Background/aims Erythropoiesis in long‐term hemodialyzed (LTH) patients is supported by erythropoietin (rHuEpo) and intravenous (IV) iron. This treatment may end up in iron overload (IO) in major organs. We studied such patients for the parameters of IO in the serum and in major organs. Methods Patients were treated with rHuEpo (6–8 x 103 units × 1–3/wk) and IV 100 mg ferric saccharate. Results Of 115 patients, 21 had serum ferritin (SF) > 1000 ng/mL. This group was further analyzed. Their SF and transferrin saturation (TSAT) were 2688 ± 1489 ng/mL and 54.2 ± 32.7%, respectively (vs. 125–360 ng/mL and 20–50% in normal controls). Serum hepcidin was 60.1 ± 29.5 nm (vs. 10.61 ± 6.44 nm in controls) (P < 0.001). Nineteen patients had increased malonyldialdehyde, a product of lipid peroxidation, indicating oxidative stress. T2* MRI disclosed in 19 of 21 patients moderate to severe IO in the liver and spleen, in three of eight patients in the pancreas, but in no patient in the heart. After stopping IV iron for a mean of 12 months, while continuing rHuEpo, the mean SF decreased in 11 patients to 1682 ng/mL and the mean TSAT decreased to 28%, whereas hemoglobin did not change indicating that tissue iron was utilized. Conclusion High SF correlates with IO in the liver and spleen, but not in the heart.

These guidelines provide information on how to develop and manage a point-of-care (POCT) service so that reliable haematology results are produced regardless of where the test is performed. Many of the issues addressed here are relevant to POCT within hospitals or health centres; however, the principles are equally applicable to care in the community and doctors' offices. Other aspects discussed in this guideline are the initiation of the service (including indications for and limitations of a POCT service), staff training, type of haematology equipment selected, the blood results, monitoring of quality, accreditation, safety and cost. Equipment selected should generate results that are comparable to those of the local reference laboratory. If a complete independent evaluation of the POCT device has not been performed, the purchaser should perform a local assessment according to the protocol in this document. A literature search should also be undertaken to find independent peer reviewed evaluations on POCT equipment. Often the ideals discussed here may not be achievable in some developing countries but long-term training and education of POCT workers needs to be supported and constantly kept on government agendas to reach the recommendations advised here. Users should interpret these recommendations for their particular POCT needs and setting.

No abstract

Malaria diagnosis presents a challenge to all laboratories. There is a need for rapid, sensitive, and cost-effective screening on all samples, particularly in areas where malaria is endemic. Response to malaria infection involves an increased monocyte count and production of large activated monocytes. These changes can be detected by volume, conductivity, and scatter (VCS) technology on certain automated blood cell counters (Beckman Coulter, Miami, FL). The SD of the volume of lymphocytes and monocytes demonstrates a significant difference from normal when malaria is present. By using a calculation derived from the SD volume of the lymphocytes and monocytes, herein termed the malaria factor, sensitivity of 98% and specificity 94% were demonstrated for the detection of malaria. Based on this derived discriminant, VCS technology should become a useful tool in the detection of malaria. A flag to indicate the potential presence of malaria could then be generated by the instrument if the user or manufacturer chose to do so.

SummaryBackgroundThe cell population data (CPD) measured by Sysmex XN-9000 can be used for screening many hematological and non-hematological disorders. Since little information is available on harmonization of CPD among different instrumentation and clinical laboratories, this study aimed at assessing the current degree of CPD harmonization between separate Sysmex XN modules allocated to the same laboratory.MethodsA total number of 78291 data were used for verification of within-run imprecision, analyzers harmonization, reference ranges and assessment of blood sample stability of CPD parameters, including results of daily quality control testing and those generated in samples collected from blood donors and healthy volunteers.ResultsWithin-run imprecision of CPD parameters ranged between 0.4 and 14.1%. Good agreement was found among five different XN-modules, especially when values were adjusted after calculation of instrument-specific alignment factors. The bias of all parameters remained always lower than the reference change values in samples stored for up to 8 hours, regardless of storage temperature.ConclusionsThe imprecision of CPD parameters was acceptable, except for those reflecting the dispersion of cellular clusters. Due to the lack of reference control materials, we showed that the use of data generated on a large number of normal routine samples (i.e., a Moving Average population) may be a reliable approach for testing analyzers harmonization. Nevertheless, availability of both calibration and quality control materials for these parameters is highly advisable in the future. We finally showed that whole blood samples may be stable for up to 2–4 hours for most CPD parameters.