The present study aims to investigate crack presence in a rigid steel beam so that it can be considered in structural design. A finite element method (FEM) had been used with the Ansys 16.1 software to simulate the whole steel body with three different forces and moments with a magnitude force subjected at the free end of the beam. The steel rod had been considered as simple cantilever to be modelled by the software. Von Mises stress had been considered in the simulation process where the maximum value of stress due to applied load and moment was 1.9 MPa. Total deformation of the whole body had also been considered to instigate the maximum deformation (4.3mm) due to applied loads and moments. Furthermore, MATLAB and through fuzzy logic had been used to assist in the investigation of cracks. Both approaches had been governed by the Euler-Bernoulli theory for free vibration of motion equations. The other aim of this study is to evaluate results received from the Ansys with MATLAB for the same boundary conditions as the case.
In the this study , numerical analysis of heat transfer in the radiation system of the car has been investigated by using pure water and water with nano-fluid. ANSYS fluent version 16.1 has been conducted to carry out the simulation process using Computational Fluid Dynamic (FCD) approach. This study has been validated with experimental results and based on the simulation results the error was 8% when applying the same boundary condition. And the validation process was carried out for the flow rate with Nusselt number in both concertation 0.7 % and 1 %. Based on numerical analysis, the Nusselt number has been increased by increasing nano particle concertation. Increased number of Nusselt causes the enactment of the heat exchanger. The previous experimental data show that the heat transfer of the nanofluids was based highly on the concentration of nano particles, the flux conditions and the weak temperature-dependent heat transfer conditions.
This work aims to investigate the influence of blending diesel fuel with different percentages of methyl alcohol on reducing the emission of exhaust gases. The study was performed using a laboratory diesel engine, which is an internal combustion, single-cylinder, and four-strokes engine. The study involved investigating three volume percentages of methyl alcohol (methanol), which are 7, 14, and 21. The emission results of the blending fuels were compared with that of non-blending fuel. The analysis of the exhaust gases was done under three engine loads, which are two, four, and six N.m, with a constant speed of 2000 rpm. The analysis involves measuring carbon oxides (CO and CO2), unburned hydrocarbons (HC), nitrogen oxides (NOx), and particulate matter (PM). The results showed a positive impact of methanol on reducing the emission of all gases except NOx. Increasing the methanol ratio increases the reduction of the emissions of CO, CO2, PM, and HC, where the highest reductions of the gaseous emissions were observed with the percentage of 21% of methanol under all engine loads. Specifically, the drop recorded by using 21% of methanol was 69-83% for CO, 60-69% for CO2, 80-83% for HC, and 25-30% for PM. These reductions in emissions are assigned to the high oxygen content of methyl alcohol that influences the complete combustion of diesel. On the other hand, the NOx emission increased by 135-346%, but a possible reduction in these emissions can be achieved through a proper engine modification. The results of this investigation provide essential insights that would inspire using methanol as a fuel additive with modifying the diesel engines to be compatible with blending fuel.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.