An intercomparison study of a midlatitude mesoscale squall line is performed using the Weather Research and Forecasting (WRF) model at 1 km horizontal grid spacing with eight different cloud microphysics schemes to investigate processes that contribute to the large variability in simulated cloud and precipitation properties. All simulations tend to produce a wider area of high radar reflectivity (Ze > 45 dBZ) than observed but a much narrower stratiform area. The magnitude of the virtual potential temperature drop associated with the gust front passage is similar in simulations and observations, while the pressure rise and peak wind speed are smaller than observed, possibly suggesting that simulated cold pools are shallower than observed. Most of the microphysics schemes overestimate vertical velocity and Ze in convective updrafts as compared with observational retrievals. Simulated precipitation rates and updraft velocities have significant variability across the eight schemes, even in this strongly dynamically driven system. Differences in simulated updraft velocity correlate well with differences in simulated buoyancy and low‐level vertical perturbation pressure gradient, which appears related to cold pool intensity that is controlled by the evaporation rate. Simulations with stronger updrafts have a more optimal convective state, with stronger cold pools, ambient low‐level vertical wind shear, and rear‐inflow jets. Updraft velocity variability between schemes is mainly controlled by differences in simulated ice‐related processes, which impact the overall latent heating rate, whereas surface rainfall variability increases in no‐ice simulations mainly because of scheme differences in collision‐coalescence parameterizations.

The squall-line event on 20 May 2011, during the Midlatitude Continental Convective Clouds (MC3E) field campaign has been simulated by three bin (spectral) microphysics schemes coupled into the Weather Research and Forecasting (WRF) Model. Semi-idealized three-dimensional simulations driven by temperature and moisture profiles acquired by a radiosonde released in the preconvection environment at 1200 UTC in Morris, Oklahoma, show that each scheme produced a squall line with features broadly consistent with the observed storm characteristics. However, substantial differences in the details of the simulated dynamic and thermodynamic structure are evident. These differences are attributed to different algorithms and numerical representations of microphysical processes, assumptions of the hydrometeor processes and properties, especially ice particle mass, density, and terminal velocity relationships with size, and the resulting interactions between the microphysics, cold pool, and dynamics. This study shows that different bin microphysics schemes, designed to be conceptually more realistic and thus arguably more accurate than bulk microphysics schemes, still simulate a wide spread of microphysical, thermodynamic, and dynamic characteristics of a squall line, qualitatively similar to the spread of squall-line characteristics using various bulk schemes. Future work may focus on improving the representation of ice particle properties in bin schemes to reduce this uncertainty and using the similar assumptions for all schemes to isolate the impact of physics from numerics.

Although satellite precipitation estimates provide valuable information for weather and flood forecasts, infrared (IR) brightness temperature (BT)-based algorithms often produce large errors for precipitation detection and estimation during deep convective systems (DCSs). As DCSs produce greatly varying precipitation rates below similar IR BT retrievals, using IR BTs alone to estimate precipitation in DCSs is problematic. Classifying a DCS into convective-core (CC), stratiform (SR), and anvil cloud (AC) regions allows an evaluation of estimated precipitation distributions among DCS components to supplement typical quantitative precipitation estimate (QPE) evaluations and to diagnose these IR-based algorithm biases. This paper assesses the performance of the National Mosaic and Multi-Sensor Next Generation Quantitative Precipitation Estimation System (NMQ Q2), and a simplified version of the Self-Calibrating Multivariate Precipitation Retrieval (SCaMPR) algorithm, over the state of Oklahoma using Oklahoma Mesonet observations. While average annual Q2 precipitation estimates were about 35% higher than Mesonet observations, strong correlations exist between these two datasets for multiple temporal and spatial scales. Additionally, the Q2-estimated precipitation distribution among DCS components strongly resembled the Mesonet-observed distribution, indicating Q2 can accurately capture the precipitation characteristics of DCSs despite its wet bias. SCaMPR retrievals were typically 3-4 times higher than Mesonet observations, with relatively weak correlations during 2012. Overestimates from SCaMPR retrievals were primarily caused by precipitation retrievals from the anvil regions of DCSs when collocated Mesonet stations recorded no precipitation. A modified SCaMPR retrieval algorithm, employing both cloud optical depth and IR temperature, has the potential to make significant improvements to reduce the wet bias of SCaMPR retrievals over anvil regions of a DCS.

The Mesoscale Heavy Rainfall Observing System (MHROS), supported by the Institute of Heavy Rain (IHR), Chinese Meteorology Administration, is one of the major systems to observe mesoscale convective systems (MCSs) over the middle region of the Yangtze River in China. The IHR MHROS consists of mobile C-POL and X-POL precipitation radars, millimeter wavelength cloud radar, fixed S-band precipitation radars, GPS network, microwave radiometers, radio soundings, wind profiler radars, and disdrometers. The atmospheric variables observed or retrieved by these instruments include the profiles of atmospheric temperature, moisture, wind speed and direction, vertical structures of MCS clouds and precipitation, atmospheric water vapor, and cloud liquid water. These quality-controlled observations and retrievals have been used in mesoscale numerical weather prediction to improve the accuracy of weather forecasting and MCS research since 2007. These long-term observations have provided the most comprehensive data sets for researchers to investigate the formation-dissipation processes of MCSs and for modelers to improve their simulations of MCSs. As the first paper of a series, we briefly introduce the IHR MHROS and describe the specifications of its major instruments. Then, we provide an integrative analysis of the IHR MHROS observations for a heavy rain case on 3-5 July 2014 as well as the application of IHR MHROS observations in improving the model simulations. In a series of papers, we will tentatively answer several key scientific questions related to the MCS and Meiyu frontal systems over the middle region of the Yangtze River using the IHR MHROS observations.

To address gaps in ground-based radar coverage and rain gauge networks in the United States, geostationary satellite quantitative precipitation estimation (QPE) such as the Self-Calibrating Multivariate Precipitation Retrieval (SCaMPR) can be used to fill in both spatial and temporal gaps of ground-based measurements. Additionally, with the launch of Geostationary Operational Environmental Satellite R series (GOES-R), the temporal resolution of satellite QPEs may be comparable to Weather Surveillance Radar-1988 Doppler (WSR-88D) volume scans as GOES images will be available every 5 min. However, while satellite QPEs have strengths in spatial coverage and temporal resolution, they face limitations, particularly during convective events. Deep convective systems (DCSs) have large cloud shields with similar brightness temperatures (BTs) over nearly the entire system, but widely varying precipitation rates beneath these clouds. Geostationary satellite QPEs relying on the indirect relationship between BTs and precipitation rates often suffer from large errors because anvil regions (little or no precipitation) cannot be distinguished from rain cores (heavy precipitation) using only BTs. However, a combination of BTs and optical depth τ has been found to reduce overestimates of precipitation in anvil regions. A new rain mask algorithm incorporating both τ and BTs has been developed, and its application to the existing SCaMPR algorithm was evaluated. The performance of the modified SCaMPR was evaluated using traditional skill scores and a more detailed analysis of performance in individual DCS components by utilizing the Feng et al. classification algorithm. SCaMPR estimates with the new rain mask benefited from significantly reduced overestimates of precipitation in anvil regions and overall improvements in skill scores.