No abstract

1,2-Dimethoxyethane (DME) is a common electrolyte solvent for lithium metal batteries. Various DME-based electrolyte designs have improved long-term cyclability of high-voltage full cells. However, insufficient Coulombic efficiency at the Li anode and poor high-voltage stability remain a challenge for DME electrolytes. Here, we report a molecular design principle that utilizes a steric hindrance effect to tune the solvation structures of Li+ ions. We hypothesized that by substituting the methoxy groups on DME with larger-sized ethoxy groups, the resulting 1,2-diethoxyethane (DEE) should have a weaker solvation ability and consequently more anion-rich inner solvation shells, both of which enhance interfacial stability at the cathode and anode. Experimental and computational evidence indicates such steric-effect-based design leads to an appreciable improvement in electrochemical stability of lithium bis­(fluoro­sulfonyl)­imide (LiFSI)/DEE electrolytes. Under stringent full-cell conditions of 4.8 mAh cm–2 NMC811, 50 μm thin Li, and high cutoff voltage at 4.4 V, 4 M LiFSI/DEE enabled 182 cycles until 80% capacity retention while 4 M LiFSI/DME only achieved 94 cycles. This work points out a promising path toward the molecular design of non-fluorinated ether-based electrolyte solvents for practical high-voltage Li metal batteries.

Fully understanding the mechanism of lithium metal deposition is critical for the development of rechargeable lithium battery anodes. The heterogeneous electron transfer kinetics are an important aspect of lithium electrodeposition, but they have been difficult to measure and understand. Here, we use transient voltammetry with ultramicroelectrodes to explicitly investigate the electron transfer kinetics of lithium electrodeposition. The results deviate from the Butler−Volmer model of electrode kinetics; instead, a Marcus model accurately describes the electron transfer. Measuring the kinetics in a series of electrolytes shows the mechanism of lithium deposition under electron transfer control is consistent with the general framework of Marcus theory. Comparison of the transient voltammetry results to electrochemical impedance spectra provides a strategy for understanding how the interplay of the electron transfer and mass transport resistances affect the morphology of lithium.

No abstract

A major hurdle to the successful deployment of high‐energy‐density lithium metal based batteries is dendrite growth during battery cycling, which raises safety and cycle life concerns. Coating the Li metal anode with a soft polymer layer has been previously shown to be effective in suppressing dendrite growth, leading to uniform lithium deposition even at high current densities. A 3D coarse‐grained molecular model to study the mechanism of dendrite suppression is presented. It is found that the most effective coatings delay or even prevent dendrites from penetrating the polymer layer during deposition. The optimal deposition can be achieved by jointly tuning the polymer stiffness and relaxation time. Higher polymer dielectric permittivity and coating thickness are also effective, but the deposition rate and, therefore, the charging current density is reduced. These findings provide the basis for rational design of soft polymer coatings for stable lithium deposition.

We develop a theoretical model to predict the impact of nematic liquid-crystalline alignment on charge transport in conducting polymer materials. Using polymer field-theoretic modeling, we predict the chain conformations in a polymer liquid-crystalline state as wormlike chains aligning via a Maier–Saupe interaction. The resulting chain conformations are inserted into our theoretical model for charge transport in a conducting polymer material, which has been previously vetted against experimental measurements in amorphous polymer materials. The resulting predictive model provides a foundational approach to assess the potential enhancement in charge mobility arising from chain alignment in a liquid-crystalline phase. We use this model to predict the mobility enhancement with increasing nematic alignment and varying molecular weight. These predictions offer insight into the potential for performance improvement for conducting materials that are processed from a liquid-crystalline state.

No abstract

No abstract