Mandibular reconstruction with fibula flap shows a 3D discrepancy between the fibula and the remnant mandible. Eight patients underwent three-dimensional reconstruction of the fibula flap with iliac crest graft and dental implants through virtual surgical planning (VSP), stereolitographic models (STL) and CAD/CAM titanium mesh. Vertical ridge augmentation and horizontal dimensions of the fibula, peri-implant bone resorption of the iliac crest graft, implant success rate and functional and aesthetic results were evaluated. Vertical reconstruction ranged from 13.4 mm to 10.1 mm, with an average of 12.22 mm. Iliac crest graft and titanium mesh were able to preserve the width of the fibula, which ranged from 8.9 mm to 11.7 mm, with an average of 10.1 mm. A total of 38 implants were placed in the new mandible, with an average of 4.75 ± 0.4 implants per patient and an osseointegration success rate of 94.7%. Two implants were lost during the osseointegration period (5.3%). Bone resorption was measured as peri-implant bone resorption at the mesial and distal level of each implant, with a variation between 0.5 mm and 2.4 mm, and with a mean of 1.43 mm. All patients were rehabilitated with a fixed implant prosthesis with good aesthetic and functional results.

Double-barrel flap, vertical distraction and iliac crest graft are used to reconstruct the vertical height of the fibula. Twenty-four patients with fibula flap were reconstructed comparing these techniques (eight patients in each group) in terms of height of bone, bone resorption, implant success rate and the effects of radiotherapy. The increase in vertical bone with vertical distraction, double-barrel flap and iliac crest was 12.5 ± 0.78 mm, 18.5 ± 0.5 mm, and 17.75 ± 0.6 mm, (p < 0.001). The perimplant bone resorption was 2.31 ± 0.12 mm, 1.23 ± 0.09 mm and 1.43 ± 0.042 mm (p < 0.001), respectively. There were significant differences in vertical bone reconstruction and bone resorption between double-barrel flap and vertical distraction and between iliac crest and vertical distraction (p < 0.001). The study did not show significant differences in implant failure (p = 0.346). Radiotherapy did not affect vertical bone reconstruction (p = 0.125) or bone resorption (p = 0.237) but it showed higher implant failure in radiated patients (p = 0.015). The double-barrel flap and iliac crest graft showed better stability in the height of bone and less bone resorption and higher implant success rates compared with vertical distraction. Radiation therapy did not affect the vertical bone reconstruction but resulted in a higher implant failure.

IntroductionVertical discrepancy between the fibula flap and the native mandible results in difficult prosthetic rehabilitation. The aim of this study was to evaluate the outcomes of 3D reconstruction of the mandible in oncologic patients using three different techniques through virtual surgical planning (VSP), cutting guides, customized titanium mesh and plates with CAD/CAM technology, STL models and intraoperative dynamic navigation for implant placement. Material and methodsMaterial and MethodsThree different techniques for mandibular reconstruction and implant rehabilitation were performed in 14 oncologic patients. Five patients (36%) underwent VSP, cutting guides, STL models and a customized double-barrel titanium plate with a double-barrel flap and immediate implants. In six patients (43%), VSP, STL models and a custom-made titanium mesh (CAD/CAM) for 3D reconstruction with iliac crest graft over a fibula flap with deferred dental implants were performed. Three patients (21%) underwent VSP with cutting guides and customized titanium plates for mandibular reconstruction and implant rehabilitation using intraoperative dynamic navigation was accomplished. Vertical bone reconstruction, peri-implant bone resorption, implant success rate, effects of radiotherapy in vertical reconstruction, bone resorption and implant failure, mastication, aesthetic result and dysphagia were evaluated.ResultsSignificant differences in bone growth between the double-barrel technique and iliac crest graft with titanium mesh technique were found (p&lt;0.002). Regarding bone resorption, there were no significant differences between the techniques (p=0.11). 60 implants were placed with an osseointegration rate of 91.49%. Five implants were lost during the osseointegration period (8%). Peri-implant bone resorption was measured with a mean of 1.27 mm. There was no significant difference between the vertical gain technique used and implant survival (p&gt;0.385). Implant survival rates were higher in non-irradiated patients (p&lt;0.017). All patients were rehabilitated with a fixed implant-supported prosthesis reporting a regular diet (80%), normal swallowing (85.7%) and excellent aesthetic results.ConclusionsMulti-stage implementation of VSP, STL models and cutting guides, CAD/CAM technology, customized plates and in-house dynamic implant navigation for mandibular defects increases bone-to-bone contact, resolves vertical discrepancy and improves operative efficiency with reduced complication rates and minimal bone resorption. It provides accurate reconstruction that optimizes implant placement, thereby improving facial symmetry, aesthetics and function.

