In this study, a plasma electrolytic oxidation (PEO) process was used to produce oxide coatings on commercially pure aluminium (1100 alloy) at a pulsed dc power mode. The effects of process parameters (i.e. current density and treatment time) on the plasma discharge behaviour during the PEO treatment were investigated using optical emission spectroscopy (OES) in the visible and near ultraviolet (NUV) band (285–800 nm). The elements present in the plasma were identified. Stark shifts of spectral lines and line intensity ratios were utilized to determine the plasma electron concentrations and temperatures, respectively. The plasma electron temperature profile, coating surface morphology and coating composition were used to interpret the plasma discharging behaviour. The different coating morphologies and compositions at different coating surface regions are explained in terms of three types of discharge, which originate either at the substrate/coating interface, within the upper layer, or at the coating top layer. The high spike peaks on the plasma intensity and temperature profiles corresponded to discharges originated from the substrate/coating interface, while the base line and small fluctuations were due to discharges at the coating/electrolyte interface.

No abstract

Magnesium alloys are increasingly being used as lightweight materials in the automotive, defense, electronics, biomaterial and aerospace industries. However, their inherently poor corrosion and wear resistance have, so far, limited their application. Plasma electrolytic oxidation (PEO) in an environmentally friendly aluminates electrolyte has been used to produce oxide coatings with thicknesses of~80 μm on an AJ62 magnesium alloy. Optical emission spectroscopy (OES) in the visible and near ultraviolet (NUV) band (285 nm-800 nm) was employed to characterize the PEO plasma. Scanning electron microscopy (SEM) and X-ray diffraction (XRD) were used to characterize the coated materials, and potentiodynamic polarization and electrochemical impedance spectroscopy (EIS) in a 3.5% NaCl solution were used to determine the corrosion behavior. It was found that the plasma discharge behavior significantly influenced the microstructure and the morphology of the oxide coatings and, hence the corrosion resistance. The corrosion resistance of the coated alloy was increased by changing the current mode from unipolar to bipolar, where the strong plasma discharges had been reduced or eliminated.

No abstract

No abstract

No abstract

In this study, aluminum oxide was deposited on an Al alloy substrate to produce hard ceramic coatings using a plasma electrolytic oxidation (PEO) process working at atmospheric pressure. The process utilizes dc and unipolar pulsed dc in the frequency range 0.2–20 kHz. Optical emission spectroscopy was employed to study the species and electron temperature of the plasma. The morphology and microstructure of the coatings were investigated using scanning electron microscopy. It was found that in the first 12 min of the PEO process, the plasma electron temperature increased with the applied voltage during the experiments, the plasma electron temperature was found to be in the range 4000–9000 K, and the applied voltage to the electrodes ranged up to 550–600 V for the different current modes. The plasma temperature profile exhibits a wider peak temperature spike for the dc power mode than for the pulsed dc mode, indicating that the dc plasma discharges would provide longer sintering time. The pulsed dc mode increases the spike temperature up to 8700 K but does not necessarily enhance the coating growth. The high spike temperature generated by strong discharges likely melts the oxide and then traps gas into the melt pool, resulting in some porosity at the interface. By eliminating the high temperature spike, a denser interface layer and homogenous coating morphology are produced.

No abstract