A method for predicting yarn strength and strain is presented, based on the main fiber parameters of linear density, length, strain, and stress. The application of special software for a microcomputer makes the time required for all the calculations extremely short (2 minutes maximum). A comparison of the theoretical and experimental values of strength and breaking strain is presented.
SynopsisThe refractive indices, birefringence, and cross-sectional area of cotton fibers was measured using interference polarizing microscope constructed by M. Pluta. A new technique was suggested by realizing the measurements a t the perpendicular position of the duplicated image of fiber to the interference fringe. The proposed procedure is a combination of modification of Hamza method and Pluta dual wavelength method, and it was possible to measure a t once the three mentioned features of single fiber a t one time.
Serious damage to the inner rim of the rear twin wheel in one dump truck was noted during the operation of the fleet performing transport tasks. It was a drive wheel, and its damage occurred while driving with a load exceeding the permissible value. The examination of selected fragments of the damaged rim surface was conducted visually as well as using a digital microscope with a portable head. The measurements of the Vickers hardness and microscopic observations of the material structure of the sample cut along the thickness of the rim disk were carried out. The drive torque loading of the twin wheels of the tipper-truck rear axle, under their mating with different kinds of road roughness and under various vertical loads of the wheels was calculated. An analysis of stress distributions in the rim modelled using the Finite Element Method was also conducted for several possible scenarios of wheel loading. The damage to the rim was caused by simultaneous action of several factors, such as overloading the car, poor condition of the tires, loading the drive wheel by a part of the vehicle weight and the driving torque, and hitting a wheel on a cavity in a dirt road, causing a temporary relief of one of the tires on a twin wheel.
The exhaust gas recirculation (EGR) valve regulates the exhaust gas flow between the engine exhaust manifold and the inlet one. This allows the inlet air to warm up, improving fuel evaporation and reducing the combustion temperature of the charge. Such a valve reduces the number of harmful substances in the exhaust gas. The valve sticks when too much sediment builds on the walls of the exhaust system, especially during driving in urban conditions or when leaks in the vacuum or exhaust pipes occur. A faulty valve causes the engine to run unevenly at idle speed and under light loads. The defective EGR valve weakens the inlet manifold capacity, increases combustion, clogging of the particulate filter, damage to the lambda probe. A blocked EGR valve may lead to engine immobilization as a result of the operation of its computerized control system. A model of the EGR valve of a selected diesel engine was developed to determine the velocity distribution of the load flowing in it for different values of the degree of valve opening and the volume of deposits on the valve walls. The volume of accumulated carbon deposits on the walls of the EGR valve was measured using a real engine. Based on the recorded mileage of the vehicle, the assumed average speed of the car, and the driving style of the driver, the intensity of deposition of carbon particles on the walls was estimated.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.