The remarkable properties of graphene, such as broadband optical absorption, high carrier mobility, and short photogenerated carrier lifetime, are particularly attractive for high-frequency optoelectronic devices operating at 1.55 μm telecom wavelength. Moreover, the possibility to transfer graphene on a silicon substrate using a complementary metal-oxide-semiconductor-compatible process opens the ability to integrate electronics and optics on a single cost-effective chip. Here, we report an optoelectronic mixer based on chemical vapor-deposited graphene transferred on an oxidized silicon substrate. Our device consists in a coplanar waveguide that integrates a graphene channel, passivated with an atomic layer-deposited Al2O3 film. With this new structure, 30 GHz optoelectronic mixing in commercially available graphene is demonstrated for the first time. In particular, using a 30 GHz intensity-modulated optical signal and a 29.9 GHz electrical signal, we show frequency downconversion to 100 MHz. These results open promising perspectives in the domain of optoelectronics for radar and radio-communication systems.

Relative intensity noise and frequency noise have been measured for the first time for a single-frequency Brillouin chalcogenide As38Se62 fiber laser. This is also the first demonstration of a compact suspended-core fiber Brillouin laser, which exhibits a low threshold power of 22 mW and a slope efficiency of 26% for nonresonant pumping.

Intensity noise characteristics of a single-mode Brillouin fiber ring laser are experimentally analyzed from 100 kHz up to 18 GHz. The Stokes wave is shown to be shot-noise limited to -155 dB/Hz for a 1 mA detected photocurrent over the whole spectral range 100 MHz-18 GHz. The pump-to-Stokes noise filtering efficiency is evaluated by artificially increasing the pump intensity noise. It evidences that a shot-noise-limited Brillouin laser could be realized by using a narrow-linewidth semiconductor laser pump, for stringent microwave photonics applications.

We propose a reliable method for stabilizing narrow linewidth Brillouin fiber lasers with non-resonant pumping. Mode-hopping is suppressed by means of a phase-locked loop that locks the pump-Stokes detuning to a local radio-frequency (RF) oscillator. Stable single-mode operation of a 110-m-long Brillouin fiber laser oscillating at 1.55 μm is demonstrated for several hours. The beat note between two independent Stokes waves presents a phase noise level of -60  dBc/Hz at 100 Hz with a -20  dB/decade slope, and a FWHM linewidth lower than 50 Hz.

No abstract