ethics, person-organization fit, attraction, retention, corporate social responsibility, corporate social performance,

Three straight-bladed vertical axis turbine designs were simulated using ThreeDimensional (3D) transient Computational Fluid Dynamics (CFD) models, using a commercial Unsteady Reynolds Averaged Navier-Stokes (URANS). The turbine designs differed in support strut section, blade-strut joint design and strut location to evaluate their effect on power output, torque fluctuation levels and mounting forces. Simulations of power output were performed and validated against Experimental Fluid Dynamics (EFD), with results capturing the impacts of geometrical changes on turbine power output. Strut section and blade-strut joint design were determined to significantly influence total power output between the three turbine designs, with strut location having a smaller but still significant effect. Maximum torque fluctuations were found to occur around the rotation speed corresponding to maximum power output and fluctuation levels increased with overall turbine efficiency. Turbine mounting forces were also simulated and successfully validated against EFD results. Mounting forces aligned with the inflow increased with rotational rates, but plateaued due to reductions in shaft drag caused by rotation and blockage effects. Mounting forces perpendicular to the inflow were found to be 75% less than forces aligned with the inflow. High loading force fluctuations were found, with maximum values 40% greater than average forces.

No abstract

a b s t r a c tPrevious research has shown that helical vertical axis turbines exhibit lower torque fluctuation levels than straight-bladed turbines; however little is known of the impact of blade helicity on turbine performance characteristics. To investigate these relationships the hydrodynamic characteristics of straight and helical-bladed vertical axis turbines were investigated using Three-Dimensional (3D) Computational Fluid Dynamics (CFD) models using a commercial Unsteady Reynolds Averaged Navier-Stokes (URANS) solver. Simulations of power output, torque oscillations, and mounting forces were performed for turbines with overlap angles from 0 to 120 and section inclination angles from À15 to 45 . Results indicated that straight-bladed turbines with 0 blade overlap generated the highest power output. Helical turbines were found to generate decreasing power outputs as blade overlap angle increased due to the resultant blade inclination to the inflow. Blade section inclination to the inflow was also found to influence power output. Some benefits of helical-bladed turbines over their straight-bladed counterparts were established; helical turbine torque oscillation levels and mounting forces were reduced when compared to straight-bladed turbines. For both straight and helical-bladed turbines maximum mounting force levels were found to exceed the average force levels by more than 40%, with large cyclical loading forces identified.