About 6‐8 wt% yttria‐stabilized zirconia (YSZ) is the industry standard material for thermal barrier coatings (TBC). However, it cannot meet the long‐term requirements for advanced engines due to the phase transformation and sintering issues above 1200°C. In this study, we have developed a magnetoplumbite‐type SrAl12O19 coating fabricated by atmospheric plasma spray, which shows potential capability to be operated above 1200°C. SrAl12O19 coating exhibits large concentrations of cracks and pores (~26% porosity) after 1000 hours heat treatment at 1300°C, while the total porosity of YSZ coatings progressively decreases from the initial value of ~18% to ~5%. Due to the contribution of porous microstructure, an ultralow thermal conductivity (~1.36 W m−1 K−1) can be maintained for SrAl12O19 coating even after 1000 hours aging at 1300°C, which is far lower than that of the YSZ coating (~1.98 W m−1 K−1). In thermal cyclic fatigue test, the SrAl12O19/YSZ double‐ceramic‐layer coating undertakes a thermal cycling lifetime of ~512 cycles, which is not only much longer than its single‐layer counterpart (~163 cycles), but also superior to that of YSZ coating (~392 cycles). These preliminary results suggest that SrAl12O19 might be a promising alternative TBC material to YSZ for applications above 1200°C.

The model of a clamped-clamped Euler-Bernoulli beam is presented in order to study nonlinear vibration control of electrostatically actuated nanobeam with nanocapacitive sensor, considering primary and superharmonic resonances. The capacitance of nanobeam capacitor changes with the nanobeam deformation. The nanocapacitive sensor is applied to extract vibration signals and to transform enlarged signals into controller to control nanobeam vibrations. The method of multiple scales is used to obtain the first-order approximate solutions and derive the amplitude-frequency equation. The nonlinear vibration characteristics and amplitude-frequency response of nanobeam vibration system are studied under different excitation voltage, feedback gains, and damping. The relationships between amplitude and system parameters are discussed in detail. The presented analytical and numerical simulations show that dynamic response of nanobeam is stable when the appropriate parameters are chosen. This investigation provides a better understanding of the nonlinear vibration of nanoelectromechanical systems devices based on nanobeam.

This is the first report describing co-infection of Scedosporium apiospermum and Lichtheimia corymbifera caused by biogas inhalation in two people without underlying medical conditions. Two patients fell into the same pig manure pit at the same time while rescuing another patient (this person died in a few hours) and inhaled biogas. Both patients were diagnosed with pulmonary fungal disease and developed acute liver failure around Day 52. Their results were negative for the 1,3-β- d -glucan test and weakly positive for the galactomannan test. They were treated with amphotericin B and/or posaconazole without surgery. The patient in case 2 required amphotericin B deoxycholate aerosol inhalation to complete the treatment. Both patients recovered completely. For patients with mucormycosis confined to the lungs who cannot tolerate intravenous drip amphotericin B, increasing the dose of nebulised administration maybe a salvage regimen.

The nonlinear vibration effect of nanobeam and problem of the pull-in between the nanobeam and driven plate are the factors which prevent nano-resonator from improving the performance. The nonlinear governing differential equation is built by considering the axial force with piezoelectric controller. The piezoelectric time-delay electrostatic pull-in control is studied and the first-order approximate solution of nonlinear equation is gotten by using the method of multi-scale. The amplitude–frequency and phase frequency response equation of nonlinear vibration system are given for the primary resonance response of the nanobeam. The relationship between the control effect and feedback control parameters is studied. It is found that the piezoelectric time-delay control can change the critical voltage but not the critical position. The axial force can affect the performance of nanobeam.

A two-degree-of-freedom nonlinear vibration system of a quarter vehicle suspension system is studied by using the feedback control method considered the fractional-order derivative damping. The nonlinear dynamic model of two-degree-of-freedom vehicle suspension system is built and linear velocity and displacement controllers are used to control the nonlinear vibration of the vehicle suspension system. A case of the 1:1 internal resonance is considered. The amplitude–frequency response is obtained with the multiscale method. The asymptotic stability conditions of the nonlinear system can be gotten by using the Routh–Hurwitz criterion and the ranges of control parameters are gained in the condition of stable solutions to the system. The simulation results show that the feedback control can effectively reduce the amplitude of primary resonance, weaken or even eliminate the nonlinear vibration characteristics of the suspension system. Fractional orders have an impact on control performance, which should be considered in the control problem. The study will provide a theoretical basis and reference for the optimal design of the vehicle suspension system.