In JET, both high density and low-q operation are limited by disruptions. The density limit disruptions are caused initially by impurity radiation. This causes a contraction of the plasma temperature profile and leads to an MHD unstable configuration. There is evidence of magnetic island formation resulting in minor disruptions. After several minor disruptions, a major disruption with a rapid energy quench occurs. This event takes place in two stages. In the first stage there is a loss of energy from the central region. In the second stage there is a more rapid drop to a very low temperature, apparently due to a dramatic increase in impurity radiation. The final current decay takes place in the resulting cold plasma. During the growth of the MHD instability the initially rotating mode is brought to rest. This mode locking is believed to be due to an electromagnetic interaction with the vacuum vessel and external magnetic field asymmetries. The low-q disruptions are remarkable for the precision with which they occur at qψ = 2. These disruptions do not have extended precursors or minor disruptions. The instability grows and locks rapidly. The energy quench and current decay are generally similar to those of the density limit.

We discuss the processes underlying the excitation of fishbone-like internal kink instabilities driven by supra-thermal electrons generated experimentally by different means: Electron Cyclotron Resonance Heating (ECRH) and by Lower Hybrid (LH) power injection. The peculiarity and interest of exciting these electron fishbones by ECRH only or by LH only is also analyzed. Not only the mode stability is explained, but also the transition between steady state nonlinear oscillations to bursting (almost regular) pulsations, as observed in FTU, is interpreted in terms of the LH power input. These results are directly relevant to the investigation of trapped alpha particle interactions with low-frequency MHD modes in burning plasmas: in fact, alpha particles in reactor relevant conditions are characterized by small dimensionless orbits, similarly to electrons; the trapped particle bounce averaged dynamics, meanwhile, depends on energy and not mass.

In the course of the Preliminary Tritium Experiment in JET, where combined deuterium and tritium neutral beam injection generated a DT fusion power of 1.7 MW, ion cyclotron emission (ICE) was measured in the frequency range Y I 180 MHz. The ICE spectra contain superthermal, narrow, equally spaced emission lines, which correspond to successive cyclotron harmonics of deuterons or alpha particles at the outer midplane, close to the last closed flux surface at major radius R -4.0 m. Above about 100 MHz the lines merge into a relatively intense continuum. The ICE signal fluctuates rapidly in time, and is extinguished whenever a large amplitude edge localized mode (ELM) occurs.In pure deuterium and mixed DT discharges ICE spectra are similar in form, but on changing from pure D to mixed D + T neutral beam injection at constant power, the intensity of the ICE rises in proportion to the increased neutron flux: this indicates that fusion alpha particlesand not beam ionsprovide the free energy to generate ICE. The JET ICE database, which now extends over a range of six decades in signal intensity, shows that the time averaged ICE power increases almost linearly with total neutron flux. The rise and fall of the neutron flux during a single discharge is closely followed by that of the ICE signal, which is delayed by a time of the order of the fusion product slowing down time. This feature is well modelled by a TRANSP code simulation of the density of deeply trapped fusion products reaching the plasma edge. Calculations reveal a class of fusion products, born in the core, which make orbital excursions of sufficient size to reach the outer midplane edge. There, the velocity distribution has a ring structure, which is found to be linearly unstable to relaxation to obliquely propagating waves on the fast Alfv6n-ion Bernstein branch at all ion cyclotron harmonics. The paper shows how ICE provides a unique diagnostic for fusion alpha particles.

High fusion power experiments using DT mixtures in ELM-free H mode and optimized shear regimes in JET are reported. A fusion power of 16.1 MW has been produced in an ELM-free H mode at 4.2 MA/3.6 T. The transient value of the fusion amplification factor was 0.95±0.17, consistent with the high value of nDT(0)τEdiaTi(0) = 8.7 × 1020±20% m-3 s keV, and was maintained for about half an energy confinement time until excessive edge pressure gradients resulted in discharge termination by MHD instabilities. The ratio of DD to DT fusion powers (from separate but otherwise similar discharges) showed the expected factor of 210, validating DD projections of DT performance for similar pressure profiles and good plasma mixture control, which was achieved by loading the vessel walls with the appropriate DT mix. Magnetic fluctuation spectra showed no evidence of Alfvénic instabilities driven by alpha particles, in agreement with theoretical model calculations. Alpha particle heating has been unambiguously observed, its effect being separated successfully from possible isotope effects on energy confinement by varying the tritium concentration in otherwise similar discharges. The scan showed that there was no, or at most a very weak, isotope effect on the energy confinement time. The highest electron temperature was clearly correlated with the maximum alpha particle heating power and the optimum DT mixture; the maximum increase was 1.3±0.23 keV with 1.3 MW of alpha particle heating power, consistent with classical expectations for alpha particle confinement and heating. In the optimized shear regime, clear internal transport barriers were established for the first time in DT, with a power similar to that required in DD. The ion thermal conductivity in the plasma core approached neoclassical levels. Real time power control maintained the plasma core close to limits set by pressure gradient driven MHD instabilities, allowing 8.2 MW of DT fusion power with nDT(0)τEdiaTi(0) ≈ 1021 m-3 s keV, even though full optimization was not possible within the imposed neutron budget. In addition, quasi-steady-state discharges with simultaneous internal and edge transport barriers have been produced with high confinement and a fusion power of up to 7 MW; these double barrier discharges show a great potential for steady state operation. © 1999, Euratom

