Pseudomonas putida CA-3 is capable of converting the aromatic hydrocarbon styrene, its metabolite phenylacetic acid, and glucose into polyhydroxyalkanoate (PHA) when a limiting concentration of nitrogen (as sodium ammonium phosphate) is supplied to the growth medium. PHA accumulation occurs to a low level when the nitrogen concentration drops below 26.8 mg/liter and increases rapidly once the nitrogen is no longer detectable in the growth medium. The depletion of nitrogen and the onset of PHA accumulation coincided with a decrease in the rate of substrate utilization and biochemical activity of whole cells grown on styrene, phenylacetic acid, and glucose. However, the efficiency of carbon conversion to PHA dramatically increased once the nitrogen concentration dropped below 26.

A novel approach to the recycling of polystyrene is reported here; polystyrene is converted to a biodegradable plastic, namely polyhydroxyalkanoate (PHA). This unique combinatorial approach involves the pyrolysis of polystyrene to styrene oil, followed by the bacterial conversion of the styrene oil to PHA by Pseudomonas putida CA-3 (NCIMB 41162). The pyrolysis (520 degrees C) of polystyrene in a fluidized bed reactor (Quartz sand (0.3-0.5 mm)) resulted in the generation of an oil composed of styrene (82.8% w/w) and low levels of other aromatic compounds. This styrene oil, when supplied as the sole source of carbon and energy allowed for the growth of P. putida CA-3 and PHA accumulation in shake flask experiments. Styrene oil (1 g) was converted to 62.5 mg of PHA and 250 mg of bacterial biomass in shake flasks. A 1.6-fold improvement in the yield of PHA from styrene oil was achieved by growing P. putida CA-3 in a 7.5 liter stirred tank reactor. The medium chain length PHA accumulated was comprised of monomers 6, 8, and 10 carbons in length in a molar ratio of 0.046:0.436:1.126, respectively. A single pyrolysis run and four fermentation runs resulted in the conversion of 64 g of polystyrene to 6.4 g of PHA.

Large quantities of the potentially toxic compound styrene are produced and used annually by the petrochemical and polymer-processing industries. It is as a direct consequence of this that significant volumes of styrene are released into the environment in both the liquid and the gaseous forms. Styrene and its metabolites are known to have serious negative effects on human health and therefore, strategies to prevent its release, remove it from the environment, and understand its route of degradation were the subject of much research. There are a large number of microbial genera capable of metabolizing styrene as a sole source of carbon and energy and therefore, the possibility of applying these organisms to bioremediation strategies was extensively investigated. From the multitude of biodegradation studies, the application of styrene-degrading organisms or single enzymes for the synthesis of value-added products such as epoxides has emerged.