The sensitive determination of hydrogen peroxide has broad analytical applications. In this work, a novel non-enzymatic hydrogen peroxide sensor based on Pt nanoparticles (PtNPs) electrochemically deposited on previously modified and activated screen-printed carbon electrodes (aSPCEs) was constructed. The pretreatment consisted of subjecting the electrodes to a surface activation treatment with hydrogen peroxide followed by the electrodeposition of poly(azure A) films (PAA) in a sodium dodecyl sulfate micellar aqueous solution. The PtNPs/PAA/aSPCEs were characterized by scanning electron microscope, X-Ray photoelectron spectrometry, linear scan voltammetry and electrochemical impedance spectroscopy. Linear sweep voltammograms showed that the oxidation peak potential of H2O2 shifts from ~1 V at SPCEs to ~0.1 V at PtNPs/PAA/aSPCEs. The fabricated electrodes showed excellent electrocatalytic activity towards H2O2 oxidation, making its detection possible at 0.1 V. The detection limit was 51.6 nM, which is significantly lower than other modified electrodes found in the literature, and the linear range ranging from 0 to 300 µM. The proposed electrode was successfully applied to the determination of H2O2 in real samples in different areas. Additional experiments against common interfering agents (ascorbic acid, dehydroascorbic acid, glucose, salicylic acid, among other compounds) showed no increase in the current signal and only in the case of ascorbic acid a small interference, not greater than 10% is observed, which indicates high specificity of the sensor. These electrodes open up alternative avenues for the development of highly sensitive, robust and low cost electrochemical H2O2 sensors for field tests.

Herein, a novel electrochemical glucose biosensor based on glucose oxidase (GOx) immobilized on a surface containing platinum nanoparticles (PtNPs) electrodeposited on poly(Azure A) (PAA) previously electropolymerized on activated screen-printed carbon electrodes (GOx-PtNPs-PAA-aSPCEs) is reported. The resulting electrochemical biosensor was validated towards glucose oxidation in real samples and further electrochemical measurement associated with the generated H2O2. The electrochemical biosensor showed an excellent sensitivity (42.7 μA mM−1 cm−2), limit of detection (7.6 μM), linear range (20 μM–2.3 mM), and good selectivity towards glucose determination. Furthermore, and most importantly, the detection of glucose was performed at a low potential (0.2 V vs. Ag). The high performance of the electrochemical biosensor was explained through surface exploration using field emission SEM, XPS, and impedance measurements. The electrochemical biosensor was successfully applied to glucose quantification in several real samples (commercial juices and a plant cell culture medium), exhibiting a high accuracy when compared with a classical spectrophotometric method. This electrochemical biosensor can be easily prepared and opens up a good alternative in the development of new sensitive glucose sensors.

14Soil has been utilized in criminal investigations for some time because of its prevalence and 15 transferability. It is usually the physical characteristics that are studied, however the research