Electron-energy-loss spectroscopy has been used to identify microcrystalline diamond films produced by laser ablation of graphite. The production of the diamond phase results from varying the deposition geometry and parameters from those of an earlier configuration that produced diamondlike carbon films. A complete study of these crystalline and amorphous materials indicates a plasmon energy variation for films produced in different environments.Spectra taken with different primary energies show variation in the plasmon energy in hydrogenated carbon films. These changes were interpreted as a variation in the bonding nature of the sample with depth. The spectra of all samples were analyzed to determine sp /sp +sp fraction, dielectric functions, and optical band gap.

In this work, a high repetition rate laser matrix-assisted laser desorption/ionization (MALDI) source is studied on a quadrupole-time-of-flight (QqTOF) and a triple quadrupole (QqQ) mass spectrometer for rapid quantification of small pharmaceutical drugs. The high repetition rate laser allows an up to 100-fold higher pulse frequency as compared with regular MALDI lasers, resulting in much larger sample throughput and number of accumulated spectra. This increases the reproducibility of signal intensities considerably, with average values being around 5% relative standard deviation after taking into account the area ratio of the analyte to an internal standard. Experiments were conducted in MS/MS mode to circumvent the large chemical background due to MALDI matrix ions in the low mass range. The dynamic range of calibration curves on the QqTOF mass spectrometer extended over at least two orders of magnitude, whereas on the QqQ it extended over at least three orders of magnitude. Detection limits ranged from 60-400 pg/microL on the QqTOF and from 6-70 pg/microL on the QqQ for a series of benzodiazepines. The benzodiazepine content of commercial pill formulations was quantified, and less than 5% error was obtained between the present method and the manufacturer's certified values. Furthermore, a high sample throughput was achieved with this method, so that a single MALDI spot could be quantitatively scanned in as little as 15 s, and an entire 96-well MALDI plate in 24 min.

The usefulness of MALDI for small-molecule work has been limited by matrix chemical interference in the mass range of interest, tedious sample preparation, and various crystallization and sample deposition issues. We report instrument characterization and small-molecule quantification performance data from a high repetition rate laser MALDI ion source coupled to a triple quadrupole mass spectrometer. The high repetition rate laser improves sensitivity and precision and allows a proportional increase in sample throughput. Tandem mass spectrometry is used to discriminate the signal from the high chemical background caused by the MALDI matrix. Successful quantification requires use of an internal standard and a means of sample cleanup for typical in vitro sample compositions. This instrument combination and analysis technique is relatively insensitive to sample crystal quality and spot homogeneity. Quantitative performance results are characterized for 53 small-molecule pharmaceutical compounds and compared to those obtained by ESI-MS/MS. Further comparison between MALDI and ESI is examined, and the potential for high-throughput MALDI-MS/MS quantification is demonstrated.

A MALDI ion source on a triple quadrupole mass spectrometer constructed for the purpose of obtaining high speed quantitative measurements on drugs and other low molecular weight compounds is described. Particular attention is given to the ion generation and transport phenomena that affect analysis speed, throughput, and practical instrument robustness. In this regard parameters that affect desorption speed, beam spreading, ion flight times, sensitivity, signal-to-noise, ion fragmentation, sample carry-over, and instrument contamination are examined and experimental results are provided. MALDI and electrospray sensitivity is compared, to provide a practical frame of reference. . One interesting configuration is MALDI on a triple quadrupole (QqQ) designed for the express purpose of acquiring rapid quantitative measurements on drug entities and other low molecular weight compounds dried and arrayed on microtiter plates. The concept is analogous to plate readers used in high throughput screening albeit these optical based systems derive their speed from parallel measurements. In the case of a mass spectrometer the analysis is inherently serial in nature but could be operated at rates that would approach the throughputs of the optical systems. Assessments of the general utility of MALDI TOF for small molecule quantitative and qualitative analyses have been reported [2] and reviewed [3]. Studies of the practicality of the triple quadrupole approach for various applications have begun to appear in the literature using prototype triple quadrupole instruments [4,5], which have examined in detail the quantitative figures of merit of the technique in biological samples, emphasizing the importance of the use of internal standards. In a sister publication to this work [4], issues important to quantitation and general analytical utility such as chemical diversity, background produced by blank measurements, and s/n are covered in detail. The focus of this work are the characteristics of the instrumentation.The reasons why a triple quadrupole is a logical choice for a MALDI based high speed quantitation tool will be elaborated on in this paper but can be summarized as follows. MALDI on a triple quadruple decouples the synchronization of the desorption event with the mass analysis, similar to orthogonal MALDI TOF, but quite distinct from traditional low-pressure MALDI TOF. The mass spectrometer performance is thus independent from the sample morphology. This allows target preparation to be a noncritical issue so inhomogeneities in the sample, as would be expected in any high throughput methodology, will have no effect on the mass spectrometer mass resolution or accuracy. High-pressure operation of the source and the preanalyzer RF optics is readily accommodated in a QqQ. Collisional cooling of the ion beam is achieved at higher pressures, which reduces ion fragmentation and allows a broader range of laser energy to be utilized. With low-pressure operation on TOF instruments the laser energy must be kept low, near the ionization ...

