A new fluorinated version of a cyclic β-aminoalcohol gelator derived from 1,2,3,4-tetrahydroisoquinoline is presented. The gelator is able to gel various nonprotic solvents through OH⋅⋅⋅N hydrogen bonds and additional CH⋅⋅⋅F interactions due to the introduction of fluorine. A bimolecular lamellar structure is formed in the gel phase, which partly preserves the pattern of molecular organization in the single crystal. The racemate of the chiral gelator shows lower gelation ability than its enantiomer because of a higher tendency to form microcrystals, as shown by X-ray diffraction analysis. The influence of fluorination on the self-assembly of the gelator and the properties of the gel was investigated in comparison to the original fluorine-free gel system. The introduction of fluorine brings two new features. The first is good recognition of o-xylene by the gelator, which induces an in situ transition from gels of o-xylene and of an o-xylene/toluene mixture to identical single crystals with unique tubular architecture. The second is the enhanced stability of the toluene gel towards ions, including quaternary ammonium salts, which enables the preparation of a stable toluene gel in the presence of chloroaurate or chloroplatinate. The gel system can be used as a template for the synthesis of spherical gold nanoparticles with a diameter of 5 to 9 nm and wormlike platinum nanostructures with a diameter of 2 to 3 nm and a length of 5 to 12 nm. This is the first example of a synthesis of platinum nanoparticles in an organogel medium. Therefore, the appropriate introduction of a fluorine atom and corresponding nonbonding interactions into a known gelator to tune the properties and functions of a gel is a simple and effective tactic for design of a gel system with specific targets.
As 3D printers become more widely available, researchers are able to rapidly produce components that may have previously taken weeks to have machined. The resulting plastic components, having high surface roughness, are often not suitable for high-precision optomechanics. However, by playing to the strengths of 3D printing-namely the ability to print complex internal geometries-it is possible to design monolithic mechanisms that do not rely on tight integration of high-precision parts. Here we present a motorised monolithic 3D-printed plastic flexure stage with sub-100 nm resolution, that can perform automated optical fibre alignment. *
The OpenFlexure Microscope is a 3D-printed laboratory-grade motorised microscope. Over the past 3 years, the microscope has primarily been co-developed between the University of Bath and the Tanzanian engineering company STICLab. We are beginning the process of preparing the microscope for medical certification, as an in-vitro diagnostic device. In this paper we detail the technical challenges of remote design of a complex scientific instrument. We believe that identifying and solving these issues is essential if we are to encourage research organisations in the Global North to design instrumentation with Africans, rather than "for Africa".
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.