Analysis of MHD activity in pellet enhanced performance (PEP) pulses is used to determine the position of rational surfaces associated with the safety factor q. This gives evidence for negative shear in the central region of the plasma. The plasma equilibrium calculated from the measured q values yields a Shafranov shift in reasonable agreement with the experimental value of about 0.2 m. The corresponding current profile has two large off-axis maxima in agreement with the bootstrap current calculated from the electron temperature and density measurements. A transport simulation shows that the bootstrap current is driven by the steep density gradient, which results from improved confinement in the plasma core where the shear is negative. During the PEP phase (m,n)=(1,1) fast MHD events are correlated with collapses in the neutron rate. The dominant mode preceding these events usually is n=3, whereas the mode following them is dominantly n=2. Toroidal linear MHD stability calculations assuming a non-monotonic q-profile with an off-axis minimum decreasing from above 1 to below 1 describe this sequence of modes (n=3,1,2), but always give a larger growth rate for the n=1 mode than for the n=2 mode. This large growth rate is due to the high central poloidal beta of 1.5 observed in the PEP pulses. Finally, a rotating (m,n)=(1,1) mode is observed as a hot spot with a ballooning character on the low field side. The hot spot has some of the properties of a 'hot' island consistent with the presence of a region of negative shear

Measurements of soft X-ray emission from the JET plasma have been analysed with tomographic reconstruction methods. Because there are two detector arrays, two-dimensional images of X-ray emissivity are obtained without having to resort to rotation models. Several algorithms are employed in order to get as much detail as possible in the images while keeping any guiding assumptions to a minimum. The data analysed so far have been used principally to study MHD instabilities, and illustrative examples of the sawtooth crash and of disruptions are described.

MHD spectroscopy in FTU has revealed high frequency (HF) oscillations between 30 and 70 kHz that accompany the development of large m 0 = −2, n 0 = −1 islands in ohmic plasmas. This frequency range is one order of magnitude above the island rotation frequency, one order of magnitude below the first toroidal gap in the Alfvén continuum and of the same order of the low frequency gap introduced by finite beta effects. The HF spectrum is organized in pairs of modes with opposite toroidal numbers, n = 1 and n = −1 for the stronger ones, which form standing waves in the island rest frame. The poloidal structure of HF modes is |m| = 2 for the main lines. HF lines appear when the level of poloidal field perturbation produced by the island at the plasma edge exceeds 0.2%. The absence of energetic ions in FTU ohmic plasmas, the strict correlation between HF and tearing modes and the existence of a threshold indicate that HF modes tap their energy from the tearing mode by a non-linear coupling mechanism.

Washboard (WB) modes (Smeulders P et al 1999 Plasma Phys. Control. Fusion 41 1303) are a very common edge instability regularly observed in the H-mode regime in JET. They are detected as (normally several) bands of continuously fluctuating magnetic activity rotating in the direction of the electron diamagnetic drift with typical frequencies in the range of 10-90 kHz. The time evolution of the WB mode frequency is found to follow qualitatively the evolution of the electron temperature measured near the pedestal top, probably due to the strong diamagnetic drift associated with the large pedestal gradients. Evidence for their involvement in the pedestal and ELM dynamics will be presented. Increasing WB mode amplitude is correlated with an increase in the time between consecutive type-I ELMs. In situations in which a sudden increase (decrease) of WB mode activity is observed, the build-up of the pedestal temperature (and, linked to this, also of the pedestal pressure) of the electrons is seen to become slower (faster). This is a strong indication that the WB mode activity has a regulating effect on the pedestal and that it is responsible for an enhanced transport of energy across the separatrix. The occurrence of a class of type-I ELM precursor modes commonly observed in JET in discharges with low to moderate collisionality (ν * e < 2, roughly) (Perez C P et al EFDA-JET Preprint EFD-P(02)11) is found to be associated with a weakening of the WB modes. The underlying mechanism for this interaction has not