Red blood cells (RBCs) in microchannels has tendency to undergo axial migration due to the parabolic velocity profile, which results in a high shear stress around wall that forces the RBC to move towards the centre induced by the tank treading motion of the RBC membrane. As a result there is a formation of a cell free layer (CFL) with extremely low concentration of cells. Based on this phenomenon, several works have proposed microfluidic designs to separate the suspending physiological fluid from whole in vitro blood. This study aims to characterize the CFL in hyperbolic-shaped microchannels to separate RBCs from plasma. For this purpose, we have investigated the effect of hyperbolic contractions on the CFL by using not only different Hencky strains but also varying the series of contractions. The results show that the hyperbolic contractions with a Hencky strain of 3 and higher, substantially increase the CFL downstream of the contraction region in contrast with the microchannels with a Hencky strain of 2, where the effect is insignificant. Although, the highest CFL thickness occur at microchannels with a Hencky strain of 3.6 and 4.2 the experiments have also shown that cells blockage are more likely to occur at this kind of microchannels. Hence, the most appropriate hyperbolic-shaped microchannels to separate RBCs from plasma is the one with a Hencky strain of 3.
Several studies have already demonstrated that it is possible to perform blood flow studies in microfluidic systems fabricated by using low-cost techniques. However, most of these techniques do not produce microchannels smaller than 100 microns and as a result they have several limitations related to blood cell separation. Recently, manufacturers have been able to produce milling tools smaller than 100 microns, which consequently have promoted the ability of micromilling machines to fabricate microfluidic devices able to perform separation of red blood cells (RBCs) from plasma. In this work, we show the ability of a micromilling machine to manufacture microchannels with dimensions down to 30 microns. Additionally, we show for the first time the ability of the proposed microfluidic device to enhance the cell-free layer close to the walls, leading to perform partial separation of RBCs from plasma.
The most common and used technique to produce microfluidic devices for biomedical applications is the soft-lithography. However, this is a high cost and time-consuming technique. Recently, manufacturers were able to produce milling tools smaller than 100 m and consequently have promoted the ability of the micromilling machines to fabricate microfluidic devices capable of performing cell separation. In this work, we show the ability of a micromilling machine to manufacture microchannels down to 30 m and also the ability of a microfluidic device to perform partial separation of red blood cells from plasma. Flow visualization and measurements were performed by using a high-speed video microscopy system. Advantages and limitations of the micromilling fabrication process are also presented.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.