Impurity doping has been widely used to endow semiconductor nanocrystals with novel optical, electronic, and magnetic functionalities. Here, we introduce a new family of doped NCs offering unique insights into the chemical mechanism of doping, as well as into the fundamental interactions between the dopant and the semiconductor host. Specifically, by elucidating the role of relative bond strengths within the precursor and the host lattice, we develop an effective approach for incorporating manganese (Mn) ions into nanocrystals of lead-halide perovskites (CsPbX, where X = Cl, Br, or I). In a key enabling step not possible in, for example, II-VI nanocrystals, we use gentle chemical means to finely and reversibly tune the nanocrystal band gap over a wide range of energies (1.8-3.1 eV) via postsynthetic anion exchange. We observe a dramatic effect of halide identity on relative intensities of intrinsic band-edge and Mn emission bands, which we ascribe to the influence of the energy difference between the corresponding transitions on the characteristics of energy transfer between the Mn ion and the semiconductor host.

PbSe nanocrystal quantum dots (NQDs) are a promising active material for a range of optoelectronic devices, including solar cells, high-sensitivity infrared (IR) photodetectors, and IR-emitting diodes and lasers. However, device realization has been constrained by these NQDs' chemical instability toward oxidation, which leads to uncontrollable changes in optical and electronic properties. Here, we present a simple method to enhance the stability of PbSe NQDs against oxidation and to improve their optical properties through reaction with molecular chlorine. The chlorine molecules preferentially etch out surface Se ions and react with Pb ions to form a thin (1-2 monolayers) PbCl(x) passivation layer which effectively prevents oxidation during long-term air exposure while passivating surface trap states to increase photoluminescence efficiency and decrease photocharging. Our method is simple, widely applicable to PbSe and PbS NQDs of a range of sizes, compatible with solution-based processes for fabricating NQD-based devices, and effective both in solution and in solid NQD films; thus, it is a practical protocol for facilitating advances over the full range of optoelectronic applications.

One process limiting the performance of solar cells is rapid cooling (thermalization) of hot carriers generated by higher-energy solar photons. In principle, the thermalization losses can be reduced by converting the kinetic energy of energetic carriers into additional electron-hole pairs via carrier multiplication (CM). While being inefficient in bulk semiconductors this process is enhanced in quantum dots, although not sufficiently high to considerably boost the power output of practical devices. Here we demonstrate that thick-shell PbSe/CdSe nanostructures can show almost a fourfold increase in the CM yield over conventional PbSe quantum dots, accompanied by a considerable reduction of the CM threshold. These structures enhance a valence-band CM channel due to effective capture of energetic holes into long-lived shell-localized states. The attainment of the regime of slowed cooling responsible for CM enhancement is indicated by the development of shell-related emission in the visible observed simultaneously with infrared emission from the core.

The use of semiconductor nanocrystal quantum dots (QDs) in optoelectronic devices typically requires postsynthetic chemical surface treatments to enhance electronic coupling between QDs and allow for efficient charge transport in QD films. Despite their importance in solar cells and infrared (IR) light-emitting diodes and photodetectors, advances in these chemical treatments for lead chalcogenide (PbE; E = S, Se, Te) QDs have lagged behind those of, for instance, II-VI semiconductor QDs. Here, we introduce a method for fast and effective ligand exchange for PbE QDs in solution, resulting in QDs completely passivated by a wide range of small anionic ligands. Due to electrostatic stabilization, these QDs are readily dispersible in polar solvents, in which they form highly concentrated solutions that remain stable for months. QDs of all three Pb chalcogenides retain their photoluminescence, allowing for a detailed study of the effect of the surface ionic double layer on electronic passivation of QD surfaces, which we find can be explained using the hard/soft acid-base theory. Importantly, we prepare highly conductive films of PbS, PbSe, and PbTe QDs by directly casting from solution without further chemical treatment, as determined by field-effect transistor measurements. This method allows for precise control over the surface chemistry, and therefore the transport properties of deposited films. It also permits single-step deposition of films of unprecedented thickness via continuous processing techniques, as we demonstrate by preparing a dense, smooth, 5.3-μm-thick PbSe QD film via doctor-blading. As such, it offers important advantages over laborious layer-by-layer methods for solar cells and photodetectors, while opening the door to new possibilities in ionizing-radiation detectors.

A new nanocomposite formulation of the FeS-based anode for lithium-ion batteries is proposed, where FeS nanoparticles wrapped in reduced graphene oxide (RGO) are produced via a facile direct-precipitation approach. The resulting nanocomposite FeS@RGO structure has better lithium ion storage properties, exceeding those of FeS prepared without RGO sheets. The enhanced electrochemical performance is attributed to the robust sheet-wrapped structure with smaller FeS nanoparticles and synergetic effects between FeS and RGO sheets, such as increased conductivity, shortened lithium ion diffusion path, and the effective prevention of polysulfide dissolution.

The unique optical properties exhibited by visible emitting core/shell quantum dots with especially thick shells are the focus of widespread study, but have yet to be realized in infrared (IR)-active nanostructures. We apply an effective-mass model to identify PbSe/CdSe core/shell quantum dots as a promising system for achieving this goal. We then synthesize colloidal PbSe/CdSe quantum dots with shell thicknesses of up to 4 nm that exhibit unusually slow hole intraband relaxation from shell to core states, as evidenced by the emergence of dual emission, i.e., IR photoluminescence from the PbSe core observed simultaneously with visible emission from the CdSe shell. In addition to the large shell thickness, the development of slowed intraband relaxation is facilitated by the existence of a sharp core-shell interface without discernible alloying. Growth of thick shells without interfacial alloying or incidental formation of homogeneous CdSe nanocrystals was accomplished using insights attained via a systematic study of the dynamics of the cation-exchange synthesis of both PbSe/CdSe and the related system PbS/CdS. Finally, we show that the efficiency of the visible photoluminescence can be greatly enhanced by inorganic passivation.

Nanostructured MoO2/graphite oxide (GO) composites are synthesized by a simple solvothermal method. X-ray diffraction and transmission electron microscopy analyses show that with the addition of GO and the increase in GO content in the precursor solutions, MoO3 rods change to MoO2 nanorods and then further to MoO2 nanoparticles, and the nanorods or nanoparticles are uniformly distributed on the surface of the GO sheets in the composites. The MoO2/GO composite with 10 wt % GO exhibits a reversible capacity of 720 mAh/g at a current density of 100 mA/g and 560 mAh/g at a high current density of 800 mA/g after 30 cycles. The improved reversible capacity, rate capacity, and cycling performance of the composites are attributed to synergistic reaction between MoO2 and GO.

Hybrid superstructures allow a convenient route to the development of materials with multiple functionalities (e.g., sensor, marker, conductor) out of monofunctional (e.g., excitonic, plasmonic) building blocks. This work describes a general synthetic route to the preparation of metal|dielectric|quantum dot hybrid superstructures that have excitonic and plasmonic resonances independently tunable from the ultraviolet to the mid-infrared spectral region. We demonstrate that structural tuning can be used to control intercomponent coupling leading to the emergence of unique optical properties. We illustrate this capability by demonstrating single- and multicolor emission from coupled systems, and a significant enhancement of two-photon absorption cross sections of quantum dots. Such properties in a robust yet dispersible particle can be useful in a number of applications including bioimaging and microscopy, and in optoelectronic devices, as well as serve as a platform for fundamental studies of metal-semiconductor interactions.