Theoretical calculations unveil that the formation of Os‐OsSe2 heterostructures with neutralized work function (WF) perfectly balances the electronic state between strong (Os) and weak (OsSe2) adsorbents and bidirectionally optimizes the hydrogen evolution reaction (HER) activity of Os sites, significantly reducing thermodynamic energy barrier and accelerating kinetics process. Then, heterostructural Os‐OsSe2 is constructed for the first time by a molten salt method and confirmed by in‐depth structural characterization. Impressively, due to highly active sites endowed by the charge balance effect, Os‐OsSe2 exhibits ultra‐low overpotentials for HER in both acidic (26 mV @ 10 mA cm−2) and alkaline (23 mV @ 10 mA cm−2) media, surpassing commercial Pt catalysts. Moreover, the solar‐to‐hydrogen device assembled with Os‐OsSe2 further highlights its potential application prospects. Profoundly, this special heterostructure provides a new model for rational selection of heterocomponents.
Anchoring platinum catalysts on appropriate supports, e.g., MXenes, is a feasible pathway to achieve a desirable anode for direct methanol fuel cells. The authentic performance of Pt is often hindered by the occupancy and poisoning of active sites, weak interaction between Pt and supports, and the dissolution of Pt. Herein, we construct three-dimensional (3D) crumpled Ti 3 C 2 T x MXene balls with abundant Ti vacancies for Pt confinement via a spray-drying process. The as-prepared Pt clusters/Ti 3 C 2 T x (Ptc/Ti 3 C 2 T x ) show enhanced electrocatalytic methanol oxidation reaction (MOR) activity, including a relatively low overpotential, high tolerance to CO poisoning, and ultrahigh stability. Specifically, it achieves a high mass activity of up to 7.32 A mg Pt −1 , which is the highest value reported to date in Pt-based electrocatalysts, and 42% of the current density is retained on Ptc/Ti 3 C 2 T x even after the 3000 min operative time. In situ spectroscopy and theoretical calculations reveal that an electric field-induced repulsion on the Ptc/Ti 3 C 2 T x interface accelerates the combination of OH − and CO adsorption intermediates (CO ads ) in kinetics and thermodynamics. Besides, this Ptc/Ti 3 C 2 T x also efficiently electrocatalyze ethanol, ethylene glycol, and glycerol oxidation reactions with comparable activity and stability to commercial Pt/C.
Electrochemical synthesis of NH3 is a carbon-free alternative to the traditional Haber-Bosch process. The challenge with nitrogen reduction reaction (NRR) to NH3 is cleavage of the inert N≡N triple bond of nitrogen gas. Obtaining NH3 from environmental pollutants, such as nitrates or nitrites, is a more practical route than NRR. However, reduction of nitrates or nitrites to ammonia is currently hampered by modest Faradaic efficiencies, typically below 10 %. Here, we report a novel heterogeneous catalyst based on iron (Fe) single-atoms supported on two-dimensional MoS2 (Fe-MoS2) for the nitrate reduction reaction (NO3RR). We have found that Fe-MoS2 exhibits remarkable performance with a maximum Faradaic efficiency of 98 % for NO3RR to NH3 at an overpotential of -0.48 V vs. the reversible hydrogen electrode (RHE) as confirmed by our isotopic nuclear magnetic resonance (NMR) analyses. Density function theory (DFT) calculations reveal that the enhanced selectivity for the production of NH3 from single Fe atoms supported on MoS2 is attributed to a reduced energy barrier of 0.38 eV associated with de-oxidation of *NO to *N -the usual potential limiting step in NO3RR. We assembled our catalyst in a two-electrode electrolyzer coupled to an InGaP/GaAs/Ge triple-junction solar cell to demonstrate a solar-to-ammonia (STA) conversion efficiency of 3.4 % and a yield rate of 0.03 mmol h -1 cm -2 equivalent to 510 µg h -1 cm -2 . Our results open new avenues for design of single-atom catalysts (SAC) for the realization of solar-driven ammonia production.
Platinum (Pt)‐based electrocatalysts are the benchmark catalysts for hydrogen evolution reaction (HER); however, they are limited by the scarcity and high price. Introducing an adequate substrate to disperse and anchor Pt‐based species is a feasible pathway to improve the utilization efficiency. Herein, a quick and continuous spray drying route is proposed to fabricate 3D crumpled Ti3C2Tx MXene loaded with sub‐nanometer platinum clusters (Pt/MXene). The 3D crumpled structure inhibits the restacking of layered MXene nanosheets and guarantees the fully exposure of Pt clusters. The as‐prepared catalyst exhibits excellent HER performances comparable to commercial Pt/C, including a low overpotential of 34 mV to reach a current density of 10 mA cm−2, a superior mass activity (1847 mA mgPt−1), a small Tafel slope (29.7 mV dec−1), and a high turnover frequency (10.66 H2 s−1). The improved activity of Pt/MXene can be attributed to the charge transfer from Pt clusters to MXene, which weakens the hydrogen adsorption, as evidenced by the density functional theory calculations. The present contribution proposes a novel strategy to anchor low‐mass‐loading sub‐nanometer precious metal clusters on crumpled MXene with fully exposed active sites for catalysis.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.