No abstract

RPLC is the most common mode of LC. It is widely used for separations of both small and large molecules. Monolithic columns, which are currently under intensive study by many groups, have the potential of becoming attractive alternatives to particle-packed columns. They are generally easier and faster to fabricate, and they demonstrate a lower pressure drop, less nonspecific adsorption, and richer chemistry (in the case of organic polymer monoliths) for providing broad selectivity. Silica monoliths, as is also true for columns packed with silica particles, are best applied to small-molecule separations. Organic polymer monoliths, on the other hand, have shown advantages for large-molecule separations. Recently, improvements in organic monoliths have led to efficiencies for small molecules that are approaching and even surpassing 100,000 plates/m. While this performance is still far short of what is currently available using modern small particles and silica monoliths in RPLC, steady progress is being made. This review describes recent developments in the synthesis and performance of organic polymer RPLC monoliths, and identifies areas where additional work is needed to significantly improve their performance for both small- and large-molecule separations.

No abstract

No abstract

The damping coefficient (tand) of wood flour filled polypropylene composites, having varying filler concentrations were measured using the free vibration decay of disk-shaped specimen, vibrating in flexural vibration mode. The damping coefficients decreased with the increase of filler load in composites. There was no significant difference in damping behavior of composites with and without compatiblizer at low filler level (upto 30%). At higher filler loading (>30%), composites with compatiblizer had lower damping coefficient suggesting improved interfacial adhesion between wood and polypropylene. The damping in composite is attributed to the damping because of the composite constituents and damping at the interface. The damping because of interface was estimated using a model and was found to increase with the increase in filler loading. At higher filler content, damping due to interface in composites with compatiblizer was significantly lower than in composites without compatiblizer suggesting a better interfacial adhesion between the wood filler and polypropylene matrix with compatiblizer.