No abstract

PET is a semicrystalline thermoplastic polyester used in many fields. For a variety of applications, however, it is necessary to impart desired properties by introducing specific functional groups on the surface. Aminolysis of PET fibers with diamines (1,2-diaminoethane, 1,6-diaminohexane, 3,6-dioxa-1,8-diaminooctane, and 4,9-dioxa-1,12-diaminododecane) gives amino functional groups on the surface. The effects of temperature, reaction time, diamine concentration, and solvent employed for the grafting were studied. The graft yield was observed to increase with temperature, reaction time, and diamine concentration. Aminolysis affects greatly the geometry and surface morphology of PET fibers as observed by scanning electronic microscopy and atomic force microscopy in tapping mode. A decrease of fibers diameter and an increase of surface heterogeneity and roughness due to chemical degradation is observed. Amino groups on the surface were used to prepare glycosylated fibers by reductive amination or amidation with different carbohydrates as maltose, maltotriose, and maltohexaose. The study reveals that the yield is dependent on the initial amino groups' surface concentration and the molar mass of the carbohydrate. These surfaces could benefit to a wide range of applications in the biomedical field.

No abstract

Water-soluble arabinoxylans from wheat flour were purified and fractionated by graded ethanol precipitation. Six fractions were obtained at 20% (F20), 30% (F30), 40% (F40), 50% (F50), 60% (F60), and 70% (F70) saturation with ethanol. Neutral sugars and (1)H NMR analyses revealed differences in structural characteristics. The Ara/Xyl ratio and the amount of Xylp residues disubstituted increased with ethanol concentration. Ferulic acid content was higher in fractions precipitated at low ethanol percentage. Fractions were refractionated by SEC, leading to 46 subfractions with low polydispersity index. Substitution degree was apparently linearly related to the amount of disubstituted Xylp. Macromolecular characteristics (M(w), [eta], R(G), q, nu) determined by multiangle laser light scattering and viscosimetry were similar among all fractions. A rather flexible conformation was determined for the arabinoxylans, in conflict with the admitted rodlike conformation. The substitution degree had no influence on the conformation or on the rigidity of the polymers. Evidence for the presence of ferulic acid dimers in the water-soluble arabinoxylans is provided, which probably explains the unexpected conformation and macromolecular characteristics.

No abstract

No abstract

No abstract

No abstract