The aim of this study is to evaluate the functional outcomes and quality of life (QoL) in oncologic patients with intraoral defects reconstructed with the buccinator myomucosal flap. A retrospective study was performed involving 39 patients with intraoral soft-tissue defects, reconstructed with a buccinator myomucosal flap during a six-year period. Patients completed the European Organization for Research and Treatment of Cancer questionnaires, the standard questionnaire (QLQ-C30) and the head-and-neck specific module (QLQ-H&N35). Thirty-nine patients with a mean age of 61.23 ± 15.80 years were included in the study. Thirty-three patients were diagnosed with an oncological condition (84.61%). Six patients (15.38%) developed orosinusal communication and underwent extensive debridement. The median global-health-status score was 79.27 and emotional performance was the lowest scoring, with a mean score of 76.93. As for the symptom items, the most outstanding were dental problems (33.33), oral opening (31.62) and dry mouth (37.61), followed by sticky saliva (24.79), problems with social eating (21.15) and pain (19.87). The most significant symptoms were radiotherapy-related adverse effects such as pain, fatigue, dental problems and dry mouth. Patients reconstructed with the buccinator myomucosal flap develop a good quality of life for all types of activities, and a correct function and aesthetics. Postoperative radiotherapy is associated with a poorer quality of life, and can lead to impairment of several symptoms such as swallowing, oral opening and dry mouth.

Optimal functional outcomes in oncologic patients with squamous cell carcinoma (SCCA) of the tongue and floor of the mouth require good lingual mobility, adequate facial competence, the cheek suction effect and dental rehabilitation with osseointegrated implants. In this study, twenty-two oncologic patients who had been diagnosed with intraoral SCCA affecting the tongue and the floor of the mouth and who had undergone wide resection of the tumor and immediate reconstruction with an inferiorly pedicled FAMM flap and immediate osseointegrated implants were assessed. Lingual mobility, speech articulation, deglutition, implant success rate, mouth opening, and aesthetic results were evaluated. All patients were staged as T2 and the defect size ranged from 3.7 × 2.1 cm to 6.3 × 4.2 cm. A selective neck dissection was performed in all patients as part of their oncologic treatment, either electively or for node positive disease. Thirteen patients (59%) were diagnosed with node positive disease and underwent adjuvant radiotherapy. A total of 101 osseointegrated implants were placed for prosthetic rehabilitation and 8 implants were lost (7.9%), of which 7 received radiotherapy (87.5%). The implant success rate was 92.1%. Mouth opening was reported as normal in 19 patients (86.3%). Tongue tip elevation was reported as excellent in 19 patients (86.3%) and good in 3 patients (13.6%). Lingual protrusion was referred to as excellent in 15 patients (68.2%) and good in 6 patients (27.2%). Lateral excursion was reported as excellent in 14 patients (63.6%) and good in 7 patients (31.8%). In terms of speech articulation, 20 patients reported normal speech (90.9%). Regarding deglutition, 19 patients (86.3%) reported a regular diet while a soft diet was reported by 3 patients (13.7%). Aesthetic results were referred to as excellent in 17 patients (77.3%). FAMM flaps, immediate implants and fixed prostheses enable the functional rehabilitation of oncologic patients, optimizing aesthetics and functional outcomes even in patients undergoing irradiation, thus returning oncologic patients to an excellent quality of life.

