-500 ms duration) generated from individual droplets and particles. The capabilities of the instrument for the analysis of single nanoparticles are studied using microdroplets consisting of a multi-element standard solution and containing 114 nm Au particles. The detection efficiencies for Ag and Au, calculated from the response of individual droplets and particles, are similar to those of the quadrupole-based instrument and amount to 1.3 Â 10 À6 ions per atom and 3.1 Â 10 À6 ions per atom, respectively. The sizes of the smallest detectable Ag, Au and U metallic nanoparticles are estimated to be 46 nm, 32 nm and 22 nm, respectively. Furthermore, time shifts of the signals of different elements within single droplets were observed. These new results demonstrate the advantage of the temporal resolution of the instrument for studying processes taking place in the plasma on the ms-time scale.

Utilization of metallic engineered nanoparticles (ENP) is progressing rapidly; therefore, characterization of their most important properties, e.g., size/mass, elemental composition, and number concentration, is inevitable and currently uses a set of different techniques. In this work, a new setup is proposed for the quantitative size and mass determination of ENPs employing a monodisperse microdroplet generator (MDG) with transport efficiencies >95% coupled to an ICPMS. Two different MDG sample introduction configurations (vertical and horizontal) were tested, and their performance characteristics were evaluated. Due to a 5-fold reduced temporal jitter resulting in a shorter measurement time, the horizontal droplet introduction approach was used for the analysis of ENPs. With this setup, the quantification of Au, Ag, and CeO2 nanoparticles of different sizes and polydispersities was achieved. Results are compared to complementary techniques such as transmission electron microscopy (TEM) and asymmetric flow field flow fractionation (AF4), and advantages as well as limitations of this newly proposed technique are discussed.

This work investigated the potential of a high temporal resolution inductively coupled plasma time-of-flight mass spectrometer (ICPTOFMS) in combination with a microdroplet generator (MDG) for simultaneous mass quantification of different nanoparticles (NPs) in a mixture. For this purpose, a test system containing certified Au NPs, well characterized Ag NPs, and core-shell NPs composed of an Au core and an Ag shell was employed. Thanks to the full spectra coverage and rapid simultaneous detection of the TOFMS, the element composition of individual particles can be determined. The pure Ag NPs and the core-shell NPs could be differentiated despite the same mass of Ag they contain. Calibration with monodisperse droplets consisting of standard solutions allowed for the mass quantification of NPs without the use of NP certified materials. On the basis of this mass quantification, the sizes of NPs originating from the same aqueous suspension were simultaneously determined with an accuracy of 7-12%. The size-equivalent limits of detection estimated with the 3*σ criterion were 13 nm for Au and 16 nm for Ag. Estimation of the LODs using Poisson statistics resulted in 19 and 27 nm, respectively. In addition, the 30 μs temporal resolution of the ICPTOFMS allowed studying interactions of NPs with the ICP based on their transient MS signals. The results demonstrated a difference in vaporization behavior of the core-shell NPs and solutions and indicated that vaporization of the Ag shell takes place prior to the Au core.

No abstract