Previous findings suggest that performing strength training (ST) in the evening may provide greater benefit for young individuals. However, this may not be optimal for the older population. The purpose of this study was to compare the effects of a 12-week ST program performed in the morning vs. evening on strength, functional capacity, metabolic biomarker and basal hormone concentrations in older women. Thirty-one healthy older women (66 ± 4 years, 162 ± 4 cm, 75 ± 13 kg) completed the study. Participants trained in the morning (M) (07:30, n = 10), in the evening (E) (18:00, n = 10), or acted as a non-training control group (C) (n = 11). Both intervention groups performed whole-body strength training with 3 sets of 10-12 repetitions with 2-3 minutes rest between sets. All groups were measured before and after the 12-week period with; dynamic leg press and seated-row 6-repetition maximum (6-RM) and functional capacity tests (30-second chair stands and arm curl test, Timed Up and Go), as well as whole-body skeletal muscle mass (SMM) (kg) and fat mass (FM-kg, FM%) assessed by bioelectrical impedance (BIA). Basal blood samples (in the intervention groups only) taken before and after the intervention assessed low-density lipoprotein (LDL-C), high-density lipoprotein (HDL-C), blood glucose (GLU), triglycerides (TG), high-sensitive C-reactive protein (hsCRP) concentrations and total antioxidant status (TAS) after a 12 h fast. Hormone analysis included prolactin (PRL), progesterone (P) estradiol (ESTR), testosterone (T), follicle stimulating hormone (FSH), and luteinizing hormone (LH). While C showed no changes in any variable, both M and E significantly improved leg press (+ 46 ± 22% and + 21 ± 12%, respectively; p < 0.001) and seated-row (+ 48 ± 21% and + 42 ± 18%, respectively; p < 0.001) 6-RM, as well as all functional capacity outcomes (p < 0.01) due to training. M were the only group to increase muscle mass (+ 3 ± 2%, p < 0.01). Both M and E group significantly (p < 0.05) decreased GLU (-4 ± 6% and -8 ± 10%, respectively), whereas significantly greater decrease was observed in the E compared to the M group (p < 0.05). Only E group significantly decreased TG (-17 ± 25%, p < 0.01), whereas M group increased (+ 15%, p < 0.01). The difference in TG between the groups favored E compared to M group (p < 0.01). These results suggest that short-term "hypertrophic" ST alone mainly improves strength and functional capacity performance, but it influences metabolic and hormonal profile of healthy older women to a lesser extent. In this group of previously untrained older women, time-of-day did not have a major effect on outcome variables, but some evidence suggests that training in the morning may be more beneficial for muscle hypertrophy (i.e. only M significantly increased muscle mass and had larger effect size (M: g = 2 vs. E: g = 0.5).

Slovak bryndza" is a traditional Slovak cheese manufactured by milling a lump of matured ewe's cheese or by milling a mixture of lump ewe's cheese and lump cow's cheese. The percentage of lump ewe's cheese is greater than 50% w/w dry matter. Differences in the purchase prices of ewe's and cow's milk create the potential for adulteration. The detection of cow's milk compounds by isoelectric focusing of γ-caseins after plasmolysis is a suitable method for the determination of adulteration of this traditional cheese. The analysis and final results may be affected by factors affecting laboratory activity and biological factors. Biological factors are manifested primarily as variations in the casein content of ewe's and cow's milk. Despite this variation, this method may also be used for quantification purposes. We were able to establish a reliable calibration line from the internal reference materials prepared in our laboratory. The mean composition of Slovak bryndza cheese determined in our research was protein 18.7 ± 1.9 g 100 g −1 , fat 24.0 ± 1.8 g 100 g −1 , lactose 1.5 ± 1.9 g 100 g −1 , ash 4.5 ± 0.3 g 100 g −1 , fat in dry matter 49.3 ± 2.6 g 100 g −1 , casein 18.4 ± 1.9 g 100 g −1 , gamma casein 0.60 ± 0.19 g 100 g −1, and bovine-to-ovine gamma casein ratio 0.65 ± 0.12 g 100 g −1 .

This study aimed to evaluate the impact of selection on the genome structure of beef cattle through identification of selection signatures reflecting the breeding standard of each breed and to discover potential functional genetic variants to improve performance traits. Genotyping data of six beef breeds (Aberdeen Angus, Hereford, Limousin, Charolais, Piedmontese and Romagnola) were used to perform genome-wide scans for selection signatures. The approaches applied were based on an assumption that selection leads to linkage disequilibrium or to a decrease of genetic variability in genomic regions containing genotypes connected with favourable phenotypes. Thus, the selection signatures were analysed based on Wright’s F_ST index, distribution of runs of homozygosity segments in the beef genome and determination of linkage disequilibrium variability between breeds. The number and length of detected selection signals were different depending on the breeds and methodological approaches. As expected due to the breeding goals of analysed breeds, common signals were located on autosomes 2, 6, 7, 13 and 20 close to the genes associated with coat colour (KIT, KDR), muscle development (GDF9, GHRH, GHR), double muscling (MSTN), meat tenderness (CAST) and intramuscular fat content (SCD). But, across the genomes of analysed breeds, unique selection signals were found as well. The subsequent analysis of those single nucleotide polymorphism markers can be beneficial for the genetic progress of studied breeds in future.