No abstract

Intraosseous venous malformations affecting the zygomatic bone are infrequent. Primary reconstruction is usually accomplished with calvarial grafts, although the use of virtual surgical planning, cutting guides and patient-specific implants (PSI) have had a major development in recent years. A retrospective study was designed and implemented in patients diagnosed with intraosseous venous malformation during 2006–2021, and a review of the scientific literature was also performed to clarify diagnostic terms. Eight patients were treated, differentiating two groups according to the technique: four patients were treated through standard surgery with resection and primary reconstruction of the defect with calvarial graft, and four patients underwent resection and primary reconstruction through virtual surgical planning (VSP), cutting guides, STL models developed with CAD-CAM technology and PSI (titanium or Polyether-ether-ketone). In the group treated with standard surgery, 75% of the patients developed sequelae or morbidity associated with this technique. The operation time ranged from 175 min to 210 min (average 188.7 min), the length of hospital ranged from 4 days to 6 days (average 4.75 days) and the postoperative CT scan showed a defect surface coverage of 79.75%. The aesthetic results were “excellent” in 25% of the patients, “good” in 50% and “poor” in 25%. In the VSP group, 25% presented sequelae associated with surgical treatment. The operation time ranged from 99 min to 143 min (average 121 min), the length of hospital stay ranged from 1 to 2 days (average of 1.75 days) and 75% of the patients reported “excellent” results. Postoperative CT scan showed 100% coverage of the defect surface in the VSP group. The multi-stage implementation of virtual surgical planning with cutting guides, STL models and patient-specific implants increases the reconstructive accuracy in the treatment of patients diagnosed with intraosseous venous malformation of the zygomatic bone, reducing sequelae, operation time and average hospital stay, providing a better cover of the defect, and improving the precision of the reconstruction and the aesthetic results compared to standard technique.

intracutaneous suture techniques in Asian patients, which may help to obtain better scar outcome. After this modified combined sill and alar excision, the mean ratio of interalar distance to intercanthal distance changed significantly from preoperative 1.10 to postoperative 1.02. Before the surgery, there were 16 cases (30.8%) of horizon-shaped nostrils. After the surgery, the frequency significantly decreased to 2 cases (4.8%). The frequency of the pearshaped nostrils improved significantly from preoperative 15 cases (28.8%) to postoperative 26 cases (50.0%). The frequency of circular-shaped nostrils changed insignificantly from preoperative 21 cases (40.4%) to postoperative 24 cases (46.2%). These outcomes demonstrated our modified combined sill and alar excision could successfully narrow the wide nasal base and correct the alar flare. The shape of nostrils improved in most cases after the surgery. Some patients obtained no improvement of the shape of nostrils, which deserved further clinical exploration.Although the results of alar base excision are satisfying, we did not consider it as a routine surgery. Since the width of the nasal base and alar flare are directly affected by nasal tip projection and tip rotation. Alar width and flare would decrease following an increasing nasal tip projection due to a ''tent effect.'' 3 Some surgeons are not willing to perform such surgery in case of producing unnatural results or obvious scarring. We created the alar incision along the alar-facial groove and sutured the incision with intracutaneous suture techniques, which produced unnoticeable scar and could well hide the scar in the depth of the natural alar crease. This location of incision was in contrast with previous studies, which described the incision be placed above the crease to avoid crease obliteration. 12,14-16 However, obvious scar paralleled to the alar crease may be observed with this incision above the crease. For patients with wide alar base and without alar flare, we performed the alar excision with the incision located in the groove and closed the incision with intracutaneous suture techniques. The results were gratifying since the scar was well hidden and unobvious.One limitation in this current study is that it is a retrospective cohort study. There is no comparison group with incision above the crease, or with transcutaneous suture of incision, which can gain the strength of the study evidence. Therefore, a well-designed prospective study is needed to further investigate this issue. CONCLUSIONSWhen it is necessary to correct wide alar base and flare in Asian patients, we recommend a modified procedure with the incision for alar excision being placed in the alar-facial groove and closed by intracutaneous suture. This modified approach can obtain good scar outcomes and improve the shape of nostrils simultaneously.