Cyclic voltammetry experiments at minielectrodes exhibit less ohmic error for lower polarity solvents when the supporting electrolyte anion is [B(C(6)F(5))(4)](-) rather than one of the smaller traditional anions such as [BF(4)](-), [PF(6)](-), or [ClO(4)](-). Conductance measurements have been performed for [NBu(4)][B(C(6)F(5))(4)] in tetrahydrofuran, dichloromethane, benzotrifluoride, and acetonitrile and compared with results for [NBu(4)](+) salts of several traditional anions in the same solvents. In solvents with dielectric constants of 10 or less, ion association constants, K(A), are as much as 2 orders of magnitude lower with [B(C(6)F(5))(4)](-), TFAB, as the electrolyte anion and the degree of this lowering is related to the acceptor property of the solvent. Analyses carried out on the basis of a Fuoss model attribute this fact to differences in concentrations of contact ion pairs rather than of solvent-separated ion pairs. The greater dissociation of the TFAB ion is attributed to its highly delocalized charge.

We report the cyclic voltammetry, chronoamperometry, and scanning electrochemical microscopy of ferrocene dissolved in deep eutectic solvents (DES), consisting of choline chloride (ChCl) and either trifluoroacetamide (TFA) or malonic acid as the hydrogen-bond donor. Despite the use of ultramicroelectrodes, which were required due to the modest conductivities of the DES employed, linear diffusion behavior was observed in cyclic voltammetric experiments. The high viscosity of 1:2 ChCl/TFA relative to non-aqueous electrochemical solvents leads to a low diffusion coefficient, 2.7 x 10(-8) cm2 s(-1) for ferrocene in this medium. Because of the difficulties in achieving steady-state conditions, SECM approach curves were tip velocity dependent. Under certain conditions, SECM approach curves to an insulating substrate displayed a positive-feedback response. Satisfactory simulation of this unexpected behavior was obtained by including convection terms into the mass transport equations typically used for SECM theory. The observance of positive-feedback behavior at an insulating substrate can be described in terms of a dimensionless parameter, the Peclet number, which is the ratio of the convective and diffusive timescales. Fitting insulator approach curves of ferrocene in 1:2 ChCl/TFA shows an apparent increase in the diffusion coefficient with increasing tip velocity, which can be explained by DES behaving as a shear thinning non-Newtonian fluid.

From the reaction of in situ generated 1,2-di(4-tert-butylphenyl)ethylene-1,2-dithiol, 2LH2, and Na[AuCl4].2H2O in 1,4-dioxane, green brown crystals of diamagnetic [N(n-Bu)4][AuIII(2L)2] (1) were obtained. As shown by cyclic voltammetry, 1 is a member of an electron-transfer series comprising the dianion [AuII(2L)2]2-, the monoanion [AuIII(2L)2]-, the neutral species [AuIII(2L*)(2L)]0 <--> [AuIII(2L)(2L*)]0, and the monocation [AuIII(2L*)2]+. (2L*)1- represents the pi radical anion (Srad = 1/2) of the one-electron oxidized closed-shell dianion (2L)2-. Oxidation of 1 in CH2Cl2 with ferrocenium hexafluorophosphate affords green, paramagnetic microcrystals of [AuIII(2L*)(2L)] <--> [AuIII(2L)(2L*)] (2) (S = 1/2). Complexes 1 and 2 have been characterized by X-ray crystallography. Both species possess square-planar monoanions and neutral molecules, respectively. From the oxidation reaction of 1 or [N(n-Bu)4][AuIII(3L)2] with 2-3 equiv of [NO]BF4 in CH2Cl2, a green solution of [AuIII(2L*)2]+ and green microcrystals of [AuIII(3L*)2]BF4 (3) were obtained, respectively; (3L)2- represents the dianion 1,2-di(4-diphenyl)ethylene-1,2-dithiolate, and (3L*)1- is its pi radical monoanion. The electronic structures of this series of gold species have been elucidated by UV-vis, EPR spectroscopies, and DFT calculations. It is shown computationally by density functional theoretical (DFT) methods that the electronic structure of [AuIII(1L*)2]+ is best described as a singlet diradical (St = 0); the ligand mixed valency in the neutral species 2 is of class (III) (delocalized); the monoanion in 1 contains a AuIII ion and two closed-shell dianionic ligands; and the corresponding dianions [Au(L)2]2- are best described as an intermediate AuII/AuIII species with a metal-ligand delocalized SOMO (25% Au 5d, 75% 3p of four S atoms). (1L)2- is the dianion 1,2-di(phenyl)ethylene-1,2-dithiolate, and (1L*)1- is the pi radical monoanion. The neutral species [PdII(2L*)2] (4) has also been synthesized and characterized by X-ray crystallography. Its electronic structure is the same as described for [AuIII(1L*)2]+ (singlet diradical), whereas that of the monoanion [PdII(2L*)(2L)]- <--> [Pd(2L)(2L*)]- corresponds to that of the neutral gold complex 2. Anodic oxidation of the analogous monoanion [AuIII(mnt)2]-, where mnt = maleonitriledithiolate, gave the neutral complex [Au(mnt)(mnt*)] (E1/2 = 0.91 V vs Fc+/Fc). The optical and EPR spectroscopies of [Au(mnt)(mnt*)] were consistent with those observed for the corresponding di(tert-butylphenyl)ethylenedithiolate complex 2.

Persistent blue-to-purple solutions of the complexes M[S4C4(CN)4], M(mnt)2, M = Ni, Pd, Pt have for the first time been prepared by anodic electrolysis. Solids isolated from more concentrated solutions of the Ni and Pd complexes quantitatively form the corresponding monoanions when dissolved in weakly basic solvents. Pt[S4C4(CN)4] is a strong one-electron oxidant. All three complexes react with norbornadiene yielding electroactive products.

The noncoordinating anion [B(C(6)F(5))(4)](-) solubilizes cations and polycations, allowing the generation and study of such systems in low-dielectric media. Thus, when [NBu(4)][B(C(6)F(5))(4)] is used as a supporting electrolyte, cyclic voltammetry is possible in aliphatic ethers and other solvents of very low polarity.

Surface deactivation and reactivation processes on the Magnéli phase electrode surface in H2SO4electrolyte.

No abstract

Base-catalyzed condensation of diferrocenylsilanediol, Fc2Si(OH)2 (3; Fc = (η-C5H4)Fe(η-C5H5)), in refluxing 95% ethanol (ca. 90 °C) affords a novel cyclotrisiloxane with six ferrocenyl substituents, [Fc2SiO]3 (4), in 74% yield. At 60 °C, the intermediate tetraferrocenyldisiloxanediol, [HOSiFc2]2O (5), could be isolated in 78% yield. NMR, IR, Raman, and UV−vis data for 4 and 5 were consistent with the proposed structures. Electrochemical studies of 4 showed that there are substantial interactions between the ferrocenyl groups attached to the same Si atom and weaker interactions between the ferrocenyl groups attached to adjacent Si atoms. Furthermore, single-crystal X-ray diffraction studies of these compounds revealed an essentially planar Si3O3 ring in 4 and a novel hydrogen-bonded chain motif for disiloxanediol 5. Surprisingly, 4 and 5 cocrystallize in a 1:3 ratio from a CH2Cl2/hexanes mixture to afford an interesting helical hydrogen-bonding structure for the siloxanediol 5.