No abstract

No abstract

Plants of the Digitalis genus contain a cocktail of cardenolides commonly prescribed to treat heart failure. Cardenolides in Digitalis extracts have been conventionally quantified by highperformance liquid chromatography yet the lack of structural information compounded with possible co-eluents renders this method insufficient for analyzing cardenolides in plants. The goal of this work is to structurally characterize cardiac glycosides in fresh-leaf extracts using liquid chromatography coupled with tandem mass spectrometry (LC/MS/MS) that provides exact masses. Fragmentation of cardenolides is featured by sequential loss of sugar units while the steroid aglycon moieties undergo stepwise elimination of hydroxyl groups, which distinguishes different aglycones. The sequence of elution follows diginatigenin digoxigenin gitoxigenin gitaloxigenin digitoxigenin for cardenolides with the same sugar units but different aglycones using a reverse-phase column. A linear range of 0.8-500 ng g -1 has been achieved for digoxigenin, β -acetyldigoxin, and digitoxigenin with limits of detection ranging from 0.09 to 0.45 ng g -1 . A total of 17 cardenolides have been detected with lanatoside A, C, and E as major cardenolides in Digitalis lanata while 7 have been found in Digitalis purpurea including purpurea glycoside A, B, and E. Surprisingly, glucodigifucoside in D. lanata and verodoxin and digitoxigenin fucoside in D. purpurea have also been found as major cardenolides. As the first MS/MS-based method developed for analyzing cardenolides in plant extracts, this method serves as a foundation for complete identification and accurate quantification of cardiac glycosides, a necessary step towards understanding the biosynthesis of cardenolide in plants..

Fluorine nuclear magnetic resonance (19F-NMR) spectroscopy has been shown to be a powerful tool capable of quantifying the total per- and polyfluoroalkyl substances (PFAS) in a complex sample. The technique relies on the characteristic terminal −CF3 shift (−82.4 ppm) in the alkyl chain for quantification and does not introduce bias due to sample preparation or matrix effects. Traditional quantitative analytical techniques for PFAS, such as liquid chromatography–mass spectrometry (LC-MS) and combustion ion chromatography (CIC), contain inherent limitations that make total fluorine analysis challenging. Here, we report a sensitive 19F-NMR method for the analysis of total PFAS, with a limit of detection of 99.97 nM, or 50 μg/L perfluorosulfonic acid. To demonstrate the capabilities of 19F-NMR, the technique was compared to two commonly used methods for PFAS analysis: total oxidizable precursor (TOP) assay and LC-high resolution MS analysis for targeted quantification and suspect screening. In both cases, the 19F-NMR analyses detected higher total PFAS quantities than either the TOP assay (63%) or LC-MS analyses (65%), suggesting that LC-MS and TOP assays can lead to underreporting of PFAS. Importantly, the 19F-NMR detected trifluoroacetic acid at a concentration more than five times the total PFAS concentration quantified using LC-MS in the wastewater sample. Therefore, the use of 19F-NMR to quantify the total PFAS in highly complex samples can be used to complement classic TOP or LC-MS approaches for more accurate reporting of PFAS contamination in the environment.

Land application of treated sewage sludge (also known as biosolids) is considered a sustainable route of disposal because it reduces waste loading into landfills while improving soil health. However, this waste management practice can introduce contaminants from biosolids, such as per- and polyfluoroalkyl substances (PFAS), into the environment. PFAS have been observed to be taken up by plants, accumulate in humans and animals, and have been linked to various negative health effects. There is limited information on the nature and amounts of PFAS introduced from biosolids that have undergone different treatment processes. Therefore, this study developed analytical techniques to improve the characterization of PFAS in complex biosolid samples. Different clean-up techniques were evaluated and applied to waste-activated sludge (WAS) and lime-stabilized primary solids (PS) prior to targeted analysis and suspect screening of biosolid samples. Using liquid chromatography with high-resolution mass spectrometry, a workflow was developed to achieve parallel quantitative targeted analysis and qualitative suspect screening. This study found that concentrations of individual PFAS (27 targeted analytes) can range from 0.6 to 84.6 ng/g in WAS (average total PFAS = 241.4 ng/g) and from 1.6 to 33.8 ng/g in PS (average total PFAS = 72.1 ng/g). The suspect screening workflow identified seven additional PFAS in the biosolid samples, five of which have not been previously reported in environmental samples. Some of the newly identified compounds are a short-chain polyfluorinated carboxylate (a PFOS replacement), a diphosphate ester (a PFOA precursor), a possible transformation product of carboxylate PFAS, and an imidohydrazide which contains a sulfonate and benzene ring.