Textile composites made of woven fabrics have demonstrated excellent mechanical properties for the production of high specific-strength products. Research efforts in the woven fabric sheet forming are currently at a point where benchmarking will lead to major advances in understanding both the strengths and the limitations of existing experimental and modeling approaches. Test results can provide valuable information for the material characterization and forming process design of woven composites if researchers know how to interpret the results obtained from varying test methods appropriately. An international group of academic and industry researchers has gathered to design and conduct benchmarking tests of interest to the composite sheet forming community. Shear deformation is the dominative deformation mode for woven fabrics in forming; therefore, trellis-frame (picture-frame) and biasextension tests for both balanced and unbalanced fabrics have been conducted and compared through this collaborative effort. Tests were conducted by seven international research institutions on three identical woven fabrics. Both the variations in the setup of each research laboratory and the normalization methods used to compare the test results are presented and discussed. With an understanding of the effects of testing variations on the results and the normalization methods, numerical modeling efforts can commence and new testing methods can be developed to advance the field.

The increased usage of fiber reinforced polymer composites in load bearing applications requires a detailed understanding of the process induced residual stresses and their effect on the shape distortions. This is utmost necessary in order to have more reliable composite manufacturing since the residual stresses alter the internal stress level of the composite part during the service life and the residual shape distortions may lead to not meeting the desired geometrical tolerances. The occurrence of residual stresses during the manufacturing process inherently contains diverse interactions between the involved physical phenomena mainly related to material flow, heat transfer and polymerization or crystallization. Development of numerical process models is required for virtual design and optimization of the composite manufacturing process which avoids the expensive trial-and-error based approaches. The process models as well as applications focusing on the prediction of residual stresses and shape distortions taking place in composite manufacturing are discussed in this study. The applications on both thermoset and thermoplastic based composites are reviewed in detail.

The rapid utilization of carbon fibre reinforced composite (CFRC) and glass fibre reinforced composite (GFRC) in main sectors, such as automobile, aerospace, wind turbines, boats and sport parts, has gained much attention because of its high strength, light weight and impressive mechanical properties. Currently, the increasing amount and handling of composite waste at their end-of-life (EoL) has a negative impact on resources conservation and the environment. Pyrolysis, a two-step process, appeared as most viable process to recover not only valuable materials but also produce fuel and chemicals. However, the testing facilities and optimized operation of composite waste in pyrolysis processes to produce materials with low energy consumption and acceptable mechanical properties are still under development and discussion before commercialization. The aim of this article is to review the studies on CFRC/GFRC recycling via pyrolysis processes and highlight their technical challenges and re-use possibilities in high performance composites. The forthcoming commercialization challenges and respective market potential to recyclates using the pyrolysis process will be addressed. This study will also introduce the strong connection between recycling and re-usability of fibres which would help to explain the concept of circular economy and cradle-to-cradle approach. Finally, based on updated studies and critical analysis, research gaps in the recycling treatments of fibrous composite waste using pyrolysis processes are discussed with recommendations.

No abstract

No abstract

No abstract

No abstract

No abstract