Development of light-emitting diodes (LEDs) based on colloidal quantum dots is driven by attractive properties of these fluorophores such as spectrally narrow, tunable emission and facile processibility via solution-based methods. A current obstacle towards improved LED performance is an incomplete understanding of the roles of extrinsic factors, such as non-radiative recombination at surface defects, versus intrinsic processes, such as multicarrier Auger recombination or electron-hole separation due to applied electric field. Here we address this problem with studies that correlate the excited state dynamics of structurally engineered quantum dots with their emissive performance within LEDs. We find that because of significant charging of quantum dots with extra electrons, Auger recombination greatly impacts both LED efficiency and the onset of efficiency roll-off at high currents. Further, we demonstrate two specific approaches for mitigating this problem using heterostructured quantum dots, either by suppressing Auger decay through the introduction of an intermediate alloyed layer, or by using an additional shell that impedes electron transfer into the quantum dot to help balance electron and hole injection.

The influence of a CdSexS1-x interfacial alloyed layer on the photophysical properties of core/shell CdSe/CdS nanocrystal quantum dots (QDs) is investigated by comparing reference QDs with a sharp core/shell interface to alloyed structures with an intermediate CdSexS1-x layer at the core/shell interface. To fully realize the structural contrast, we have developed two novel synthetic approaches: a method for fast CdS-shell growth, which results in an abrupt core/shell boundary (no intentional or unintentional alloying), and a method for depositing a CdSexS1-x alloy layer of controlled composition onto the CdSe core prior to the growth of the CdS shell. Both types of QDs possess similar size-dependent single-exciton properties (photoluminescence energy, quantum yield, and decay lifetime). However the alloyed QDs show a significantly longer biexciton lifetime and up to a 3-fold increase in the biexciton emission efficiency compared to the reference samples. These results provide direct evidence that the structure of the QD interface has a significant effect on the rate of nonradiative Auger recombination, which dominates biexciton decay. We also observe that the energy gradient at the core-shell interface introduced by the alloyed layer accelerates hole trapping from the shell to the core states, which results in suppression of shell emission. This comparative study offers practical guidelines for controlling multicarrier Auger recombination without a significant effect on either spectral or dynamical properties of single excitons. The proposed strategy should be applicable to QDs of a variety of compositions (including, e.g., infrared-emitting QDs) and can benefit numerous applications from light emitting diodes and lasers to photodetectors and photovoltaics.

Cesium lead halide perovskite quantum dots (PQDs) have emerged as a promising new platform for lighting applications. However, to date, light emitting diodes (LED) based on these materials exhibit limited efficiencies. One hypothesized limiting factor is fast nonradiative multiexciton Auger recombination. Using ultrafast spectroscopic techniques, we investigate multicarrier interaction and recombination mechanisms in cesium lead halide PQDs. By mapping the dependence of the biexciton Auger lifetime and the biexciton binding energy on nanomaterial size and composition, we find unusually strong Coulomb interactions among multiexcitons in PQDs. This results in weakly emissive biexcitons and trions, and accounts for low light emission efficiencies. We observe that, for strong confinement, the biexciton lifetime depends linearly on the PQD volume. This dependence becomes sublinear in the weak confinement regime as the PQD size increases beyond the Bohr radius. We demonstrate that Auger recombination is faster in PQDs compared to CdSe nanoparticles having the same volume, suggesting a stronger Coulombic interaction in the PQDs. We confirm this by demonstrating an increased biexciton binding energy, which reaches a maximum of about 100 meV, fully three times larger than in CdSe quantum dots. The biexciton shift can lead to low-threshold optical gain in these materials. These findings also suggest that materials engineering to reduce Coulombic interaction in cesium lead halide PQDs could improve prospects for high efficiency optoelectronic devices. Core-shell structures, in particular type-II nanostructures, which are known to reduce the bandedge Coulomb interaction in CdSe/CdS, could beneficially be applied to PQDs with the goal of increasing their potential in lighting applications.

Cesium lead halide perovskite quantum dots (PQDs) have attracted significant interest for optoelectronic applications in view of their high brightness and narrow emission linewidth at visible wavelengths. A remaining challenge is the degradation of PQDs during purification from the synthesis solution.This is attributed to proton transfer between oleic acid and oleylamine surface capping agents that leads to facile ligand loss. Here, a new synthetic method is reported that enhances the colloidal stability of PQDs by capping them solely using oleic acid (OA). Quaternary alkylammonium halides are used as precursors, eliminating the need for oleylamine. This strategy enhances the colloidal stability of OA capped PQDs during purification, allowing us to remove excess organic content in thin films. Inverted red, green, and blue PQD light-emitting diodes (LED) are fabricated for the first time with solution-processed polymerbased hole transport layers due to higher robustness of OA capped PQDs to solution processing. The blue and green LEDs exhibit threefold and tenfold improved external quantum efficiency (EQE), respectively, compared to prior related reports for amine/ammonium capped cross-linked PQDs. The brightest blue LED based on all inorganic CsPb(Br 1−x Cl x ) 3 PQDs is also reported. Figure 5. a) Transient absorption spectra for green-emitting PQDs in toluene solution for several pump intensities (inset shows the multiexciton dynamics at high excitation energy (〈N〉 = 2.2)). b) Comparison between the transient absorption spectra of PQDs in solution and film. full paper 8763 wileyonlinelibrary.com

