Low-loss optical planar waveguides in YVO 4 produced by silicon ion implantation at low doses J. Appl. Phys. 94, 4708 (2003); 10.1063/1.1604965Monomode, nonleaky planar waveguides in a Nd 3+ -doped silicate glass produced by silicon ion implantation at low doses
The depth refractive index profiles of broadband visible-emitting planar waveguides produced in LiF crystals with 1.5- and 2-MeV He+ ions at different doses have been derived from mode analysis. They show that there are two competitive mechanisms responsible for positive and negative modifications of the refractive index in the irradiated volume associated with different processes of energy deposition of the incident ions, so as to induce a complex coloration profile along the penetration direction, which is strongly dependent on the irradiation dose.
Fabrication and laser operation of proton-implanted Ti:sapphire buried channel waveguides is reported for the first time to our knowledge. Without any postimplantation annealing of the structures, continuous laser operation near 780 nm was demonstrated at room temperature at an absorbed pump power threshold of 230 mW. Single-transverse-mode laser emission was observed with measured beam propagation factors M x 2 and M y 2 of 1.5 and 1.2, respectively. An output power of 12.4 mW for 1 W pump power was obtained with an output coupler of 4.6% transmission at the signal wavelength. Higher output powers were measured in waveguides with larger cross sections exhibiting multimode laser emission. © 2006 Optical Society of America OCIS codes: 130.3120, 230.7380, 140.3590, 140.3570, 230.7370, 350.3850. Proton implantation has recently attracted interest for fabrication of waveguide lasers, because protons, compared to higher-mass ions, allow for larger penetration depths and, therefore, can lead to deeper damage profiles. They also create less damage in the guiding region, which extends the prospects of developing waveguide devices. 1,2 This method has recently been proved capable of producing low-loss ͑ϳ0.7 dB/ cm͒ buried channel waveguides in undoped sapphire crystals without any postimplantation annealing.2 Ti:sapphire is a widely used laser system with broad tunability ͑650-1100 nm͒, which makes it suitable for the development of short pulse and broadly tunable lasers, 3 with potential applications in areas as diverse as biomedical imaging, spectroscopy, sensing, and microscopy. Due to its low peak emission cross section and the short fluorescence lifetime, Ti:sapphire lasers require high pump-power densities to achieve efficient cw lasing. Development of miniature Ti:sapphire channel waveguide lasers would offer the possibility to achieve low laser thresholds as a result of the confinement of the laser and pump modes. Such lasers have been realized in planar waveguide geometry via pulsed laser deposition (PLD), 4 and in channel waveguide geometry via thermal diffusion of Ti 2 O 3 into sapphire, 5 and a combination of PLD and photolithography-Ar + -beam milling, 6 respectively. However, the indiffused channel waveguides showed low slope efficiencies, typically of the order of ϳ0.1%, 5 while those produced by the latter method exhibited relatively high propagation losses ͑ϳ1.8 dB/ cm͒. These losses can be an unavoidable consequence of the PLD process itself and may, therefore, limit the prospects for future device developments.Here, we report, for the first time to our knowledge, the laser operation of Ti:sapphire buried channel waveguides fabricated by proton implantation. To date, lasing action in proton-implanted crystalline waveguides has been demonstrated in garnet-based (Nd:YAG) planar structures with guidance in one direction only. 1,7 Implantations were performed with high-energy protons ͑0.5-1 MeV͒ resulting in negative refractive index changes of the order of −0.5 to −1% for a 1 MeV proton beam and doses...
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.