In this work, the particle jetting behavior in a blast-driven dense particle bed is studied at early times. Four-way coupled Euler–Lagrange simulations are performed using a high-order discontinuous Galerkin spectral element solver coupled with a high-order Lagrangian particle solver, wherein the inter-particle collisions are resolved using a discrete element method collision model. Following the experiments of Rodriguez et al. [“Formation of particle jetting in a cylindrical shock tube,” Shock Waves 23(6), 619–634 (2013)] and the simulations of Osnes et al. [“Numerical simulation of particle jet formation induced by shock wave acceleration in a Hele-Shaw cell,” Shock Waves 28(3), 451–461 (2018)], the simulations are performed in a quasi-two-dimensional cylindrical geometry (Hele-Shaw cell). Parametric studies are carried out to assess the impact of the coefficient of restitution and the strength of the incident shock on the particle jetting behavior. The deposition of vorticity through a multiphase (gas–particle) analog of Richtmyer–Meshkov instability is observed to play a crucial role in channeling the particles into well-defined jets at the outer edge of the particle bed. This is confirmed by the presence of vortex pairs around the outer jets. Furthermore, the effect of the relaxation of the relative velocity between the two phases on the vorticity generation is explored by analyzing the correlation between the radial velocity of particles and the radial velocity of the gas at the particle location.
This paper investigates the orthotropic properties of Fused Deposition Modeling (FDM)-printed Acrylonitrile Styrene Acrylate (ASA) material with different raster configurations. The elastic properties were determined using a non-destructive ultrasonic technique. This technique allows us to deduce the orthotropic elastic constants from the material density and the velocities of the longitudinal and shear waves propagating through the material along different directions. Tensile tests were performed in addition to ultrasonic tests to obtain the yield properties of the ASA material and to validate the elastic constants determined by the ultrasonic tests, which have shown very close correspondence. Finally, numerical verification was performed by comparing the experimental results of the three-point and four-point bending tests with the finite element simulation results which have as input the material properties from the ultrasonic testing. The simulation results have shown excellent agreement with the experimental results, implying that the material properties obtained from the ultrasonic testing were highly accurate comparing to the actual orthotropic elastic properties of the 3D-printed ASA material.
This paper investigates the differences in structural response of lightweight internal structures using finite element (FE) simulation to provide quantitative comparison of the advantages of each type of structure. Various configurations, corresponding to different amounts of weight savings, were studied under distributed pressure loading and bending moment loading conditions. It was found that for configurations with less weight savings, the kagome possesses better performance than the honeycomb structure. However, as the amount of weight savings increases, the trend was observed to be reversed, with the honeycomb structure providing much better performance than the kagome structure. In general, it was shown that the honeycomb structure possesses better performance than the kagome structure under cantilever loading conditions.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.