Previous single-particle spectroscopic studies of colloidal quantum dots have indicated a significant spread in biexciton lifetimes across an ensemble of nominally identical nanocrystals. It has been speculated that in addition to dot-to-dot variation in physical dimensions, this spread is contributed to by variations in the structure of the quantum dot interface, which controls the shape of the confinement potential. Here, we directly evaluate the effect of the composition of the core-shell interface on single- and multiexciton dynamics via side-by-side measurements of individual core-shell CdSe/CdS nanocrystals with a sharp versus smooth (graded) interface. To realize the latter type of structures we incorporate a CdSexS1-x alloy layer of controlled composition and thickness between the CdSe core and the CdS shell. We observe that while having essentially no effect on single-exciton decay, the interfacial alloy layer leads to a systematic increase in biexciton lifetimes, which correlates with the increase in the biexciton emission efficiency, as inferred from two-photon correlation measurements. These observations provide direct experimental evidence that in addition to the size of the quantum dot, its interfacial properties also significantly affect the rate of Auger recombination, which governs biexciton decay. These findings help rationalize previous observations of a significant heterogeneity in the biexciton lifetimes across similarly sized quantum dots and should facilitate the development of "Auger-recombination-free" colloidal nanostructures for a range of applications from lasers and light-emitting diodes to photodetectors and solar cells.

PbSe nanocrystal quantum dots (NQDs) are a promising active material for a range of optoelectronic devices, including solar cells, high-sensitivity infrared (IR) photodetectors, and IR-emitting diodes and lasers. However, device realization has been constrained by these NQDs' chemical instability toward oxidation, which leads to uncontrollable changes in optical and electronic properties. Here, we present a simple method to enhance the stability of PbSe NQDs against oxidation and to improve their optical properties through reaction with molecular chlorine. The chlorine molecules preferentially etch out surface Se ions and react with Pb ions to form a thin (1-2 monolayers) PbCl(x) passivation layer which effectively prevents oxidation during long-term air exposure while passivating surface trap states to increase photoluminescence efficiency and decrease photocharging. Our method is simple, widely applicable to PbSe and PbS NQDs of a range of sizes, compatible with solution-based processes for fabricating NQD-based devices, and effective both in solution and in solid NQD films; thus, it is a practical protocol for facilitating advances over the full range of optoelectronic applications.

Nanomaterials with efficient carrier multiplication (CM), that is, generation of multiple electron-hole pairs by single photons, have been the object of intense scientific interest as potential enablers of high efficiency generation-III photovoltaics. In this work, we explore nanocrystal shape control as a means for enhancing CM. Specifically, we investigate the influence of aspect ratio (ρ) of PbSe nanorods (NRs) on both CM and the inverse of this process, Auger recombination. We observe that Auger lifetimes in NRs increase with increasing particle volume and for a fixed cross-sectional size follow a linear dependence on the NR length. For a given band gap energy, the CM efficiency in NRs shows a significant dependence on aspect ratio and exhibits a maximum at ρ ∼ 6-7 for which the multiexciton yields are a factor of ca. 2 higher than those in quantum dots with a similar bandgap energy. To rationalize our experimental observations, we analyze the influence of dimensionality on both CM and non-CM energy-loss mechanisms and offer possible explanations for the seemingly divergent effects the transition from zero- to one-dimensional confinement has on the closely related processes of Auger recombination and CM.

During carrier multiplication (CM), also known as multiexciton generation (MEG), absorption of a single photon produces multiple electron-hole pairs, or excitons. This process can appreciably increase the efficiency of photoconversion, which is especially beneficial in photocatalysis and photovoltaics. This Account reviews recent progress in understanding the CM process in semiconductor nanocrystals (NCs), motivated by the challenge researchers face to quickly identify candidate nanomaterials with enhanced CM. We present a possible solution to this problem by showing that, using measured biexciton Auger lifetimes and intraband relaxation rates as surrogates for, respectively, CM time constants and non-CM energy-loss rates, we can predict relative changes in CM yields as a function of composition. Indeed, by studying PbS, PbSe, and PbTe NCs of a variety of sizes we determine that the significant difference in CM yields for these compounds comes from the dissimilarities in their non-CM relaxation channels, i.e., the processes that compete with CM. This finding is likely general, as previous observations of a material-independent, "universal" volume-scaling of Auger lifetimes suggest that the timescale of the CM process itself is only weakly affected by NC composition. We further explore the role of nanostructure shape in the CM process. We observe that a moderate elongation (aspect ratio of 6-7) of PbSe NCs can cause up to an approximately two-fold increase in the multiexciton yield compared to spherical nanoparticles. The increased Auger lifetimes and improved charge transport properties generally associated with elongated nanostructures suggest that lead chalcogenide nanorods are a promising system for testing CM concepts in practical photovoltaics. Historically, experimental considerations have been an important factor influencing CM studies. To this end, we discuss the role of NC photocharging in CM measurements. Photocharging can distort multiexciton dynamics, leading to erroneous estimations of the CM yield. Here, we show that in addition to distorting time-resolved CM signals, photocharging also creates spectral signatures that mimic CM. This re-emphasizes the importance of a careful analysis of the potential effect of charged species in both optical and photocurrent-based measurements of this process.