The aim of this study was to examine possible usage of instrumental determination of selected texture parameters to estimate sensory texture acceptability of ketchups. Likewise, the authors focused on examination whether the consumer's perception of texture acceptability is connected to the selected factors related to the ingredients and production technology. Yet another aim was to describe the selected textural parameters of ketchups available in the European market. Within the frame of this study, 29 samples of ketchups were analyzed by means of instrumental and sensory texture analysis. Further, a survey research was carried out with the results showing that the texture was the second most significant parameter for the consumer's choice of a particular product. The average evaluation of sensory texture acceptability reached the values from 3.78 to 7.67. Analysis of the evaluation results of textural parameters based on the values of Pearson's correlation coefficient confirmed a high correlation (p < 0.05) between instrumental and sensory determined viscosity and density. However, none of these partial textural parameters affected the sensory acceptability of the texture separately. Thus, using the instrumental analysis for estimation of the sensory texture acceptability of ketchups is not possible. For the optimization and control of ketchup texture in practice, sensory analysis is essential.

The aim of this study was to test the reliability of commercial ELISA tests (RC-bovino) within raw and heat treated cow milk detection in sheep milk and cheese in order to obtain a high-quality, reliable and economically beneficial method suitable for routine application in practice. These tests were subsequently used for quantification of cow milk in commercial "Bryndza". Raw sheep milk, cow milk and heat-treated cow milk (pasteurisation at 72 °C for 15 sec or at 85 °C for 3 sec) were mixed in precisely defined proportions (0 -100% cow milk in sheep milk). The milk mixtures were sampled to detect adulteration and subsequently cheese was made. By ELISA tests was possible to determine these amounts of raw cow milk in sheep milk: 0.5% (0.2%), 5 % (4.81%), 50% (42.08%) and 75% (56.52%). The pasteurized samples in different combinations gave lower optical density responses than those prepared from raw milk (by approximately 60%). In context with the above mentioned, the relationship between the real and detected amount of cow milk (%) in different production stages (milk, cheese) using a regression analysis was examined. However, a lower reliability of the detection was indicated by R 2 values, which ranged from 0.4058 (cheese) to 0.5175 (milk). In practice this means that although individual percentage (%) of cow milk in the sample can be detected, but in the unknown sample it can not be clearly confirm whether the cow milk was raw or heat-treated. In this context, the results can be inaccurate and may not correspond to the real situation. Within monitoring phase of this research, 9 samples of bryndza were analysed with the results of detected cow milk ranged from 11.56% to 14.3%. The obtained results confirm that the appropriate selection of ELISA tests can become an important factor in the setting of analytical capabilities for the detection of milk and cheese adulteration.

Abstract. This study presents the application of BovineSNP50 BeadChip for genome-wide screening of two taurine breeds (Bos primigenius taurus) and Zebu (Bos primigenius indicus), and two species from the family Cervidae: red deer (Cervus elaphus) and fallow deer (Dama dama). The aim of the paper was to evaluate the use of bovine array for cross-species genotyping and analyse single nucleotide polymorphism (SNP) distribution, diversity within groups of animals and genetic distance among analysed species. The number of polymorphic SNPs decreased with the increase of phylogenetic distance between species, which also reflected a decrease in call rate (from 99.54 to 61.19 %). The minor allele frequency (MAF) values were significantly different between species and ranged from 0.18 ± 15 (Zebu) to 0.26 ± 0.14 (Pinzgau). The subsequent analyses of genetic diversity were based on the polymorphic loci detected in cervids. Differences in the expected heterozygosity was low (0.06), on average 0.34. In analysed groups the F IS values were close to zero, which suggested low SNP variance within them. The value of F IT indicated homozygote excess in evaluated individuals. Analysis of molecular variance revealed that most of the variability was distributed within all individuals. Observed genetic distances within and across groups of animals suggested that taurine cattle and cervids were more distant. The study results showed that genotyping array prepared for model species can be applied not only to organisms for which was developed, but can be also successfully used in closely related and more phylogenetically divergent species.

Deer (Cervidae) recently belongs to the most important species. The aim of presenting study was evaluation of genetic diversity and relationship within and among seven red deer populations from different origins - Czech Republic, Hungary, hybrids Hungary x New Zealand, Lithuania, New Zealand, Poland and Slovak Republic. This study was conducted to determine the levels of genetic variability and relationships among deer populations from a total of 637 animals originating from seven countries Czech Republic (50), Hungary (35), Hungary x New Zealand hybrids (67), Lithuania (26), New Zealand (82), Poland (347) and Slovak Republic (30).  We used the hair bulbs as a source of DNA.  In total, 213 alleles were observed from the 10 loci surveyed. The number of alleles per locus ranged from 11 (IOBT965) to 35 (T156, RT13). Genetic diversity and relatedness among red deer populations has been performed on a total of 637 animals. A panel of 10 microsatellite markers used in deer were optimized. On the basis of this panel of microsatellites we were investigated genetic variability and relationships by using statistical and graphical programmes. We evaluated how close populations are to each other and their genetic admixture. Molecular genetic data combined with evaluation in statistical programmes could lead to a complex view of populations.

The object of the research was to investigate the quality of vegetable oils for cooking food. The analysis used two types of oils - oil Fritol and Promienna. Both oils were purchased commercially. Oil changes were observed at frying French fries. At the same changes were observed oil stored at room temperature and the temperature in the refrigerator. The determined parameters included the measurement of polar materials in oil with electronic device Testo 265 for measuring the quality of cooking oil. Determination of change in the texture of oil during the oil deterioration by device Texturometer TA.XT Plus and determination the peroxide value by STN EN ISO 3960:2007. The work is also evaluating the results of the studied parameters. In all compared cases based on the content of the TPM showed higher heat resistance oil Fritol and sample of oil stored in the refrigerator.

doi:10.5219/210