No abstract

Salt is one of the most widely used additives in food industries because of its low cost and varied properties. It has a preservative and antimicrobial effect as a direct consequence of the capacity of sodium chloride to reduce water activity values. In addition, sodium chloride is a flavour enhancer as a consequence of its effect on different biochemical mechanisms. It also has flavour enhancing effects from reducing or enhancing the enzymatic activity of some enzymes responsible for the development of different organoleptic parameters. Trends in sodium chloride use in food industries point to salt replacement or reduction by means of the use of sodium chloride substitutes such as KCl or phosphates; flavour enhancers and the optimisation of the physical form of salt. This trend has arisen as a result of the greater awareness of the negative effects of excess dietary intake of sodium, which has been linked to hypertension and consequently an increased risk of cardiovascular disease. The average total daily sodium intake per individual in developed countries is 4-5 g of Na, which is up to 25 times greater than the minimum adult requirement. KeywordsProtein behaviour, salt effect, salt in foods, salting, water-holding capacity.

No abstract

No abstract

No abstract

No abstract

No abstract

A technique was developed to predict the freshness of packaged sliced chicken breast employing a nondestructive visible and short-wavelength near infrared (SW-NIR) spectroscopy method. Spectra were recorded at 0, 7 and 14 days using a camera, spectral filter (400-1000 nm) and a halogen flood lighting system which were developed and calibrated for the purpose. Physicochemical, biochemical and microbiological properties such as moisture (x w ), water activity (a w ), pH, total volatile basic nitrogen (TVB-N), ATP breakdown compounds (K 1 values) and mesophilic bacteria (cfu g -1 ) were determined to predict freshness degradation. The spectra obtained were related to the storage time of the samples. The best wavelengths for modeling freshness were 413, 426, 449, 460, 473, 480, 499, 638, 942, 946, 967, 970 and 982 nm. A linear correlation was found between the visible and SW-NIR spectroscopy and parameters such as microbiological counts, K 1 and T-VBN indexes.