Distortion of metal frameworks for the ceramic fused to metal technique during firing is attributed to thermal creep of the alloys. Usually thermal creep measurements are performed at constant load and constant temperature over varying time periods. Because metal frameworks for the ceramic-fused-to-metal technique are cyclically stressed, a three-point bending test for dynamic measurement of creep in a modified dilatometer was developed. Bending of 14 commercially available noble metal alloys was determined in the as-cast state, as well as after simulation of the firing process. The sag at 950 degrees C, which is the firing temperature of the ceramic, was chosen as an indicator for creep. No correlation of this value to other technical data of the alloys was observed, but it was found that sag correlates with the sum of the Au and Ag content of the alloys. A strong sag was observed with high (Au + Ag) content. The lowest sag values were found with a content in the range of 50 atom % (Au + Ag). At lower (Au + Ag) content Pd becomes the main component in the alloys, and the values for sag increased slightly. The method for dynamic measurement of creep gave reproducible results and offers a possible test for rapid qualitative creep assessment.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.