Phase-change optical memories are based on the astonishingly rapid nanosecond-scale crystallization of nanosized amorphous 'marks' in a polycrystalline layer. Models of crystallization exist for the commercially used phase-change alloy Ge(2)Sb(2)Te(5) (GST), but not for the equally important class of Sb-Te-based alloys. We have combined X-ray diffraction, extended X-ray absorption fine structure and hard X-ray photoelectron spectroscopy experiments with density functional simulations to determine the crystalline and amorphous structures of Ag(3.5)In(3.8)Sb(75.0)Te(17.7) (AIST) and how they differ from GST. The structure of amorphous (a-) AIST shows a range of atomic ring sizes, whereas a-GST shows mainly small rings and cavities. The local environment of Sb in both forms of AIST is a distorted 3+3 octahedron. These structures suggest a bond-interchange model, where a sequence of small displacements of Sb atoms accompanied by interchanges of short and long bonds is the origin of the rapid crystallization of a-AIST. It differs profoundly from crystallization in a-GST.
The (GeTe)1−γ–(Sb2Te3)γ pseudobinary system has, over almost its entire composition range, two kinds of crystalline phase: one is a metastable phase with a NaCl-type structure and the other is a spectrum of stable phases with homologous structures. In the metastable phase, Ge/Sb atoms and intrinsic vacancies occupy the Na sites; on the other hand, Te atoms are located at the Cl sites. These vacancies are produced by following γ/1+2γ to ensure the stoichiometry of the metastable pseudobinary compound. This metastable phase obstinately holds its NaCl-type structure and resists transformation to stable homologous structures, even at high temperatures on the GeTe-rich side of the system. In GeTe (γ=0), the NaCl-type atomic configuration itself is the stable structure. GeTe has, as is well known, a high-temperature cubic phase and a low-temperature rhombohedral phase. This GeTe and the pseudobinary compounds containing a small quantity of Sb2Te3 have their single-phase regions not on the GeTe–Sb2Te3 tie line but at Ge-poor sides off the line: in other words, the Na sites of these off-stoichiometric compounds have some excess vacancies besides the intrinsic vacancies. As Sb2Te3 is further added to GeTe, however, the structural transformation temperature continuously falls and the single-phase region converges on the tie line as the excess vacancies at the Na site disappear, which change its electrical property from metallic to semiconducting conductivity. The low-temperature rhombohedral phase is present up to near γ=0.14. The NaCl-type metastable phase becomes unstable with increased Sb2Te3; after subjecting the compound Ge8Sb2Te11 (γ=0.11) to heat treatment for 15 days at 773 K, a stable homologous structure appeared.
Crystallization of an amorphous solid is usually accompanied by a significant change of transport properties, such as an increase in thermal and electrical conductivity. This fact underlines the importance of crystalline order for the transport of charge and heat. Phase-change materials, however, reveal a remarkably low thermal conductivity in the crystalline state. The small change in this conductivity upon crystallization points to unique lattice properties. The present investigation reveals that the thermal properties of the amorphous and crystalline state of phase-change materials show remarkable differences such as higher thermal displacements and a more pronounced anharmonic behavior in the crystalline phase. These fi ndings are related to the change of bonding upon crystallization, which leads to an increase of the sound velocity and a softening of the optical phonon modes at the same time.
GeTe(1-x)-Sb2Te3(x) sputtered amorphous film was crystallized into a simple NaCl-type structure through instantaneous laser irradiation over a wide composition range from x = 0 to at least 2/3. When the ratio of Sb2Te3 increases, a vacancy is generated at every Na site for two Sb atoms. The fraction of vacancies, v(x), changes according to x/(1 + 2x), and the cubic root unit cell volume varies with a strong correlation to v(x). Through these created vacancies, valence electrons provided by adjacent Ge/Sb and Te atoms remain constant regardless of the composition, ensuring that these electrons occupy predominantly the bonding molecular orbitals. This results in crystal chemical stability, with the closed shell p-p bondings in the valence electrons arranging the crystal's atomic configuration into an NaCl-type structure.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.