No abstract

No abstract

Laser ignition is considered the prime alternative to conventional coil based ignition for improving efficiency and simultaneously reducing NOx emissions in lean-burn natural gas fired stationary reciprocating engines. In this paper, Argonne’s efforts towards the development of a viable laser ignition system are presented. The relative merits of various implementation strategies for laser based ignition are discussed. Finally, the performance improvements required for some of the components for successful field implementation are listed. Also reported are efforts to determine the relative merit of laser ignition over conventional Capacitance Discharge Ignition (CDI) ignition. Emissions and performance data of a large-bore single cylinder research engine are compared while running with laser ignition and the industry standard CDI system. It was primarily noticed that NOx emissions reduce by 50% under full load conditions with up to 65% reductions noticed under part load conditions. Also, the lean ignition limit was significantly extended and laser ignition improved combustion stability under all operating conditions. Other noticeable differences in combustion characteristics are also presented. Efforts wherein ignition was achieved while transmitting the high-power laser pulses through optical fibers showed performance improvements similar those achieved by using free-space laser ignition.

A thermodynamic simulation is used to study the effects of oxygen-enriched intake air on the performance and nitrogen oxide (NO) emissions of a locomotive diesel engine. The parasitic power of the air separation membrane required to supply the oxygen-enriched air is also estimated. For a given constraint on peak cylinder pressure, the gross and net power output of an engine operating under different levels of oxygen enrichment are compared with those obtained when a high-boost turbocharged engine is used. A 4% increase in peak cylinder pressure can result in an increase in net engine power of approximately 13% when intake air with an oxygen content of 28% by volume is used and fuel injection timing is retarded by 4 degrees. When the engine is turbocharged to a higher inlet boost, the same increase in peak cylinder pressure can result an improvement in power of only 4%. If part of the significantly higher exhaust enthalpies available as a result of oxygen enrichment are recovered, the power requirements of the air separator membrane can be met, resulting in substantial net power improvements. Oxygen enrichment with its attendant higher combustion temperatures, reduces emissions of particulates and visible smoke but increases NO emissions (by up to three times at 26% oxygen content). Therefore, exhaust gas after-treatment and heat recovery would be required if the full potential of oxygen enrichment for improving the performance of locomotive diesel engines is to be realized.

No abstract