Factors determining the orientation of two-dimensional perovskites were examined.

Two-dimensional perovskite compounds, (RNH 3 ) 2 PbX 4 , have attracted much attention as quantum confinement materials. To achieve suitable orientation and exciton properties for optical applications, carboxy groups were introduced into the ammonium cations of two-dimensional perovskite compounds, which formed dimer structures based on the hydrogen bonding by the carboxy moieties. This structural organization allowed control of the layer orientation for favorable solar cells and thermal stability of the perovskites, while maintaining quantum confinement effects.

Push-coating is a simple process that can be employed for extremely low-cost polymer electronic device production. Here, we demonstrate its application to the fabrication of poly­(2,7-carbazole-alt-dithienylbenzothiadiazole) (PCDTBT):[6,6]-phenyl-C71-butyric acid methyl ester (PC71BM) active layers processed in air, yielding similar photovoltaic performances as thermally annealed spin-coated thin films when used in inverted polymer solar cells (PSCs). During push-coating, the polydimethylsiloxane layer temporarily traps the deposition solvent, resulting in simultaneous film formation and solvent annealing effect. This removes the necessity for a postdeposition thermal annealing step which is required for spin-coated PSCs to produce high photovoltaic performances. Optimized PSC active layers are produced with a push-coating time of 5 min at room temperature with 20 times less hazardous solvent and 40 times less active material than spin-coating. Annealed spin-coated active layers and active layers push-coated for 5 min both produce average power conversion efficiencies (PCEs) of 5.77%, while those push-coated for a shorter time of 1 min yield a slightly lower value of 5.59%. We demonstrate that, despite differences in their donor:acceptor vertical concentration gradients, unencapsulated PCDTBT:PC71BM active layers push-coated for 1 min produce PSCs with similar operational stability and upscaling capacity as thermally annealed spin-coated ones. As fast device fabrication can be achieved with short-time push-coating, we further demonstrate the potential of this deposition technique by manufacturing push-coated PSC-based semitransparent photovoltaic devices with a PCE of 4.23%, relatively neutral colors and an average visible transparency of 40.2%. Our work thus confirms that push-coating is not limited to the widely employed poly­(3-hexylthiophene-2,5-diyl) but can also be used with low band gap copolymers and opens the path to low-cost and eco-friendly, yet efficient and stable PSCs.