Edge localized modes (ELMs) in high-confinement mode plasmas were completely suppressed in KSTAR by applying n=1 nonaxisymmetric magnetic perturbations. Initially, the ELMs were intensified with a reduction of frequency, but completely suppressed later. The electron density had an initial 10% decrease followed by a gradual increase as ELMs were suppressed. Interesting phenomena such as a saturated evolution of edge T(e) and broadband changes of magnetic fluctuations were observed, suggesting the change of edge transport by the applied magnetic perturbations.

An extensive study of intrinsic and controlled non-axisymmetric field (δB) impacts in KSTAR has enhanced the understanding about non-axisymmetric field physics and its implications, in particular, on resonant magnetic perturbation (RMP) physics and power threshold (Pth) for L–H transition. The n  =  1 intrinsic non-axisymmetric field in KSTAR was measured to remain as low as δB/B0 ~ 4  ×  10−5 even at high-beta plasmas (βN ~ 2), which corresponds to approximately 20% below the targeted ITER tolerance level. As for the RMP edge-localized-modes (ELM) control, robust n  =  1 RMP ELM-crash-suppression has been not only sustained for more than ~90 τE, but also confirmed to be compatible with rotating RMP. An optimal window of radial position of lower X-point (i.e. Rx  =   m) proved to be quite critical to reach full n  =  1 RMP-driven ELM-crash-suppression, while a constraint of the safety factor could be relaxed (q95  =  5 0.25). A more encouraging finding was that even when Rx cannot be positioned in the optimal window, another systematic scan in the vicinity of the previously optimal Rx allows for a new optimal window with relatively small variations of plasma parameters. Also, we have addressed the importance of optimal phasing (i.e. toroidal phase difference between adjacent rows) for n  =  1 RMP-driven ELM control, consistent with an ideal plasma response modeling which could predict phasing-dependent ELM suppression windows. In support of ITER RMP study, intentionally misaligned RMPs have been found to be quite effective during ELM-mitigation stage in lowering the peaks of divertor heat flux, as well as in broadening the ‘wet’ areas. Besides, a systematic survey of Pth dependence on non-axisymmetric field has revealed the potential limit of the merit of low intrinsic non-axisymmetry. Considering that the ITER RMP coils are composed of 3-rows, just like in KSTAR, further 3D physics study in KSTAR is expected to help us minimize the uncertainties of the ITER RMP coils, as well as establish an optimal 3D configuration for ITER and future reactors.

We report recent experimental results from HL-2A and KSTAR on ELM mitigation by supersonic molecular beam injection (SMBI). Cold particle deposition within the pedestal by SMBI is verified in both machines.The signatures of ELM mitigation by SMBI are an ELM frequency increase and ELM amplitude decrease.These persist for an SMBI influence time τI. Here, τI is the time for the SMBI influenced pedestal profile to refill. An increase in f SMBI ELM /f 0 ELM and a decrease in the energy loss per ELM WELM were achieved in both machines. Physical insight was gleaned from studies of density and vφ(toroidal rotation velocity) evolution, particle flux and turbulence spectra, divertor heat load. The characteristic gradients of the pedestal density soften and a change in vφwas observed during a τI time. The spectra of the edge particle flux Г~ < ˜vr˜ne> and density fluctuation with and without SMBI were measured in HL-2A and in KSTAR, respectively. A clear phenomenon observed is the decrease in divertor heat load during the τI time in HL-2A. Similar results are the profiles of saturation current density Jsat with and without SMBI in KSTAR. We note that τI/τp (particle confinement time) is close to ~1, although there is a large difference in individual τI between the two machines. This suggests that τI is strongly related to particle-transport events. Experiments and analysis of a simple phenomenological model support the important conclusion that ELM mitigation by SMBI results from an increase in higher frequency fluctuations and transport events in the pedestal.

This letter reports on the successful demonstration of the second harmonic electron cyclotron heating (ECH)-assisted startup in the first plasma experiments recently completed in the fully superconducting Korea Superconducting Tokamak Advanced Research (KSTAR) device whose major and minor radii are 1.8 m and 0.5 m, respectively. For the second harmonic ECH-assisted startup, an 84 GHz EC wave at 0.35 MW was launched before the onset of the toroidal electric field of the Ohmic system. And it was observed that this was sufficient to achieve breakdown in the ECH pre-ionization phase, allow burn-through and sustain the plasma during the current ramp with a low loop voltage of 2.0 V and a corresponding toroidal electric field of 0.24 V m−1at the innermost vacuum vessel wall (R = 1.3 m). This is a lower value than 0.3 Vm−1 which is the maximum electric field in ITER. Due to the limited volt-seconds and the loop voltage of the Ohmic power system, the extended pulse duration of the ECH power up to 180 ms allowed the plasma current to rise up to more than 100 kA with a ramp-up rate of 0.8 MA s−1.

We report the status of hybrid scenario experiments in Korea Superconducting Tokamak Advanced Research (KSTAR). The hybrid scenario is defined as stationary discharges with β N ⩾ 2.4 and H 89 ⩾ 2.0 at q 95 < 6.5 without or with very mild sawtooth activities in KSTAR. It is being developed towards reactor-relevant conditions. High performance of β N ≲ 3.0, H 89 ≲ 2.4 and G-factor (≡ β N H 89 /q 2 95 ) ≲ 0.46 has been achieved and sustained for ≳ 40τ E at n e /n GW ~0.7 with heating power of ≲5 MW. Some KSTAR hybrid discharges exhibit a unique feature of a slow transition from conventional H-mode to hybrid mode after the third neutral beam injection. The reason for the confinement enhancement is extensively studied in this transition period of a representative discharge exhibiting a common feature of KSTAR hybrid scenarios. 0D performance analysis with magnetohydrodynamic activities, 1D kinetic profile dynamics, power balance analysis, linear gyro-kinetic analysis and edge pedestal stability analysis were conducted. The enhancement is thought to be from both the core and the pedestal. The improvement in the core region of the ion energy channel is observed from the linear gyro-kinetic analysis considering the electromagnetic, the fast ion, the Shafranov shift, ω E×B , and the magnetic shear effect. The electromagnetic finite β stabilisation plays a role in the inner core region at ρ tor ∼ 0.35 together with the fast ion effect. The alpha stabilisation effect is also found at ρ tor ∼ 0.5. ω E×B , which could reduce the linear growth of the ion temperature gradient mode in the outer core region at ρ tor ∼ 0.5 − 0.7 with the highest contribution from the toroidal rotation. Regarding the improvement in the pedestal, Shafranov shift broadens the stability boundary of the pedestal in support of the diamagnetic effect. The pedestal height and width could be reproduced by the EPED model, while a realistic current profile is used to calculate the internal inductance for Shafranov shift. Based on these findings, a comprehensive confinement enhancement mechanism has been proposed by considering the core-edge interplay.