This experiment investigated the effects of dietary supplementation of Origanum vulgare L. leaf material (OR) on rumen fermentation, production, and milk fatty acid composition in dairy cows. The experimental design was a replicated 4 × 4 Latin square with 8 rumen-cannulated Holstein cows and 20-d experimental periods. Treatments were control (no OR supplementation), 250 g/cow per day OR (LOR), 500 g/d OR (MOR), and 750 g/d OR (HOR). Oregano supplementation had no effect on rumen pH, volatile fatty acid concentrations, and estimated microbial protein synthesis, but decreased ammonia concentration and linearly decreased methane production per unit of dry matter intake (DMI) compared with the unsupplemented control: 18.2, 16.5, 11.7, and 13.6g of methane/kg of DMI, respectively. Proportions of rumen bacterial, methanogen, and fungal populations were not affected by treatment. Treatment had no effect on total-tract apparent digestibility of dietary nutrients, except neutral detergent fiber digestibility was slightly decreased by all OR treatments compared with the control. Urinary N losses and manure odor were not affected by OR, except the proportion of urinary urea N in the total excreted urine N tended to be decreased compared with the control. Oregano linearly decreased DMI (28.3, 28.3, 27.5, and 26.7 kg/d for control, LOR, MOR, and HOR, respectively). Milk yield was not affected by treatment: 43.4, 45.2, 44.1, and 43.4 kg/d, respectively. Feed efficiency was linearly increased with OR supplementation and was greater than the control (1.46, 1.59, 1.60, and 1.63 kg/kg, respectively). Milk composition was unaffected by OR, except milk urea-N concentration was decreased. Milk fatty acid composition was not affected by treatment. In this short-term study, OR fed at 250 to 750 g/d decreased rumen methane production in dairy cows within 8h after feeding, but the effect over a 24-h feeding cycle has not been determined. Supplementation of the diet with OR linearly decreased DMI and increased feed efficiency. Oregano had no effects on milk fatty acid composition.

Managing manure in reduced tillage and forage systems presents challenges, as incorporation by tillage is not compatible. Surface-applied manure that is not quickly incorporated into soil provides inefficient delivery of manure nutrients to crops due to environmental losses through ammonia (NH3) volatilization and nutrient losses in runoff, and serves as a major source of nuisance odors. An array of technologies now exist to facilitate the incorporation of liquid manures into soil with restricted or minor soil disturbance, some of which are new: shallow disk injection; chisel injection; aeration infiltration; pressure injection. Surface banding of manure inforages decreases NH3 emissions relative to surface broadcasting, as the canopy can decrease wind speed over the manure, but greater reductions can be achieved with manure injection. Soilaeration is intended to hasten manure infiltration, but its benefits are not consistent and may be related to factors such as soildrainage characteristics. Work remains to be done on refining its method of use and timing relative to manure application, which may improve its effectiveness. Placing manure under the soil surface efficiency by injection offers much promise to improve N use efficiency through less NH3 volatilization, reduced odors and decreased nutrient losses in runoff, relative to surface application. We identified significant gaps in our knowledge as manyof these technologies are relatively new, and this should help target future research efforts including environmental, agronomic, and economic assessments.

Runoff losses of dissolved and particulate phosphorus (P) may occur when rainfall interacts with manures and biosolids spread on the soil surface. This study compared P levels in runoff losses from soils amended with several P sources, including 10 different biosolids and dairy manure (untreated and treated with Fe or Al salts). Simulated rainfall (71 mm h(-1)) was applied until 30 min of runoff was collected from soil boxes (100 x 20 x 5 cm) to which the P sources were surfaced applied. Materials were applied to achieve a common plant available nitrogen (PAN) rate of 134 kg PAN ha(-1), resulting in total P loading rates from 122 (dairy manure) to 555 (Syracuse N-Viro biosolids) kg P ha(-1). Two biosolids produced via biological phosphorus removal (BPR) wastewater treatment resulted in the highest total dissolved phosphorus (13-21.5 mg TDP L(-1)) and total phosphorus (18-27.5 mg TP L(-1)) concentrations in runoff, followed by untreated dairy manure that had statistically (p = 0.05) higher TDP (8.5 mg L(-1)) and TP (10.9 mg L(-1)) than seven of the eight other biosolids. The TDP and TP in runoff from six biosolids did not differ significantly from unamended control (0.03 mg TDP L(-1); 0.95 mg TP L(-1)). Highest runoff TDP was associated with P sources low in Al and Fe. Amending dairy manure with Al and Fe salts at 1:1 metal-to-P molar ratio reduced runoff TP to control levels. Runoff TDP and TP were not positively correlated to TP application rate unless modified by a weighting factor reflecting the relative solubility of the P source. This suggests site assessment indices should account for the differential solubility of the applied P source to accurately predict the risk of P loss from the wide variety of biosolids materials routinely land applied.

The correlation of runoff phosphorus (P) with water-extractable phosphorus (WEP) in land-applied manures and biosolids has spurred wide use of WEP as a water quality indicator. Land managers, planners, and researchers need a common WEP protocol to consistently use WEP in nutrient management. Our objectives were to (i) identify a common WEP protocol with sufficient accuracy and precision to be adopted by commercial testing laboratories and (ii) confirm that the common protocol is a reliable index of runoff P. Ten laboratories across North America evaluated alternative protocols with an array of manure and biosolids samples. A single laboratory analyzed all samples and conducted a separate runoff study with the manures and biosolids. Extraction ratio (solution:solids) was the most important factor affecting WEP, with WEP increasing from 10:1 to 100:1 and increasing from 100:1 to 200:1. When WEP was measured by a single laboratory, correlations with runoff P from packed soil boxes amended with manure and biosolids ranged from 0.79 to 0.92 across all protocol combinations (extraction ratio, filtration method, and P determination method). Correlations with P in runoff were slightly lower but significant when WEP was measured by the 10 labs (r=0.56-0.86). Based on laboratory repeatability and water quality evaluation criteria, we recommend the following common protocol: 100:1 extraction ratio; 1-h shaking and centrifuge 10 min at 1500xg (filter with Whatman #1 paper if necessary); and determining P by inductively coupled plasma-atomic emission spectrometry or colorimetric methods.

Phosphorus release to runoff varies widely for different land-applied organic P sources even when spread at equivalent total P rates. To address this variability, some P site indices include tabulated P source coefficients (PSCs) for differential weighting of applied P materials based on their runoff enrichment potential. Because runoff P can vary widely even within source categories depending on composition, storage, and treatment differences, this study explored a method for estimating PSCs based on the water-extractable P (WEP) content of the applied amendment. Using seven published rainfall-runoff studies that followed National Phosphorus Research Project protocols, runoff dissolved P (RDP) was correlated (r(2) = 0.80) with WEP for multiple surface-applied manures and biosolids. Assuming amendments with WEP >/= 10 g kg(-1) behave as highly soluble P sources and have a maximum PSC of 1.0, an empirical equation was developed for computing source-specific PSCs from laboratory-determined WEP values [PSC = 0.102 x WEP(0.99)]. For two independent runoff experiments, correlations between RDP loss and P source loading rate were improved when loading rates were multiplied by the computed (r(2) = 0.73-0.86) versus generic (r(2) = 0.45-0.48) PSCs. Source-specific PSCs should enhance the ability of assessment tools to identify vulnerable sites and P loss management alternatives, although the exact inclusion process depends on index scaling and conceptual framework.