The mixing of analytes and reagents for a biological or chemical lab-on-a-chip is an important, yet difficult, microfluidic operation. As volumes approach the sub-nanoliter regime, the mixing of liquids is hindered by laminar flow conditions. An electrowetting-based linear-array droplet mixer has previously been reported. However, fixed geometric parameters and the presence of flow reversibility have prevented even faster droplet mixing times. In this paper, we study the effects of varying droplet aspect ratios (height:diameter) on linear-array droplet mixers, and propose mixing strategies applicable for both high and low aspect ratio systems. An optimal aspect ratio for four electrode linear-array mixing was found to be 0.4, with a mixing time of 4.6 seconds. Mixing times were further reduced at this ratio to less than three seconds using a two-dimensional array mixer, which eliminates the effects of flow reversibility. For lower aspect ratio (

No abstract

No abstract

Mixing of analytes and reagents is a critical step in realizing a lab-on-a-chip. However, mixing of liquids is very difficult in continuous flow microfluidics due to laminar flow conditions. An alternative mixing strategy is presented based on the discretization of liquids into droplets and further manipulation of those droplets by electrowetting. The interfacial tensions of the droplets are controlled with the application of voltage. The droplets act as virtual mixing chambers, and mixing occurs by transporting the droplet across an electrode array. We also present an improved method for visualization of mixing where the top and side views of mixing are simultaneously observed. Microliters of liquid droplets are mixed in less than five seconds, which is an order of magnitude improvement in reported mixing times of droplets. Flow reversibility hinders the process of mixing during linear droplet motion. This mixing process is not physically confined and can be dynamically reconfigured to any location on the chip to improve the throughput of the lab-on-a-chip.

Thermal management is critical for integrated circuit (IC) design. With each new IC technology generation, feature sizes decrease, while operating speeds and package densities increase. These factors contribute to elevated die temperatures detrimental to circuit performance and reliability. Furthermore, hot spots due to spatially nonuniform heat flux in ICs can cause physical stress that further reduces reliability. While a number of chip cooling techniques have been proposed in the literature, most are still unable to address the varying thermal profiles of an IC and their capability to remove a large amount of heat is undermined by their lack of reconfigurability of flows. We present an alternative cooling technique based on a recently invented "digital microfluidic" platform. This novel digital fluid handling platform uses a phenomenon known as electrowetting, and allows for a vast array of discrete droplets of liquid, ranging from microliters to nanoliters, and potentially picoliters, to be independently moved along a substrate. While this technology was originally developed for a biological and chemical lab-on-a-chip, we show how it can be adapted to be used as a fully reconfigurable, adaptive cooling platform.