The number of disabled individuals due to stroke is increasing day by day and is projected to continue increasing at an alarming rate in United States. But the current amount of health professionals in physical therapy is inadequate to provide rehabilitation to these large groups. From early 1990s, researchers have been trying to develop an easy and feasible solution to this problem and lot of assistive devices both end effector type or exoskeleton type have been developed till to date. However, only a few of them have been commercialized and are being used in rehabilitation of post-stroke patients. Making the use of exoskeletons and other devices to regain lost motor function is rare. Providing therapy to this large group is quite impossible without commercializing of exoskeleton. This has motivated the authors to make a literature review and figure the reasons out that need to be solved to bridge the gap between research prototype to commercial version. This paper covers the necessity of incorporating robotic devices in rehabilitation, a brief description of existing devices particularly upper limb exoskeletons, their hardware limitations, and control issues. Our review shows that there are significant flaws in hardware design and developing control algorithm of exoskeletons to be available in rehabilitation program.

SummaryThis paper presents an advanced robust active disturbance rejection control (ADRC) for flexible link manipulator (FLM) to track desired trajectories in the joint space and minimize the link’s vibrations. It has been shown that the ADRC technique has a very good disturbance rejection capability. Both the internal dynamics and the external disturbances can be estimated and compensated in real time. The proposed robust ADRC control law is developed to solve the problems existing in the original version of the ADRC related to the disturbance estimation errors and the variation of the parameters. Indeed, these parameters cannot be included in the existing disturbances and then be estimated by the extended state observer. The proposed control law is based on the sliding mode technique, which considers the uncertainties in the control gains and disturbance estimation errors. Lyapunov theory is used to prove the closed-loop stability of the system. The proposed control strategy is simulated and tested experimentally on one FLM. The effect of the observer bandwidth on the system performance is simulated and studied to select the best values of the bandwidth frequency. The simulation and experimental results show that the proposed robust ADRC has better performance than the traditional ADRC.

No abstract

The traditional trade-off between execution speed and path quality has forced real-time robotic path planning algorithms to sacrifice path quality in order to execute in real-time. Producing a path planning algorithm that targets enhancing both, the path quality and swiftness is a challenging problem. However, this article proposes a novel path planning strategy that aims to break this traditional trade-off, by targeting both, increasing the swiftness, and enhancing the path quality represented by the path length and smoothness. The proposed strategy is based on the observation that most path planning algorithms waste the processing efforts in less critical areas of the map. Therefore, the proposed path planning strategy tends to focus on critical areas such as the areas around obstacles and areas around the goal point, and exhausts the processing power on these critical areas. This is done by neglecting all static obstacles that do not lie between the robot and the destination. For obstacles that intersect with the linear line from the robot to the destination, a basis traditional path planning algorithm such as A*, D* or the Probabilistic RoadMap (PRM) technique is only implemented around the obstacles in order to find a feasible path around each selected obstacle. This procedure would minimize the computational efforts compared to applying the basis algorithm on the whole map. Finally, the path quality is enhanced by finding any linear shortcuts between any two points in the path and fix these shortcuts as the final path from the starting point to the goal point. The proposed path planning strategy was tested on a P3-DX Pioneer mobile robot using a kinematic controller. The experimental results have proven that the path planning strategy was able to show a superior advantage over other path planning techniques in both aspects, computational time (reached up to 97.05% improvement) and path quality (reached up to 16.21% improvement for path length and 98.50% for smoothness).

SUMMARYThis paper presents an adaptive distributed control strategy for n-serial-flexible-link manipulators. The proposed adaptive controller is used for flexible-link-manipulators: (1) to solve the tracking control problem in the joint space, and (2) to reduce vibrations of the links. The dynamical model of flexible link manipulators is reorganized to take the form of n interconnected subsystems. Each subsystem has a one-joint and one-link pair. The system parameters are deemed to be unknown. The adaptive distributed strategy controls one subsystem in each step, starting from the last one. The nth subsystem is controlled by assuming that the remaining subsystems are stable. Then, proceeding backward to the (n-1)th system, the same strategy is applied, and so on, until the first subsystem is reached. The gradient-based estimator is used to estimate the parameters of each subsystem. The control law of the ith subsystem uses its own estimated parameters and the estimated parameters of all upper level subsystems. The global stability of the error dynamics is proved using Lyapunov approach. This algorithm was implemented in real time on a two-flexible-link manipulator, and a comparison with the non-adaptive version shows the effectiveness of this approach.