The present work investigates various method development aspects for the quantitative analysis of pharmaceutical compounds in human plasma using matrix-assisted laser desorption/ionization and multiple reaction monitoring (MALDI-MRM). Talinolol was selected as a model analyte. Liquid-liquid extraction (LLE) and protein precipitation were evaluated regarding sensitivity and throughput for the MALDI-MRM technique and its applicability without and with chromatographic separation. Compared to classical electrospray liquid chromatography/mass spectrometry (LC/ESI-MS) method development, with MALDI-MRM the tuning of the analyte in single MS mode is more challenging due to interfering matrix background ions. An approach is proposed using background subtraction. With LLE and using a 200 microL human plasma aliquot acceptable precision and accuracy could be obtained in the range of 1 to 1000 ng/mL without any LC separation. Approximately 3 s were required for one analysis. A full calibration curve and its quality control samples (20 samples) can be analyzed within 1 min. Combining LC with the MALDI analysis allowed improving the linearity down to 50 pg/mL, while reducing the throughput potential only by two-fold. Matrix effects are still a significant issue with MALDI but can be monitored in a similar way to that used for LC/ESI-MS analysis.

The open port interface (OPI) coupled to an atmospheric pressure ion source is used to capture, dilute, focus, and transport nanoliter volume sample droplets for high-speed mass spectrometric analysis. For typical applications, the system has been optimized to achieve 1 Hz nanoliter volume sample transfer rates while simultaneously diluting the sample >1000-fold to minimize sample matrix-induced ionization suppression. Geometric, flow, and dispensing alterations to the system presented here demonstrate that sample transfer rates for the OPI of at least 15 Hz are possible. The fluid dynamic processes that enable sampling rates of 1 Hz and greater are examined in detail by correlating computational fluid dynamics simulations, analytic calculations, experimental data, photographic footage, and reference to the fluid dynamics literature. The resulting models and experimental results provide the rationale underlying the design and tuning of the system as well as information for developing optimized analytical methods. In combination with acoustic droplet dispensing, referred to as acoustic ejection mass spectrometry (AEMS), this system can be considered to be a special case of flow injection analysis with unique features that control the peak width, symmetry, and segregation of the samples transported in a fluid while simultaneously enabling their mixing and dilution with carrier fluids. In addition, conditions are established to prevent direct contact of the sample with a surface enabling, in combination with a contact-free dispenser like acoustic ejection, a dramatic reduction in sample-to-sample carry-over.

Frontal affinity chromatography (FAC) interfaced with electrospray mass spectrometry (ESI-MS) has been reported as a potential method for screening of compound mixtures against immobilized target proteins. However, the interfacing of bioaffinity columns to ESI-MS requires that the eluent that passes through the protein-loaded column have a relatively low ionic strength to produce a stable spray. Such low ionic strength solvents can cause serious problems with protein stability and may also affect binding constants and lead to high nonspecific binding to the column. Herein, we report on the interfacing of bioaffinity columns to matrix-assisted laser desorption/ionization (MALDI) MS/MS as a new platform for FAC/MS studies. Capillary columns containing a monolithic silica material with entrapped dihydrofolate reductase were used for frontal affinity chromatography of small-molecule mixtures. The output from the column was combined with a second stream containing alpha-cyano-hydoxycinnamic acid in methanol and was deposited using a nebulizer-assisted electrospray method onto a conventional MALDI plate that moved relative to the column via a computer-controlled x-y stage, creating a semipermanent record of the FAC run. The use of MALDI MS/MS allowed for buffers with significantly higher ionic strength to be used for FAC studies, which reduced nonspecific binding of ionic compounds and allowed for better retention of protein activity over multiple runs. Following deposition, MALDI analysis required only a fraction of the chromatographic run time, and the deposited track could be rerun multiple times to optimize ionization parameters and allow signal averaging to improve the signal-to-noise ratio. Furthermore, high levels of potential inhibitors could be detected via MALDI with limited ion suppression effects. Both MALDI- and ESI-based analysis showed similar retention of inhibitors present in compound mixtures when using identical ionic strength conditions. The results show that FAC/MALDI-MS should provide advantages over FAC/ESI-MS for high-throughput screening of compound mixtures.

No abstract